The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
NOTE: I have done the same test setup with 4000 series routers, and routing works fine.I have successfully setup 3 SVI (Static Virtual Interface) tunnels with IPSEC between 2 9300X switches.- I can ping the tunnel IPs- I can ping each VLAN interface ...
Hi I am looking to write a program using JTAPI to monitor all call events of all registered devices ( Phones alone - all types).. Can anyone help me with the classes i need to use and high level steps for the same.Your reply is appreciated.
We are trying to block few public ips in zone-based firewall. What typically in zone-based firewall, we can control based on protocol. Can we add an access list to be filtered in zone-based firewall policy map?
I configured a Cisco Catalyst 2960 Switch. I set vlan1 as the ip address of the switch as well as interface 1 with 192.168.1.1 with a class C subnet. Strangely I am not able to access the GUI, ping the switch or Telnet directly. However, I am able to...
Hallo All! What is the reason that when enabling Telemetry on C9300 Series Switches, only Application Name, Usage and Througput are shown? Switches configured with telemetry show only Application Visibility (Name and Throughput) in DNA center. Why is...
Hello All, Question in Nexus 9.x We have an EoL notice for version 9.3x. There's no replacement available at this time. Can we assume that a version 9.4 version will be released? I don't see any EoL for 9.x at this time. The customer doesn't...
i cannot log in to the SNTC portal, i have the necessary roles that were applied last week (beyond the 24 hour period that is required for SNTC portal access), but each time i try to log in at services.cisco.com, I'm redirected back to the registrati...
Hello guys,i wonder if i can use the stack port with a fiber to simple uplink from the SG500-52 to another HP Switch with SFP ports too, and if i can, how a manage to do this?Thx
I have a DMVPN network with 4331 hub routers. Our HQ in Memphis has a hub on AT&T, and another on Lumen. Our New York hub is also a Lumen connection. All are 500Mb up/down. We have about 35 spokes around the US that peer to all 3 routers. BGP is the ...
Hi,Maapi.commitQueueResult is deprecated and we should use applyTransParams.I need help on how to use applyTransParams.I have the following code:CommitParams cp = new CommitParams();cp.setCommitQueueSync();cp.setNoOverwrite();CommitQueueResult result...
hello all ,recently i tried to configure VPN site to site with certificate authentication type, i got the certificate signed by a third party autority , and when i did the debugs i got this log :CRYPTO_PKI: bitValue of KEY_USAGE = a0PKI[7]: CRYPTO_PK...
Hello,I have a switch I am unable get a prompt on the console port.I can SSH to it, and have confirmed that the baud rate and stop bits are correct from the console switch. There are two other switches that I can console to.The differences are that t...
Hi all I'm setting up a CISCO LAB to keep me busy in my retirement. My Current network consists of a TP-Link Deco mesh network which works well for my IOT, PCs and internet access. I just got hold of a Cisco 1941 router with a EHWIC D8SGP module. ...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: