The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hello team. Currently I want to deploy ipv6 for some nexus 3500 devices and I have found that ipv6 is not supported for nexus 3500's (CSCwf36829 - IPv6 not supported on Nexus 3500's), however in the Bug Search Tool it only indicates it for version 9....
Dear all,I am running in to very strange problem - currently busy with preparation in our LAB for a migration of EVPN/VXLAN setup from single-site to multi-site. During the testing in our LAB I have discovered the following.The LAB is already in mult...
I have a Cisco 3700 Series AP and trying to connect it to a WLC 5508. I have getting a certificate validation failed error, however when I use the command "show crypto pki certificates" no such expired certificate shows up. Previously had an issue wi...
I am trying to figure out how to add an ap into a an existing EWC network currently have one ap c9130ax and I am trying to add another c9130ax both same country code, the new Ap has been reset and I believe it is in Capwap mode, currently I am unbale...
Noticed that the license is evaluation instead of perpetual? If we bought new AP, do we still need to buy licenses?Cisco wireless controller 8540Software version 8.2.151.0
1. It's possible to launch into multimode using LRM optics as we have in our Cisco 6500's ?2. what is needed , possibly special launch cable , also what is needed on the HPE J9851A Switch 5412Rzl2 if going to a normal sfp+?
Dear Gents, What are the recommendations that should be followed if we have a local site with wireless APs operating in Local Mode and registering on a local Primary WLC on the same network. and in the case of Primary WLC failure, the APs w...
Hi,I have a core switch(4506e) connected to 6 edge switches(2960)..Each switch is configured with crypto pki trustpoint TP-self-signed WHat is this exactly and whats its use? Also, when i connect other 2960 with core, it automatically takes this cryp...
how do i remove a switch from the stack and return it to standalone config ? current configswitch 2 provision c9300-48uxm i tried Switch(config)#no switch 2 provision ?<cr> <cr>Switch(config)#no switch 2 provisionError: A switch is already physically...
Hi community,Few months ago I bought 3 POE AP CBW150AX for my house. And I have issues with two of them.I plugged two on my SG300 and everything seem goes well at this time.But one day, the switch port where one of the AP was plugged shut off. No mor...
Hi, Tech geeks. I have C9124AXE-E wireless AP and i have upgraded it to EWC by installing 17.9.5 version. now i have connected 4 external antennas with this AP / EWC. what i am facing is unable to get my 5ghz ssid operational, its operational status ...
Hi everyone, I want to upload the startup-config to real router via tftpd64 in vmware windows server. Windows server and ESR6300 are under the same network. But ESR6300 can ping windows server only from mgmt vrf. Through global router ESR6300 can'...