The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hi All, Can we use Azure AD as a Primary authentication for Duo Single Sign-On for Cisco ASA and FTD with AnyConnect. Also let me know where we can Entra ID as the authentication source for SSO
My network endpoints use the IP addressed vlans on my core cisco layer three core switch as their gateway addresses. i.e.- vlan 11 endpoint address 192.168.11.3/24 with gateway 192.168.11.1/24 (vlan ip on core) and vlan 12 endpoint address 192.168.12...
Question for anyone who used NSO with CARE to automate STIGs.So we had call yesterday with a few guys from Cisco to discuss us potentially ordering Cisco NSO. The main reason for purchasing is to use their CARE product which will allow us to automate...
Hi, I had a staff member call today. he said his phone had the Voice Mail message light, but no message. But he did have an email message from Unity with the voice message attached(We are using Unified Messaging Accounts for this user. If the user pl...
Hi FreindsI Heard that u can Integrate ACI Simulator with vmware VCA using Mgmt Tenanant using the the Mgmt IPs for both ! so that you can push PG to VC and Play Around , any walk around Thanks
Hello.On the Software Update page of Prime there is one Pack which i can not install or delete because it is already included in another installation i did before. Now this pack stays on the page and i am not able to remove it. Does anybody know wher...
Deployed a 3100 in chassis mode to the FMC a few days ago. All went to plan.Determined we needed to change the IP so decided just to delete the device from FMC and re-provision it.On the FTD via local-mgmt did a erase configuration. The device wiped ...
Hi Everyone,Cisco ISE 3.2 keeps crashing several days after the installation.The installation has been done successfully without any problems.After a couple of days the installation is malfunctioning.After several installations and change of the sel...
We are having an issue were after disconnecting from AnyConnect and connecting the next day, they get a new IP in AnyConnect but in our local DNS they have another IP which I assume is probably from the day before. This obviously causing name resolut...
Hi all.I am attempting to add an access group to a switch port which is located in a C1111 ISR router but the command is no longer there when using version c1100-universalk9.17.06.03a.SPA.binMy-Router(config-if)#ip a?admission arp auth-proxy*******...
Ask Me Anything Forum - Drive to 15X Welcome to the Cisco Support Community Ask Me Anything discussion! Are you considering upgrading or migrating your UC applications to version 15.x, such as CUCM, CUC, IM&P? If you're looking to learn more about...
Hi all,I installed application policy so I could configure QOS within DNAC. All was complete and the app policy section was showing but after leaving for an hour and coming back to it I can no longer see it as an option and cannot amend my config..Wh...
I've migrated one pair of 9800-80 from 17.9.4a to 17.12.3. I noticed that the APs w/ RRM on the new 17.12.3 on 6GHz have drop drastically up to 8 dBm (see attched picture). Is anyone aware of this change and why on 17.12.3?