The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hello everyone,it's basically just the question in the title. There should have been an update in February, but now, one month later, there still is no update on the horizon. The only information Linux users got was "Webex App for Linux will release ...
Is there a way to verify VPN use and uptime? I believe that the below command will only show output for the duration of the security association, which could be for an unknown time period. Do you know a way to verify when counters were last cleared...
HelloWe have a lot of clients getting the following error when contacting diffrent sites: ERR_SSL_PROTOCOL_ERROR, we have read that SonicWall and Palo Alto also have these problemes. Solution is to turn off "TLS 1.3 Hybridized Kyber Support" in chro...
On CUCM 14 is mentioned that Wi-fi to LTE is automatically enabled when CUCM 14 version is in place (together with a supported expressway version) when webex app is used. There are a few limitations (like recording) there but nothing mentioned about ...
User has excessive device registrations i am getting this error when lunch meeting from my portal here is complete error index.js:64 wx-js-sdk Meetings:index#register --> ERROR, Unable to register, User has excessive device registrations POST http...
Hi All, Thousand Eyes is an intelligence tool and has exceptional scope for Monitoring Application Performance. I have worked on End User Monitoring, Enterprise agent, Application performance, Endpoint agents features. It was quick in implementing an...
I have an 8000-series router running IOS XR. I need SNMPv2 to work, but by default that enables SNMPv3. I need to explicitely disable SNMPv3 without disabling SNMPv2.ACLs don't seem to work on the SNMPv2 configuration line. ACL'ing the physical in...
Our company is implementing 802.1x on our network. When a device auth fails it is moved to our guest vlan. I need to prevent any communication from one device to another within the vlan and only allow outbound communication. I am sure there are many ...
We recently moved to a SIP trunk and inbound/outbound calls worked just fine, but DTMF is not functioning for SCCP phones. When a call is made and we get an auto-attendant (using a SCCP phone), when selecting an option, the selected option is not reg...
Hi Together, i'm having problems with configuring BLF on 8851 3PCC with Asterik System. BLF are blinking and when pressed i've getting failure "Invalid Number". Software Version: sip88xx.11-0-1MPP-477.loads Voice with no problems, Calls possible ...
Hi, community,I have some doubts about the feature Root Guard. My scenario is four VLANs on two distribution switches and some access switches connected to the upper layer. Switch A is the root bridge for VLANs 1 and 2, while Switch B is the root bri...
Hi, i have problem of synced betewin my 2 switchs nexus 7.0.3.i7.3I use feature BGP, LACP and VRRP (also VPC etc..)But it's impossible of configure correctly the protocolI have many errors :One : In log :%ETHPORT-3-IF_ERROR_VLANS_SUSPENDED: VLANs 9-1...