The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hi, I'm trying to prefer R2 route for the multicast traffic (without using static mroute) from R1 (receiver) to R4 (source):Receiver (R1): 10.10.10.10Source~(R4): 10.0.45.5I'm completely new to multicast and still trying to understand how it works b...
hiI wanted to ask if there are analogues of the test lab. Tell me where you can test the update, and are there any instructions or videos that you can watch ( update cucm 12.5 to 14)Thank you in advance
Hi Team, am using 2x9300 catalyst switches and i have configure two interface from server with two different VLAN 148, 14 and between two switches I have port Chanel with trunk . am getting this error on both switches , thanks in advance for your as...
Hi everyone,We have 2 N9K C93180LC-EX with 5 N2K-C2348 FEX attached (dual home).We experienced some issues during the upgrade as we are getting some ports in "inactive" status. We tried to understand where the problems is but we can't figure it out. ...
Hi All! I have one problem related to running GuestShell on Nexus 9000 I managed to successfully run guestshell and install iperf3. But when i start measuring channel bandwidth, it shows tiny values, the hundreds of kilobytes, while the real channel ...
Preparing to upgrade CUCM 12.5 to 14 and ran the ciscocm.preUpgradeCheck-00033.cop. Everything pass but database sanity check on the publisher. I get the following message." administrator " present in "applicationuser" table. it is recommended to f...
HELLO GUYS,I want to implement webbridge3 on cms3.8.1 but gave me this error:cms> pki listUser supplied certificates and keys:webadmin.keywebadmin.crtwebbridge.keywebbridge.csrcertnew.cerCARoot.cer cms> pki match webbridge.key certnew.cerMatching cer...
Our gateway mac address is different when we give arp -a in cmd the mac address is another show when we trace it shows a student mac what could be the problem?
Introduction: Introduction:This document describes an issue faced by an user where Dot1x clients doesn't get connected to network by using DHCP address configured on 3560. What is Dot1x?Dot1x or technically known as 802.1X is a standard which was des...
Hi All, Need to configure an Cluster between Hardware device and Virtual appliance and later will remove the Hardware appliance. Before jumping into configuration i have a some query. 1. Is it sma required after forming an cluster to manage the devic...
Leeway Softech is a website composition and improvement organization with a talented team of specialists with prevalent space information across various improvement stages. Our overall clients range from new companies to huge undertakings. We are cen...
I have trouble connecting Cisco IP Phone CP 8811 to a network. There is no display on the phone and only the mute light blinks red. Any help is greatly appreciated.
I learning how to set-up firewall and came accross such a problem when trying to connect through web-browser to DMZSERV : 3. The packet is coming from an outside network. The device looks up its NAT table for necessary translations. 4. The packet is ...
Hi Everyone, i need some suggest regarding the issue at webex. When i click setting for microphone and camera, there is warning sign that indicate my microphone and camera cannot connect. But if I check the application camera and microphone in my lap...