The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
I'm involved in the following setup illustrated below. I am Site 4. I have a SIP trunk via the CUBE to Site 3. Calls route between Site 4 and Site 1 with no problem. Is it possible to use Site 1 CUCM, to route calls from Site 4 to Sites 3 or 2? Is it...
Greetings,I'm checking the "show bgp x.x.x.x" output in 3 different XR routers A, B & C in an ISP environment.Here's an example as the best path part of the output:Path #1: Received by speaker 0 Advertised IPv4 Unicast paths to peers (in unique updat...
Hello,we use a Webex Board Pro and the PTZ4K as second camera for PresenterTrack. It all works fine but the image of the PTZ4K cannot be mirrored. Nothing is readable over the PTZ4K. Has anyone the same problem?Thanks
Hello,we are stilll using a isr2900 router as a SBC.Currently it uses the securityk9 license and a uck9-cme-srst-cube license as smart licensing.The logging output tells me that the evalution period already expired.I know the product is EOL/EOS but s...
HiWe've had a request from the business if its possible to turn off the sound effect when volume goes up or down via the touch 10 controller on Cisco codecs. I have tried turning off all the sound effect or key tone options within the settings, but t...
Hi Community, Iam creating Smart license in IOSXR with http So I used "destination transport-method http" and also put the destination url. When I do show run, i see "destination transport-method email disable" also in the configuration ----- call-ho...
Can any one help me to fix the camera Quad TTC8-10, getting blurry image. - Tried Reboot Camera, Tried Reboot WebEx Device, Tried Reset Camera but unable to get the original view its all blurry image
Hello guys,I installed Cisco room kit EQ, but it's shows Amplifier detection error how to solve this issue,Attached error message and Connection diagram
My org has a single CUCM cluster with around 10k phones registered across 100+ buildings. We've been semi-regularly experiencing an issue that we've had trouble tracking down. Due to the nature of our deployment and the intermittent/difficult to repr...
hello. I understand that Connected routing has an AD value of 0. The IP bands on the 1st and 2nd floors are different. 1st floor: 1.1.1.0/242nd floor: 2.2.2.0/24 There are two firewalls on top of the backbone. The band will be 3.3.3.0/24. If you conf...
Hi,I have tried to retrieve serial number info for 3 units of the Cisco WAP4410N Access Point devices via Web GUI and CLI, but it seems can't find the serial number info for this model. Kindly advise further, thanks.Regards,Wilson Leong
hello all,I recently acquired an old precision 60 camera that was in a container with other broken items. I'm not sure what if anything if wrong with it, but I am trying to see if it works. I do not have the sx80 codec or any other hub for connecti...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: