Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1919125members
1223209discussions

Community Activity

BGP between two remote FTD

I have two Firepowers in two remote offices and i have two ISPs in each office, i had configured vti ipsec vpn between two offices but they are working with static routes, can i configure dynamic routing protocols for failover vpn? I tried to configu...

Local account on Nexus 3048 doesn't work

Am trying to create a new local account on a Nexus 3048 so I can SSH to it if my Radius server doesn't work.  Normally, I log in with my AD account which the switch uses Radius for authentication with that.  However, when I run the command to create ...

mramj499 by Level 1
  • 37 Views
  • 1 replies
  • 0 Helpful votes

SMTP route to Email Public address

Hello community,  i have a question, but can`t find answer on it.  If we have one listener for inbound and outbound communication and this private IP has NAT to public IP. We don`t have communication to mail server on private IP.  Is it a problem if ...

AIR-AP2802I-E-K9 fail to join

Hello ,We are having problem with one AP to join the WLC , all others successfully the controlle. the console output is :[*03/19/2024 09:08:50.0003] CAPWAP State: DTLS Setup[*03/19/2024 09:08:50.0035] dtls_process_packet: DTLS Error: 1040[*03/19/2024...

zillams by Level 1
  • 161 Views
  • 5 replies
  • 0 Helpful votes

Cisco Catalyst 9300 QoS phone call choppy

Hello all, The Phone calls work perfectly before applying the QoS but get choppy after applying. I am currently applying QoS on Cisco 9300 access switches but the phone calls are cutting in and out (Choppy). I am using Cisco phones. Below are the con...

kevirami by Level 1
  • 223 Views
  • 7 replies
  • 0 Helpful votes

Ruckus 7150 to Cisco 3750 trunk port not working

I am trying to configure a trunk port on a Cisco 3750 that has fiber running to a ruckus 7150 switch.My current config connects the switches but it is only passing vlan1 traffic and I want multiple vlans. Therefore, I configured the port as a trunk o...

oowJ by Level 1
  • 114 Views
  • 3 replies
  • 0 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: