The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
hi all,we have a topology without any redundant link. Every access switch is directly connected with the core switch, and it's a port-channel between access switch and the core. RSTP runs on switches by default, and we do not explicitly configure the...
On my Windows 10 computer, I can connect to the VPN using AnyConnect 3.1.02026 without difficulty. However, once I disconnect, I need to reboot my computer to connect again. When I try to connect the second (and subsequent) times I get the message, "...
Does anyone have a Cisco 9800-L WLC Controller and successful installed a CA Signed Cert for Web Server? Not making the Certificate signing request, but actually already have the PEM and other files locally.Cisco TAC can't figure it out. The document...
Hello,I have a question about migrating a IPSec tunnel from between a Cisco C981F-k9 and a Cisco ASA firewall to a tunnel from the same Cisco C981F-k9 router to a Fortigate firewall. What is the 'best' way to migrate this tunnel?Currently I have conf...
Dear community I am getting into NetFlow a little bit deeper but cannot get my head around sampling. All i understand so far: We can configure deterministic sampling, that uses a hardware sampler per interface, limiting the maximum number of monitori...
Hi,Per the title, I've got an issue with 5Ghz clients that have good signal strength because they are sat almost underneath the AP (1832 APs) yet but struggling to get more than 1Mbps throughput. I can see the channel utilisation is over 50% but zer...
The Cisco Document Team has posted an article. This document describes how to allow specific YouTube channels/videos and block the rest of YouTube in Web Security Appliance (WSA). Know of something that needs documenting? Share...
I have a C1111-4P router with c1100-universalk9.17.06.01a.SPA.bin image loaded, I want to update to c1100 universalk9.17.13.01a.SPA.So can I update directly to a new image or need to update any intermediate?
I am trying to configure a trunk port on a Cisco 3750 that has fiber running to a ruckus 7150 switch.My current config connects the switches but it is only passing vlan1 traffic and I want multiple vlans. Therefore, I configured the port as a trunk o...
Hi. After AnyConnect upgrade from 4.10MR2 to 4.10MR7 (pre-deploy) it downloads ISE compliance module 4.3.2403.6145 from ISE upon every connect and tries to install it, although 4.3.2403.6145 module already installed.I know there is a workaround to co...
Greeting everyone! There is a little problem with configuring tacacs server on ws-2950-24 model switch. The rest switches we have are 2960 series, also 3xxx series and others, more modern versions. We always configured tacacs server this way:tacacs-s...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: