Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
1929622members
1244374discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

VPN Tunnel connecting at a unconfigured setting - Phase 1 Timer

OK, so I've got a set of ASA's and we are migrating them to Firepowers, and all seems ok. In the past we have noticed that for some reason on the ASA's, no matter what you specify as the parameters for phase 1, the rekey timer always connects at 3600...

Screenshot 2024-04-25 142720.png Screenshot 2024-04-25 142752.png StephenCarter_0-1714052852588.png

Intermittent Static noise on phones

We are a healthcare facility.  For past several months we have had several complaints from users that calls are often full of static.   We are running CUCM 12.5(1)SU8 and the phones are primarily 8811 running current firmware.   We have replaced phon...

NTP and Syslog packets with specific IP Address

Hi All,I have a couple of C9300 L3 switches that are connecting to an ASA firewall. The NTP and the syslog server for the switches are located behind a firewall.When one of the switches request/send packets the gateway IP is the source address on the...

Ranjita by • Level 1
  • 119 Views
  • 9 replies
  • 0 Helpful votes

How to fix cast iron without welding?

Fixing cast iron without welding can be effectively accomplished through the use of a metal epoxy. This method involves cleaning the broken pieces thoroughly to remove any dirt, grease or rust. Once clean, apply a high-quality metal epoxy over the br...

cannot get to privileged enable mode via console

After searching through other posts, my config seems OK but still strange behaviourasa 9.20 running on FPWR chasisI cannot get in enabled mode when connecting to ASA via console.It used to work but stopped after I played (disable and restore) with aa...

kewwa by • Level 1
  • 145 Views
  • 6 replies
  • 0 Helpful votes

Cisco 2960S not pinging, but has DHCP address

Hi,I am trying to set up an SSH connection to my switch, but right now there is some lower level problem. I have set up my FastEthernet0 interface to ip address dhcp and the command show interfaces FastEthernet0 shows the correct address. Even if I t...

limex by • Level 1
  • 5 Views
  • 1 replies
  • 0 Helpful votes

FTD re-register to FMC chassis mode

Deployed a 3100 in chassis mode to the FMC a few days ago. All went to plan.Determined we needed to change the IP so decided just to delete the device from FMC and re-provision it.On the FTD via local-mgmt did a erase configuration. The device wiped ...

glsparks by • Level 1
  • 7 Views
  • 0 replies
  • 0 Helpful votes

Resolved! C9120AXI-E EWC license

Hi,if I want to use 2 x C9120AXI-E with Embedded Wireless Controller for redundancy what license do I need? regards

unitron79 by • Level 1
  • 5179 Views
  • 3 replies
  • 0 Helpful votes
Load more