The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
HejI have performed a local install, but I can not login to the GUI using admin/admin.I can login to CLI with "ncs_cli -C -u admin" , but when I do "show run", all I see is snmp configuration on the device. I can not see AAA or configure it.cisco@Ubu...
Planning a trip can sometimes come with unexpected changes or unforeseen circumstances 1-888-816-4638 헢헿 헧헼헹헹 헳헿헲헲 헻혂헺헯헲헿 1-888-816-4638. 핰햝햕햊행햎햆 understands this, which is why they offer a flexible cancellation policy to accommodate travelers' needs...
The standard admin password for "IOS XE on Cat8kv AlwaysOn" (devnetsandboxiosxe.cisco.com) is not working. Can this environment please be reset to defaults?
Afternoon All,I am currently working on a Site-2-Site VPN at home I have connected a cable between both Outside Interfaces. It's been a while since I have done this on an ASA5505. I have this little voice telling me there is an issue with the differe...
Hello friends,I get an insufficient disk space warning during the readiness check step before FTD upgrade. Even though I deleted the old version files I uploaded, there was no space on the disk. Has anyone encountered this problem before? From which ...
Hi all I have a small script that collects information from a list of devices, but it takes a long time. I have found out that there is a disconnection time of 10s I think I am hitting. I have found the documentation that says I can change the settin...
Hello all,Maybe this question was published before but i was unable to find an answer that solvedy issue.I acquired an UCS C240 M4 recently with firmware version 2.0.I upgraded to version 4.2 without problem.Since I had no access to the CIMP web int...
I want to use netconf to get status from C9800. module: Cisco-IOS-XE-wireless-access-point-oper +--ro access-point-oper-data +--ro ap-radio-audit-info* [wtp-mac radio-slot-id]
Following upgrading to upgrading to 5.1.2.42 to fix the vulnerability CVE-2024-20337Within Microsoft Defender this is still flagged as vulnerability for the CVEIt appears to refer to a component of the install:C:\Program Files (x86)\Cisco\Cisco Secur...
Hi anyone using radware as loadbalancer for wsa? Do we need to change anything in wsa side? We have given radware LB vip in the proxy settings of users but request is not reaching WSA.anyguide is available for the configurations.
Hello CISCO Community, I am experiencing a rather odd situation with our wireless environment. We have recently upgraded our wireless controllers, CISCO Catalyst 9800-40, to the 17.9.5. After this upgrade we started experiencing loss of associations ...
I administer a corporate customer's WiFi whereby we have multiple site locations with differing SSID requirements. We therefore have a separate AP Group for each site. One of these sites has now reached 100 AP's which I have only just discovered is t...
Hello, I create Ikev2 site to site tunnel between two cisco FPR 1140. I have same subnet on both location and i used source and destionation NAT in one site. My user try access over web some aplication and it is work, but when other site try to acc...