The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hello,We have Catalyst 9100AX series APs. We want to convert one of them to EWC. We tried to factoy reset both however after the reset they are still act like CAPWAP and stuck at CAPWAP States.P.S. We have WLCs in our network but we isolated the VLA...
Dear Cisco Community,This is regarding availability of latest firmware for below-listed Cisco CBS Segment Switches. Basically, I'm performing Manual Network Audit where I need to provide a list of latest firmware(s) with date & time stamp of release ...
Hi, I am 4-year student to university of since from Vietnam. I have a problem about ping ICMP through ASA. I can ping from R2 from outside to 4.0.0.1 of DMZ or 8.0.0.1 of inside. I can ping from DMZ via inside. Can also ping from DMZ and inside to go...
Dear Friends,I would like to know the best design and product (Cisco compatibility) for a hotline phone system. The hotline service should be available 24/7 and without downtime. I need around 150 phones to be installed inside the production factory....
Hello all, I would like to know how to calculate current throughput value at FTD 2130. What sort of information need to calculate it.? Thanks for any response to solve it.
Hello, I have an issue about ringing back tone when I call from outside --> PSTN (SIP trunk) --> CUBE --> UCCX --> redirect call to extension. I hear IVR and can do DTMF. then press extension, no ringing back tone.However when I call from PSTN (SIP t...
hello, i have enable netflow in egress interface (mpls) in IOSXR 9922 cisco routerwe see there's MPLS label type "Unknown" in several prefixes /32 (IP loopback router)and i have check by perform this command "show mpls forwarding prefixes (iploopback...
Hi,When i try to browse ESA with domain name it is not get connected. But when i put ip address then the ESA login page appeared and we can login. what can be the issue?
Hello, I am currently testing the IPSec Ikev2 VTI Based (routed-based) interworking of FPR2110 and 3rd party equipment (Fortigate) running ASA OS 9.18(3)56 as shown in the picture above.I understand that in the process of creating a Tunnel interface...
Hi Guys, I have face a very weird issue. Currently my environment are running with 2 x C3504 in HA. There have 18 AP mixed with 1702, 1852, 2802, 9120. Some support for CleanAir some not. Too use all this model, we had choose the version 8.10.130. S...
If you look at the tacacs profile as shown in the picture, there are custom characteristics I wonder how this works. In the case of other banders, I understand that tacacs are linked using these attributes If you add a value here, compare it with the...
Good day to everyone.I have two Cisco ASA running on FPR2130 assembled into a balancing group, for example:vpn-gw1.example.comvpn-gw2.example.comgeneral address vpn.example.com.Firmware version 9.18.3.56Anyconnect 4.10.07062At the moment, all our emp...