Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
1926368members
1238145discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

IPSec VPN Tunnel Lan-to-Lan decrypt count zero

Hi, I have one issue with IPSec tunnel Lan-to-Lan between ASA 5525x (v9.8) and ASA FPR 2110 (v9.16). My Tunnel is up but ping between each client was not successful. Both peer status sh cry isakmp sa in "MM_ACTIVE".I ran packet-tracer icmp between pe...

El Rondo by • Level 1
  • 233 Views
  • 15 replies
  • 0 Helpful votes

Unable to Ping and Access GUI on Cisco 2960XR

I configured a Cisco Catalyst 2960 Switch. I set vlan1 as the ip address of the switch as well as interface 1 with 192.168.1.1 with a class C subnet. Strangely I am not able to access the GUI, ping the switch or Telnet directly. However, I am able to...

ISE 3.2 Repeat Count Details

Hi,on ISE 2.4 in the live logs pages the report that one got clicking on the repeat counter was very useful because the endpoints were sorted by repeat counters. So it was very easy to find the endpoints with high repeated counters.With ISE 3.2 the r...

Secure Client ISE 3.2 Posture failure

I have just started using Secure Client Posture on my windows workstations.  All but 2 work fine.  The two are using the IP of the ISE instead of the FQDN.  All systems have the same ISEPostureCFG.xml files on them. If I disable the network connectio...

Cisco 9300X Static routes don't work to SVI Tunnels

NOTE: I have done the same test setup with 4000 series routers, and routing works fine.I have successfully setup 3 SVI (Static Virtual Interface) tunnels with IPSEC between 2 9300X switches.- I can ping the tunnel IPs- I can ping each VLAN interface ...

event syslog pattern syntax doesn't work

Hello,The DISA STIG, V-239941, asks that the following be configured:event manager applet BACKUP_CONFIG event syslog pattern "SYSLOG_CONFIG_I" action 1 cli command "copy startup-config scp://userx:xxxxxxx@10.1.48.10//opt/config_backup" action 2 syslo...

Adding Algo 8128 devices to Cisco CUCM 12.5

Has anyone tried adding multiple Algo 8182 SIP Strobe devices to their Cisco CUCM 12.5 PBX? I'd like the devices to activate on both "ring" and "in-use" events, but according to Algo that requires the "Subscribe/Notify" dialog event RFC 4235 on the P...

Load more
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: