The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hello world,I am working on creating a custom report based on the stock reports available for our call center. We would like to total the abandoned call for each day, sorted by the hour of the day. I cannot seem to create a report that only shows th...
Any idea on how can I send a random gif in message using the API ?This is the basic codepayload = { "markdown": message, "toPersonEmail": user_email, "files": #HOW TO ADD THE RANDOM GIF ???, } result = requests.post(WEBEX_URL, HEADERS, json=payload)
Hello, as part of my preparation for CCNA Security I've been making up my own topologies and configuring them, however, I might need a little help with this one. In the topology (included .pka), I configured VLANs, Port Security, OSPF, OSPF Authentic...
I configured the simple network below to test the connectivity of the ipv6 in the devices. The configurations are as shown and ipv6 unicast-routing is enabled. When pinging from Router 5 to Router 6 G0/1, it succeeds but when pinging from Router 5 to...
The latest post regarding Webex App support https://help.webex.com/en-us/article/ne3khsm/Webex-App-support-policy states that "To ensure a high level of security and access to the latest features, Webex enforces a limited lifespan for its desktop cl...
Hello, I built using the packet tracer a simple topology of three routers with ospf routing. I created a tunnel between the two routers that are not physically connected to each other, but I can't ping between one end and the other. I managed to ping...
Hello, I was creating 2 decently large ACL's to match some traffic today and I noticed something peculiar that has me puzzled. My first ACL has approx 90 ace's and pastes them fine. When I go back and look at the ACL, it looks like there are only lik...
Hi, Requirement is to enable dot1x wired authentication/authorization for Intune registered devices. There is only Azure AD and Intune. There is NO On premise component (no on premise/traditional AD, or ADCS) According to the following link, we need ...
Good day;Need help with how I can configure NAT overload with an existing vrf on a CAT9K_IOSXE V16.12. This is what I am struggling with, I currently have a vrf called AWSDX-S3. Now what I am trying to do is I have added a L2 SW and ran trunk ports...
Wired guests are not able to get out to internet, they can ping only at when payload is set to 1300 bytes or lower, this seems like an MTU issue, but its only effecting wired guest not wireless guest. Setup is a 9800 foreign on 17.9.5 code and 5520 a...
The configuration below is an IBNS2.0-based config that puts all access-mode switch interfaces into an authorized state, with no MAB or 802.1x needed, to pull device-sensor information and ship it to ISE for profiling unintrusively. It is a nice...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: