Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
1929571members
1244225discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

Resolved! FTDv managed by FMC ntp issue

Hi,I'm using FTDv 7 managed by FMC v7. Logging issues are there and there is an error about FTD not synced.So, first step seems to solve the ntp issues. FMC GUI is there for ntp which I set and it seems to be ok, but I cannot find where is the ntp se...

Resolved! File not found UCCX Custom File

Hi, we use a custom file in /opt/cisco/uccx/document/System that we can read and write from an uccx application with System.getProperty("uccx.customer.dir"). We use the in UCCX Editor the Document steps "Create FIle Document" to get a document variab...

1921 Router Config Help

Hello, I know very little about configuring cisco hardware and need some help..... we are currently running an 1800 router and I obtained a new to me 1921 router and would like to replace the 1800 router with the newer one, I managed to get it factor...

cwasilak by • Level 1
  • 85 Views
  • 5 replies
  • 0 Helpful votes

crypto keyrings command not found

Router>Router>enRouter#conf tEnter configuration commands, one per line. End with CNTL/Z.Router(config)#Router(config)#Router(config)#Router(config)#crypto key ?decrypt Decrypt a keypair.encrypt Encrypt a keypair.export Export keysgenerate Generate n...

Resolved! WSA

hello all, is it possible to access physical cisco WSA GUI without  license ???  

yoseph by • Level 1
  • 70 Views
  • 3 replies
  • 0 Helpful votes

Repeating syslog Message and then Crash

We're seeing a continuous string of the following messages on a 9407 running 17.9.5.  Eventually the switch crashes.  I can't find any info on what these messages mean exactly and whether we're looking at a software or hardware fault.  The supervisor...

copy xmodem initializing no transfer c2960

Hi Guys, i had this problem for 8 hours now and can't seem to get it cracked... after i input the command copy xmodem: flash:c2960-lanbasek9-mz.152-7.e9.binand using the SecureCRT going to Transfer > send xmodem I get this and after that nothing happ...

Expressway Single Domain 2 Seperate Expressways

Hi,We have a customer using HCS. As part of this we set up Expressway for them during the first lockdown for them to be able to use Jabber remotely for voice only (no IM&P). They use the same domain name internally and externally e.g. abc.com Another...

mikee2112 by • Level 1
  • 436 Views
  • 2 replies
  • 0 Helpful votes
Load more