Ali Bahnam

Member Since: May 27, 2012

English
Ali Bahnam commented on Telepresence Endpoints conferencing in TelePresence 3 weeks ago

Hi, I have PVDM3-16 installed on my VG which will be enough for 1 conference with 6 participants...

Ali Bahnam commented on Telepresence Endpoints conferencing in TelePresence 3 weeks ago

Hi Manish, Thank you for your reply, I already talked to Cisco support, they confirm me that no...

Ali Bahnam commented on Route Pattern in IP Telephony 6 months ago

ok, Is there any specific configuration, because when I configured it I got the outside dial tone...

Ali Bahnam commented on Route Pattern in IP Telephony 6 months ago

Thank Jaime, My point that I need to use the 91 as an outside dial tone instead of 9, is this...

Ali Bahnam commented on Cisco 6506 Core switch ethernet module failed to provide power to AP in LAN, Switching and Routing 1 year ago

nterface Admin  Oper            Power(Watts)     Device              Class...

Ali Bahnam commented on Cisco 6506 Core switch ethernet module failed to provide power to AP in LAN, Switching and Routing 1 year ago

I checked 5 ports only and have the same issue but I didn't check all module ports.The issue is...

Ali Bahnam commented on Adding phones to the cucm 9.1.2 in IP Telephony 1 year ago

Hi,The issue that I can't find the device itself in the CUCM.By the way my device is a third party...

Ali Bahnam commented on 11007 could not locate network device or aaa client in AAA, Identity and NAC 1 year ago

I have Cisco 5508 WLCs with HA (SSO) configuration.So in ISE under NW devices I should put one WLC...

Ali Bahnam commented on 11007 could not locate network device or aaa client in AAA, Identity and NAC 1 year ago

Hi Neno,the AAA are matches.Regarding the NADs (2x WLC) are listed under the ISE, and I think this...

Ali Bahnam commented on Cisco ISE CWA issue in AAA, Identity and NAC 1 year ago

Dear,The problem that I'm facing is when the user without dot1x (Guest) connect to the switch the...

Ali Bahnam commented on Cisco ISE CWA issue in AAA, Identity and NAC 1 year ago

Hi,Kindly find the attached Authentication and authorization details.Regards,

Ali Bahnam commented on Cisco CME with WIC-2AM card in IP Telephony 2 years ago

Hi Jaime,for PSTN we have the normal landline for FXO we just connect the land line it will work...

Ali Bahnam commented on CUCM 9.1 with multiple voice gateways in IP Telephony 2 years ago

Thanks for your reply,Please what are you mean by the local route group?? also can I configure the...

Ali Bahnam commented on Cisco CAP2602E Cannot Join WLC 2504 in Getting Started with Wireless 2 years ago

Dear,I have only WLC with 15 APs.For the FUS I should upgrade it before I upgrade WLC IOS??In...

Ali Bahnam commented on Cisco CAP2602E Cannot Join WLC 2504 in Getting Started with Wireless 2 years ago

Thanks for your support, Kindly advise, my current WLC IOS is 7.0.220.0 so can I upgrade it...

Ali Bahnam commented on Cisco voice gateway with FXO card in IP Telephony 2 years ago

I sent you the PCM file,Thanks

Ali Bahnam commented on CUCM 9.1 calls from sites in IP Telephony 2 years ago

Sorry, but why it is working for CME (no need to setup vpn between the sites)Can you expalin me...

Ali Bahnam commented on CUCM 9.1 calls from sites in IP Telephony 2 years ago

ok but the sites phones are registered to the CUCM so when I do call between the sites the CUCM...

Ali Bahnam commented on CUCM 9.1 calls from sites in IP Telephony 2 years ago

Hi Dragan,For another client I have the same topology but they have a CME insted of the CUCM and...

Ali Bahnam commented on How to map an Extension to access PSTN through a specific Voice card in IP Telephony 2 years ago

Thanks alot Mohammed it is working,But please now I have delay aproximately 15 Sec when I try to...

Ali Bahnam commented on How to map an Extension to access PSTN through a specific Voice card in IP Telephony 2 years ago

Dear Kevin,my problem not for the inbound I already can map Voice port to access internal extension...

Ali Bahnam commented on Cisco voice gateway with FXO card in IP Telephony 2 years ago

Yes in Middle east I can't find any specific configuration for this issue??

Ali Bahnam commented on Cisco voice gateway with FXO card in IP Telephony 2 years ago

Dragan,I tried the above but still facing the same issue,Please advise

Ali Bahnam commented on Cisco voice gateway with FXO card in IP Telephony 2 years ago

Hi Alex,I posted my VGW config please advise,Regards,

Ali Bahnam commented on Cisco voice gateway with FXO card in IP Telephony 2 years ago

My VG configured as MGCP you can find below the configuration:-voice-card 0 dspfarm dsp services...

Ali Bahnam commented on CUCM 9.1 Reports in IP Telephony 2 years ago

thanks alot aman,

Ali Bahnam commented on CUCM 9.1 Reports in IP Telephony 2 years ago

I did all the steps but still cannot find the  CDR analysis and reporting under tools.

Ali Bahnam commented on CUCM 9.1 Reports in IP Telephony 2 years ago

Good day,Thanks for your reply,Kindly there is no CDR analysis and reporting under tools, I found...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Thank you for your reply and support,Please advise, I will add section 2 config on the ASA and...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Marvin,I tested it but I got the same error (error 412 remote peer no longer responding)

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Dear Marvin,Below the configuration that I did on the routerHQ_Router#HQ_Router#sh runBuilding...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Dear Marvin,I have cisco router facing the internet and I did a static NAT to redirect the traffic...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Dear Marius,I did all the required changes but still facing the same issue (error 412 remote peer...

Ali Bahnam commented on TX 1310 Touch pad issue in TelePresence 2 years ago

Hi Vikram,in the CUCM I accessed to the device default configuration, I saw the TX1310 but in the...

Ali Bahnam commented on TX 1310 Touch pad issue in TelePresence 2 years ago

Thanks for your reply,Please can specify which files should I upload to CUCM that support the...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Still facing the same issue (error reason 412 remote peer no longer responding).I'm using cisco...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

I'm refering for this ACL:access-list nat0 extended permit ip 10.10.0.0 255.255.0.0 30.30.30.0 255...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Dear,Now the configuration that you sent I have to add ACL on it to permit the internal traffic to...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Thanks for your reply,The vpn client I cannot establish connection.For the NAT I will sdd it and...

Ali Bahnam commented on ASA 5525 9.1 Remote access VPN in VPN 2 years ago

Please any help??Below the sh run and still having the error message (reason 412):-HQ-ASA(config)#...

Ali Bahnam commented on Cisco 8941 IP phone background image in IP Telephony 2 years ago

I didn't get your points (Do you see the options?? and Do you see blue images/no images instead of...

Ali Bahnam commented on Cisco 8941 IP phone background image in IP Telephony 2 years ago

Dear Islam,I applied all the steps, but still facing the same problem

Ali Bahnam commented on IVR issue in Unified Communications Applications 2 years ago

Dear,We have two issues:-How to load the audio file??How to activate the IVR?Thanks

Ali Bahnam commented on Cisco 8941 IP phone background image in IP Telephony 2 years ago

Thanks all for your reply,I already uploaded the image for 7942 successfully.For the requirement...

Ali Bahnam commented on ACE 4710 Issue in Application Networking 2 years ago

I added the port it is working now.Thank you

Ali Bahnam commented on ACE 4710 Issue in Application Networking 3 years ago

For now the issue is I can't ping the virtual IP from the client side.

Ali Bahnam commented on Voice Mail on CME not working in Unified Communications Applications 3 years ago

autoattendant feature of CUERegards,

Ali Bahnam commented on Voice Mail on CME not working in Unified Communications Applications 3 years ago

Thank you so much for your help.Please can you support me with any documents related to the IVR...

Ali Bahnam commented on Voice Mail on CME not working in Unified Communications Applications 3 years ago

Dears,I updated the configuration but still facing the same issue the VM is not working.Below the...

Ali Bahnam commented on Remote Access VPN in VPN 3 years ago

Dears the issue has been solved and now I can ping the internal LANI just change the pool from 30....

Bio












Ali Bahnam's Stats

Points15
Discussion started 53
Answers marked as Correct 2
Endorsed 0
Content Rated 21