Atif Awan

Member Since: Aug 21, 2006

English
Atif Awan commented on xconnect within the router (Cisco7600) in MPLS 5 years ago

abakhashwin wrote:Hi Atif,do you mean also for SIP-400 with 5 port GE or 2port GE SPA,  we not have...

Atif Awan commented on xconnect within the router (Cisco7600) in MPLS 5 years ago

justa wrote:Thank you for a suggestion. I wasn't aware that it is possible to configure L3...

Atif Awan commented on xconnect within the router (Cisco7600) in MPLS 5 years ago

Jude,With 7600 you have two types of cards, LAN cards and the more intelligent ones which are...

Atif Awan commented on xconnect within the router (Cisco7600) in MPLS 5 years ago

Well if you want true local switching then you need to look at intelligent line cards like ES+...

Atif Awan commented on xconnect within the router (Cisco7600) in MPLS 5 years ago

What hardware do you have on the 7600? Local switching is not supporting on LAN cards. Atif

Atif Awan commented on Ospf inter area filtering problem in WAN, Routing and Switching 5 years ago

Provided the explanation of the topology is correct and Area 0 remains contiguous after the DC to...

Atif Awan commented on Ospf inter area filtering problem in WAN, Routing and Switching 5 years ago

Ahmed,If you can post your OSPF logical topology showing Area layout it will be easier for us to...

Atif Awan commented on EoMPLS point-to-point design in MPLS 5 years ago

Irfan,By definition an EoMPLS service in port-to-port mode should let you do whatever you want....

Atif Awan commented on Advertising MPLS Lable for Specific IPs in MPLS 5 years ago

msobier123 wrote:Atif,However, I haven't seen service providers implementing this command on the...

Atif Awan commented on Advertising MPLS Lable for Specific IPs in MPLS 5 years ago

giuslar wrote:Hello Atif,ten years ago,  C7500 were used as PE nodes and they had a label range 16-...

Atif Awan commented on Advertising MPLS Lable for Specific IPs in MPLS 5 years ago

@Guiseppe - This feature is not really used to 'conserve' label space. It is used to control label...

Atif Awan commented on PVLAN: Secondary Vlans with same IP/Subnet in LAN, Switching and Routing 5 years ago

Maurius,In my opinion this question is not more of a PVLAN question but a general one as it can be...

Atif Awan commented on ISIS topology in LAN, Switching and Routing 5 years ago

Hello Mahesh,The information is there but in the form of database. I would love to hear from you if...

Atif Awan commented on MPLS Nooby in MPLS 5 years ago

mlatosie wrote:Rich,Can you be a bit more specific on what you're trying to achieve?For example if...

Atif Awan commented on IP Default-Gateway in Getting Started with LANs 5 years ago

scooter817 wrote:HiI wanted to know can someone tell me which command is better to use, is it IP...

Atif Awan commented on MHSRP on sub interfaces in LAN, Switching and Routing 5 years ago

rburts wrote:AmarNo you can not use the same IP addresses for each HSRP group. The address you use...

Atif Awan commented on ISIS topology in LAN, Switching and Routing 5 years ago

mahesh.gohil wrote:Hi,              ------B---------CRouter-A                    -----Router-D...

Atif Awan commented on ISIS topology in LAN, Switching and Routing 5 years ago

mahesh.gohil wrote:Hi Atif,sh isis database detail  shows what metric configured with  neighbor of...

Atif Awan commented on ISIS topology in LAN, Switching and Routing 5 years ago

Have you tried using the "show isis database detail" command? It should show you what each router...

Atif Awan commented on ospf type e1 and e2 routes in LAN, Switching and Routing 5 years ago

kasiva_1987 wrote:Carl,Yes you are correct.  The difference between the two is the way the cost of...

Atif Awan commented on Per packet load sharing on 7600 in LAN, Switching and Routing 5 years ago

connect101 wrote:Atif,This what we are using now. But we tried on a 7300 lab, and the load-share...

Atif Awan commented on Per packet load sharing on 7600 in MPLS 5 years ago

Answered on a different forum:https://supportforums.cisco.com/message/3339568#3339568Atif

Atif Awan commented on Per packet load sharing on 7600 in LAN, Switching and Routing 5 years ago

connect101 wrote:Hi Atif,Thanks for you reply. It's really damage as we need absolutely to perform...

Atif Awan commented on Per packet load sharing on 7600 in WAN, Routing and Switching 5 years ago

Already answered on a separate forum. For future reference kindly do not cross-post the same...

Atif Awan commented on Per packet load sharing on 7600 in LAN, Switching and Routing 5 years ago

connect101 wrote:Dear all,Does everyone has an idea on how to activate "per-packet load sharing" on...

Atif Awan commented on Why CEF needed in MPLS Network?? in WAN, Routing and Switching 5 years ago

In simple words CEF is needed for proper MPLS functionality on Cisco routers ONLY. The reason CEF...

Atif Awan commented on OSPF functions. Load balancing. in WAN, Routing and Switching 5 years ago

Can you post your OSPF config as well as the output of the 'show ip ospf interface brief' command...

Atif Awan commented on OSPF functions. Load balancing. in WAN, Routing and Switching 5 years ago

hanwucisco wrote:I tried this one though, but I have an issue. I put the physical and two tunnels...

Atif Awan commented on MPLS frame size vs Ethernet Frame size in WAN, Routing and Switching 5 years ago

Joerg,It depends on how your traffic is going to be carried over the MPLS cloud. Following are some...

Atif Awan commented on Is GBIC SFP-10G-LR compatible with 100Mbps speeds? in WAN, Routing and Switching 5 years ago

news2010a wrote:Hello, Imagine I have from customer side SFP-10G-LR GBIC.Then circuit to be...

Atif Awan commented on ACE MODULE IN BRIDGE MODE NOT LOADBALANCING in Other Data Center Subjects 5 years ago

At a first glance I do not see anything wrong with the config but then again have not worked with...

Atif Awan commented on Supported Topology: N5k + N2k in LAN, Switching and Routing 5 years ago

Yes it will still work. Just keep in mind any other hardware considerations that are applicable to...

Atif Awan commented on AS-path prepending and Internet bgp table in WAN, Routing and Switching 5 years ago

mathieuploton wrote:Yes but if I do that, I won't have any resiliancy ? If one link fails, half of...

Atif Awan commented on Supported Topology: N5k + N2k in LAN, Switching and Routing 5 years ago

This will work as you have shown. Atif

Atif Awan commented on Internal DNS Resolution in WAN, Routing and Switching 5 years ago

You are getting some inconsistent response so I thought to add more to the confusion :- ). Is it...

Atif Awan commented on Can a RSP720-3C-GE be upgraded to handle 1M routes in Other Network Infrastructure Subjects 5 years ago

2012jakejake wrote:What are my upgrade options for the line card 7600-ES20-10G3C if I get a new...

Atif Awan commented on Is it best practice to use a dedicated link between NX7K pair for keep-alive? in Other Data Center Subjects 5 years ago

gwhuang5398 wrote:I like to use inband keep-alive that is routed through the core layer (6509...

Atif Awan commented on Issues with port-channel not passing traffic in a L2 ring in LAN, Switching and Routing 5 years ago

Chad,There appears to be a communicatoin issue over the port-channel interface. Both switches claim...

Atif Awan commented on Issues with port-channel not passing traffic in a L2 ring in LAN, Switching and Routing 5 years ago

Before we fix this I see something strange here. I would have expected either the switch at Site-A...

Atif Awan commented on Cisco ACE module in Other Network Infrastructure Subjects 5 years ago

You should post your query in one of the Data Center sub-forums (application networking for example...

Atif Awan commented on Can a RSP720-3C-GE be upgraded to handle 1M routes in Other Network Infrastructure Subjects 5 years ago

2012jakejake wrote:Hi,I have a 7606, with redundant RSP (RSP720-3C-GE with sub-modules 7600-PFC3C...

Atif Awan commented on ospf path selection in WAN, Routing and Switching 5 years ago

No it is not possible. Area 1 will not have any 'direct' routing information for Area 2. Any inter-...

Atif Awan commented on Issues with port-channel not passing traffic in a L2 ring in LAN, Switching and Routing 5 years ago

chad-young wrote:Ok, got the spanning-tree infor for two VLANs from the Site A Switch:SiteA#sh...

Atif Awan commented on Issues with port-channel not passing traffic in a L2 ring in LAN, Switching and Routing 5 years ago

You need to understand your Layer-2 topology to be able to get an idea of why traffic is not taking...

Atif Awan commented on How to configure HSRP between two Layer3 switches with no trunk between them? in LAN, Switching and Routing 5 years ago

gkushnir21 wrote:I have 2 Cisco 6509 MultiLayer Switches. I have no Layer 2 trunk between them. ...

Atif Awan commented on Nexus 5000 and Fabric Path in LAN, Switching and Routing 5 years ago

Not at the moment.Atif

Atif Awan commented on Different OSPF Process ID For Interconnect between 2 OSPF Domain in WAN, Routing and Switching 5 years ago

[email protected] wrote:Hi Atif,Have no plan of running BGP, you can refer to my update diagram. Previous...

Atif Awan commented on 3750E Throughput in LAN, Switching and Routing 5 years ago

Fair enough. Hopefully someone with more experience on performance testing can chime in. In the...

Atif Awan commented on Different OSPF Process ID For Interconnect between 2 OSPF Domain in WAN, Routing and Switching 5 years ago

[email protected] wrote:Hi Peter,Based on my requirement ,if I configure V160 and V162 with OSPF aera 50...

Bio












Atif Awan's Stats

Points345
Discussion started 0
Answers marked as Correct 45
Endorsed 0
Content Rated 4