Bilal Nawaz

Member Since: May 14, 2010

English
Bilal Nawaz's Activity on Cisco Support Community
Currently displaying 50 results

Bilal Nawaz has commented on Cisco Nexus 3000 ssh access

1 day 10 hours ago
Its not in a VRF or anything like that is it? Also have you tried setting...

Bilal Nawaz has commented on Distance In OSPF

1 day 10 hours ago
Hmm, im not too sure with the command reference, though i think you are right...

Bilal Nawaz has commented on Cisco 3560G and max MTU Size

1 day 11 hours ago
Hi Matt, you are correct. Configurable maximum transmission unit (MTU) of...

Bilal Nawaz has commented on Real world VLSM?

2 days 7 hours ago
I'm sure quite a few places only use that for point-to-point connections...

Bilal Nawaz has commented on Layer 2 over geographically disperse networks.

2 days 11 hours ago
Hello, for DR, in an "Active / Standby" solution you could extend...

Bilal Nawaz has commented on Two direct connected inferfaces / mis-configure subnet masks , what will happen ?

2 days 11 hours ago
They will still be able to reach each other.Router A's interface is 10.10....

Bilal Nawaz has commented on Load Balance & redundancy for internet from 2 different sites?

2 days 11 hours ago
Hi Louis, you could set default routes on the ASA's with tracking, and use...

Bilal Nawaz has commented on Show ip route, Why 46.1.1.4 is chosen as default route ?

2 days 11 hours ago
Hello, the static default route is showing to two next hops, 46.1.1.4 and 36.1....

Bilal Nawaz has commented on Trunking off a switch that is connected as a vPC peer

3 days 5 hours ago
was vpc peer-gateway configured on both sides (if they were the gateway?) It...

Bilal Nawaz has commented on Miraki issue

3 days 7 hours ago
Take this up with Meraki support.Apr 16 12:48:10 IN-WiFi-05 Hermes IN-L0553 802...

Bilal Nawaz has commented on Using different native VLANs on different ports of a switch configured as trunks

3 days 8 hours ago
At least we're on the same page now ;) I also think it's the wireless...

Bilal Nawaz has commented on Using different native VLANs on different ports of a switch configured as trunks

3 days 8 hours ago
Oh well maybe it's me not interpreting correctly, which has happened before...

Bilal Nawaz has commented on Real world VLSM?

3 days 9 hours ago
Yes sure if you have 200 hosts you can go with the model you've shown above...

Bilal Nawaz has commented on ACS with two IP Address?

3 days 9 hours ago
Hello Jairo, I don't see why this shouldn't work, I haven't tried...

Bilal Nawaz has commented on Will a Power Cycle fix a incorrect configuration?

3 days 10 hours ago
Hi Chris, you are correct, as long as you don't save the config, if you...

Bilal Nawaz has commented on Cisco load balancer with Real to VIP mapping ?

3 days 10 hours ago
If the real server's default gateway is to the load balancer, whatever that...

Bilal Nawaz has commented on Miraki issue

3 days 11 hours ago
There are built in troubleshooting tools within the AP if you were to log on to...

Bilal Nawaz has commented on Using different native VLANs on different ports of a switch configured as trunks

3 days 11 hours ago
Nick, if you want the routers to be able to talk to each other they MUST be on...

Bilal Nawaz has commented on How defer ARP entries from mac-table in Frames (package) forwarding

4 days 23 min ago
The question isnt very clear. ARP is the conversion from IP to MAC. If a host...

Bilal Nawaz has commented on route summarization - could this be wrong ?

4 days 1 hour ago
Yes you're not meant to advertise what doesn't belong to you. Though...

Bilal Nawaz has commented on Cisco 3560G and max MTU Size

4 days 2 hours ago
Hi Matt,The 3560 only supports up to the MTU size of 9000, stated in the...

Bilal Nawaz has commented on VMPS x CISCO MAB (MAC Authentication Bypass)

4 days 4 hours ago
Yes Exactly. You can specify which vlan to put the mac address in on those...

Bilal Nawaz has commented on VMPS x CISCO MAB (MAC Authentication Bypass)

4 days 5 hours ago
With MAB, the mac address of the host is in the radius server which will...

Bilal Nawaz has commented on Using different native VLANs on different ports of a switch configured as trunks

4 days 10 hours ago
Not possible to un-tag multiple vlans on a trunk, unless you specify multiple...

Bilal Nawaz has commented on OSPF stub area configuration

4 days 10 hours ago
Yes, if you put the no-summary command at the ABR it will generate a...

Bilal Nawaz has commented on Routing VLANS without inter-vlan connectivity?

4 days 10 hours ago
Do inter-vlan routing, but on the public interface on the router, put an ACL...

Bilal Nawaz has commented on Network Segregation

4 days 10 hours ago
DUPLICATE POSTING

Bilal Nawaz has commented on Distance In OSPF

4 days 10 hours ago
What is the error you are getting please? Is it that the parser doesn't let...

Bilal Nawaz has commented on valn on an existing network

4 days 11 hours ago
You can create vlans no problem, however each vlan will need its own subnet...

Bilal Nawaz has commented on Network speed during file transfer using LAN

4 days 11 hours ago
It depends how quick the laptop can write the data to disk/storage too.

Bilal Nawaz has commented on FabricPath or OTV between two DataCenter using Direct fiber cable

2 weeks 1 day ago
Hi Robert, if you want to make an argument out of this (Which it seems like...

Bilal Nawaz has commented on FabricPath or OTV between two DataCenter using Direct fiber cable

2 weeks 1 day ago
I didn't really cast any doubt. If it is indeed supported on the N9K...

Bilal Nawaz has commented on FabricPath or OTV between two DataCenter using Direct fiber cable

2 weeks 1 day ago
Hi Robert, thanks for your contribution to the discussion, though I want to...

Bilal Nawaz has commented on show run does not show usernames configured on the router

2 weeks 5 days ago
When you log in, are you prompted for a username? When you're logged in do...

Bilal Nawaz has commented on VoiP

2 weeks 6 days ago
Please move question to this section:Collaboration, Voice and Video

Bilal Nawaz has commented on CCIE LAB EXAM FOR Non US Imigrants

2 weeks 6 days ago
Hi John, If you found the post helpful please rate it or mark as answered, it...

Bilal Nawaz has commented on show run does not show usernames configured on the router

2 weeks 6 days ago
Can you do a "show run all | inc user" please? Also if you could...

Bilal Nawaz has commented on show run does not show usernames configured on the router

2 weeks 6 days ago
Are you using radius or tacacs credentials to log in? or is it local username...

Bilal Nawaz has commented on ISE - sponsor guest portal with smartcard authentication

2 weeks 6 days ago
Hi Ryan, if you could share it, I'd be very grateful!Thank youBilal

Bilal Nawaz has commented on Nexus N7k F2e routed interface and Sync Configuration

2 weeks 6 days ago
Hi Steven, What is issue with rebind command? If it is required, it will...

Bilal Nawaz has commented on CCIE LAB EXAM FOR Non US Imigrants

3 weeks 1 day ago
This is what I see in Cisco OLSM when I log in to see my ccie status in the...

Bilal Nawaz has commented on Inter-VLAN Routing

3 weeks 2 days ago
by the way, your ZBFW statements on the interface should be on all the sub-...

Bilal Nawaz has commented on Inter-VLAN Routing

3 weeks 2 days ago
One of the class maps dont make sense to me: class-map type inspect match-...

Bilal Nawaz has commented on Static route not being redistributed into OSPF

3 weeks 2 days ago
I wonder why that matters (though its a valid point for end to end flow), the...

Bilal Nawaz has commented on Static route not being redistributed into OSPF

3 weeks 2 days ago
What troubleshooting has been done on the other side? can you see the prefix in...

Bilal Nawaz has commented on Ping L2 switch from Router on different subnet

3 weeks 2 days ago
These are valid points Rick, though I would like to express my opinion, that...

Bilal Nawaz has commented on Ping L2 switch from Router on different subnet

3 weeks 2 days ago
What I would do is have an interface (management interface) either dedicated...

Bilal Nawaz has commented on Please suggest one Gigabyte switch for replacing Cisco 2960 G 48 port

3 weeks 2 days ago
What is the budget? How much can be spend on a replacement switch?

Bilal Nawaz has commented on How to display Transceiver Cisco PID in Nexus platform?

3 weeks 2 days ago
Hello Frank, may I ask why you need the PID?The part number is displayed as...

Bilal Nawaz has commented on Does the dot1q native VLAN need to be defined on the switch?

3 weeks 3 days ago
If you are tagging your native VLAN but do not have that VLAN in the vlan...

Bio

Working full time as a network and security infrastructure engineer in a financial organisation.
CCIE #45032
I enjoy networking technologies and thrive on helping others, and learning as a group wherever I can.
Palo Alto - ACE
JNCIA-JUNOS
JNCIS-FWV
F5-CA
CCIE - RS
CCIE - Data Center wr








  • Cisco Designated VIP

    2014 LAN





  • Community Spotlight Award

    Questions Answered May 2013





  • Community Spotlight Award

    Mobile App Contributor April 2013









Bilal Nawaz's Stats

Points2160
Discussion started 55
Answers marked as Correct 212
Endorsed 4
Content Rated 50

Bilal Nawaz's Interests

Cisco Support Community, Data Center, Network Infrastructure, Security, Top Contributors