campbech1

Member Since: Sep 10, 2007

English
campbech1's Activity on Cisco Support Community
Currently displaying 50 results

campbech1 has created OTV/VXLAN to a new remote data center

1 day 2 hours ago
So here is my issue. We are in the process of building out a new, very small,...

campbech1 has created WLC anchoring between 7.6.130 and 8.1.102 code

2 months 2 weeks ago
I have site that is quite small with only 20 access points on a...

campbech1 has commented on Etherchannel in switch multilayer packet tracer

5 months 1 week ago
I just did this same setup in Packet Tracer 6.1.1 and it appears to work....

campbech1 has created High CPU, broadcasts, and L3 gleans

5 months 1 week ago
We have a 7010 core with a WLC attached to it. We have been noticing high CPU...

campbech1 has commented on ASA 5520 Active/standby - Standby ASA crashing

5 months 3 weeks ago
The corrupt lines were NAT entries. The configuration had NAT rules in the...

campbech1 has commented on L2MCAST-SLOT2-2-L2MCAST_MAC_FULL_LC

5 months 3 weeks ago
After opening a TAC case and also escalating the case we've found that the...

campbech1 has commented on ASA 5520 Active/standby - Standby ASA crashing

5 months 3 weeks ago
We had a similar issue last year with our firewalls after performing an upgrade...

campbech1 has commented on How to only allow internet access.

5 months 3 weeks ago
Carlos,How I normally handle this is to build a network object group and place...

campbech1 has created Cisco 8510 wireless controller - vPC ok?

5 months 3 weeks ago
Does the new version 8.0 code allow for the 8500 controllers to be connected...

campbech1 has commented on 3560 12.2(50)SE SSH Feature

5 months 3 weeks ago
Carlos,If you do a "sh version" you will find you probably have the...

campbech1 has commented on L2MCAST-SLOT2-2-L2MCAST_MAC_FULL_LC

7 months 6 days ago
Thank you for the information, but that's the same information I already...

campbech1 has created L2MCAST-SLOT2-2-L2MCAST_MAC_FULL_LC

7 months 1 week ago
Since upgrading to version 6.2(8b) on our core Nexus 7ks I'm seeing the...

campbech1 has commented on Enterprise multicast design question

8 months 1 week ago
Peter,Can't thank you enough. I have a change window tomorrow that I'll...

campbech1 has commented on Enterprise multicast design question

8 months 1 week ago
Peter,Thank you very much for your reply.The links between the sites are...

campbech1 has created Enterprise multicast design question

8 months 1 week ago
Today we are 3 hospital facilities each utilizing Cisco hardware. The...

campbech1 has commented on Firewall Failover without standby address

10 months 6 days ago
That is strictly the licensing. You're configured for active/standby right...

campbech1 has commented on Get the report for no. of clients associated to a WLAN for a day

10 months 1 week ago
Maybe try Cacti?Here is an interesting forum posting about it. Might actually...

campbech1 has commented on Cisco 2921 destination NAT for transparent proxy

10 months 1 week ago
Sorry, I didn't catch that it was off-site. I don't have any...

campbech1 has commented on Cisco 2921 destination NAT for transparent proxy

10 months 1 week ago
Also, does this proxy support WCCP? That might be an even easier connection to...

campbech1 has commented on Firewall Failover without standby address

10 months 1 week ago
We are running active/standby pairs in a few of our hospitals and have this...

campbech1 has commented on How GLBP falls under L2 prototcol

10 months 1 week ago
Nice write up here:http://aconaway.com/2008/03/18/hsrp-vs-glbp/GLBP is a little...

campbech1 has commented on EHWIC-1GE-SFP-CU

10 months 1 week ago
Yes it can support anything the router is licensed for.For instance, here is...

campbech1 has commented on Cisco 2921 destination NAT for transparent proxy

10 months 1 week ago
Sounds like you need a route-map to change the next IP hop?This would be the...

campbech1 has commented on Trying to route Vlan traffic from 3560 through ASA 5520

10 months 1 week ago
Also on the switch I don't see any ports that are setup to be trunks.How I...

campbech1 has commented on Trying to route Vlan traffic from 3560 through ASA 5520

10 months 1 week ago
I diagram would be very helpful to get this resolved for you.

campbech1 has commented on EHWIC-1GE-SFP-CU

10 months 1 week ago
By normal you mean putting an IP address directly on the port? Then yes, it...

campbech1 has commented on Inter-VLAN routing help please

10 months 1 week ago
Looks like there is quite a bit missing with your upload. Most of the issues...

campbech1 has created How to connect redundant routers into an ASA

10 months 1 week ago
I'm attempting to bring two networks together that requires the existing...

campbech1 has commented on IOS-XE missing object-group network command?

11 months 2 weeks ago
I don't believe it was supported until version 3.12 and you're on 3.10...

campbech1 has commented on IOS-XE missing object-group network command?

11 months 2 weeks ago
I'm late to update this post but it looks like the command is back in Cisco...

campbech1 has created OTV question

1 year 3 months ago
I'm getting ready to setup OTV between two of our data centers and...

campbech1 has commented on Problem Connecting Nexus 5K to 2960 switch

1 year 3 months ago
What are you seeing with a "sh int trunk" on the 2960?

campbech1 has commented on Problem Connecting Nexus 5K to 2960 switch

1 year 3 months ago
What are you seeing with a "sh int trunk" on the 2960?

campbech1 has created Reverse route injection

1 year 3 months ago
Please bear with me as I explain.I'm setting up a new site-2-site VPN...

campbech1 has created Reverse route injection

1 year 5 months ago
My senerio involves two new connections to a partner that requires automatic...

campbech1 has commented on VTP question on chassis replacement

1 year 8 months ago
So are you bringing up the VSS outside of the network with their full...

campbech1 has commented on VTP question on chassis replacement

1 year 8 months ago
When you issue the commands to convert to VSS doesn't it re-write the...

campbech1 has commented on VTP question on chassis replacement

1 year 8 months ago
It's more of a concern for power.

campbech1 has created VTP question on chassis replacement

1 year 8 months ago
We are in the process of replacing a pair of 6509 chassis with 6509E's until we...

campbech1 has commented on Suggestion for separate VPN appliances and managing IPSEC VPN routes

1 year 8 months ago
This helped me immensely and is working great. Thank you for the assistance!

campbech1 has commented on IOS-XE missing object-group network command?

1 year 8 months ago
Nothing at all. No one seems to have an answer. I'm going to call my Cisco SE...

campbech1 has created IOS-XE missing object-group network command?

1 year 8 months ago
I'm in the process of installing four Cisco 4451-X routers and see that the...

campbech1 has created Anyone seeing these issues with 7.5.102.0?

1 year 9 months ago
Since upgrading from 7.3 to 7.5.102.0 we are seeing the following issues and...

campbech1 has commented on WLC Upgrades to 7.5.102.0 from 7.4.100.0 Question

1 year 9 months ago
Stavros,Since you've been on 7.5 code for almost 2 months now, what has been...

campbech1 has created Suggestion for separate VPN appliances and managing IPSEC VPN routes

2 years 4 days ago
I'm looking to install two Cisco ASA 5585X firewalls in active/standby and am...

campbech1 has created Create the "outside" interface on a subinterface?

2 years 9 months ago
So I have, what I think is an easy question, but I think I'm overthinking it....

campbech1 has created VPN routing issue

2 years 10 months ago
So here is the problem we are experiencing.A remote site to site VPN from 172....

campbech1 has commented on Clients disconnecting randoming..

3 years 3 months ago
Seeing it on a few random clients (10 or less HP laptops), but the visibility...

campbech1 has commented on Clients disconnecting randoming..

3 years 3 months ago
Seeing it on a few random clients (10 or less HP laptops), but the visibility...

campbech1 has created Clients disconnecting randoming..

3 years 3 months ago
So as for the network layout we are using two 5508 controllers running 7.1.19...

Bio












campbech1's Stats

Points25
Discussion started 37
Answers marked as Correct 5
Endorsed 0
Content Rated 1