canero

Member Since: Jun 25, 2004

English
canero commented on Does 2960S Lan Lite Guest Vlan Supported? dot1x guest-vlan command does not exit in AAA, Identity and NAC 1 year ago

It seems that the interface command "dot1x guest-vlan" has been depreciated long time ago with IOS...

canero commented on Does 2960S Lan Lite Guest Vlan Supported? dot1x guest-vlan command does not exit in AAA, Identity and NAC 1 year ago

Hi Charles,The link you provide is very good that explains the features that Lan Lite is not enough...

canero commented on Cisco ISE with TACACS+ and RADIUS both? in AAA, Identity and NAC 1 year ago

Thanks Charles,This was what we were searching, so it is not ISE 2.0 but 1.5 that has changed Best...

canero commented on Cisco ISE with TACACS+ and RADIUS both? in AAA, Identity and NAC 1 year ago

Hello,We could not find information about the ISE roadmap regarding Tacacs support other than this...

canero commented on Cisco ISE Virtual Appliance HyperV Support in AAA, Identity and NAC 2 years ago

Hi Charles, Thank you for the rapid answer. Due to HyperV increasing marketshare the demand on...

canero commented on ETHCNTR-3-LOOP_BACK_DETECTED on switches singly connected to the distribution switch in LAN, Switching and Routing 2 years ago

hi,We are experiencing a similar issue with 2960S switches ( WS-C2960S-48LPD-L) with IOS c2960s-...

canero commented on Nexus FabricPath - Spine Leaf in LAN, Switching and Routing 3 years ago

Hi Alex,For DCI Connectivity, you need a L1 link as darkfiber.  Fabricpath is not recommended for...

canero commented on ISE MAB is not Triggered for Linux Host in AAA, Identity and NAC 3 years ago

Hi Ravi,Since the linux is some kind of embedded linux, we could not get the tcp dump on the PC...

canero commented on vPC peer-gateway on Nexus 7k in Data Center & Virtualization 3 years ago

A similar discussion is as below:https://supportforums.cisco.com/message/3989694#3989694As addition...

canero commented on Two_ISP Issue in WAN, Routing and Switching 3 years ago

You may do nat with seperate overload commands for two internet facing interfaces, 2 acls for lan...

canero commented on Need a simple QOS configuration for point-to-point metro-e connection. in WAN, Routing and Switching 3 years ago

How much bandwidth is used by tje servers, i think you are trying to prioritize servers against...

canero commented on Lan to Lan Communication using same subnet between 2 locations in WAN, Routing and Switching 3 years ago

Hi Pawan,You may consider OTV as well if you have ASR or Nexus switches as wellSent from Cisco...

canero commented on N7K-M132XP-12: can we make it over subscribe 1:2 or 1:3 for two or three connected ports in port group in Borderless Networks 3 years ago

Hi jignesh,Dedicated mode prevents other pprts to be used only allows one port to be used,i think...

canero commented on Single or dual 4500e for redundancy in Borderless Networks 3 years ago

Hello,Providing chassis redundancy may be important as if you have problem woth the single 4500...

canero commented on Best practices backup network design in Storage Networking 3 years ago

Hello Jose,Looking for a similar document as well, i.e. whether to choose a seperate physical...

canero commented on Ask the Expert: Scaling Data Center Networks with Cisco FabricPath in Unified Computing 3 years ago

Hi,I would like to ask about VPC+ also, I understand that VPC+is used for connecting the hosts to...

canero commented on 6500 VSS and VPN (IPSEC-3) port adapter in LAN, Switching and Routing 3 years ago

Hello, Need the same information for a VSS design (for IPSEC-2G card), but still could not find...

canero commented on Nexus 7000 no outputs. in Server Networking 4 years ago

Hi Fariha,Can you send the output of  "?" and "show ?" commands, also do you use radius or local...

canero commented on N1K Nexus1000v VSM Cannot See VEM in Server Networking 4 years ago

Hello All,The problem turned out to be related with the  VSM-VEM Communication (which is broadcast...

canero commented on Hub Support in DMVPN, Key Server in Get VPN in WAN, Routing and Switching 4 years ago

Hello Laurent,On some of the documents ASR Key Server Support is told to be on the Roadmap, is...

canero commented on MPLSoDVMVPN Scalability for L3 MPLS VPN and VPLS in MPLS 4 years ago

Hello Matthew,Thanks for the reply, seems a good solution,  the CSC seems a good way of carrying an...

canero commented on NX-OS Nexus 7018 License-id for Chassis or Supervisor in Server Networking 5 years ago

Hello Jerry,Thank you, so only time we need to rehost the license is during a chassis change,Best...

canero commented on Is More than one Trust Point possible for Certificate Authority Services in VPN 5 years ago

Hello Marcin,The link is a good way to seperate trustpoints according to router groups (e.g. region...

canero commented on Windows 2008 CA Certificate Authority Enrollment generic error PKCS#7 vs PKCS#10 in VPN 5 years ago

Hello Marcin,The solution was in fact turned out to be simple. i.e we left the IP Address of the...

canero commented on Maximum ARP Cache Entries for ISRg2 1921 and 887VA Devices in WAN, Routing and Switching 5 years ago

Hello Latchum,There may be a large number of hosts for the Vlan that 1921 and 887 is residing, so...

canero commented on 887G Cellular 0 interface not going up without interesting traffic in DMVPN in VPN 5 years ago

Hello Andrew,Since we are using DMVPN, we thought of using  gre tunnel keepalives, but the attached...

canero commented on ASK THE EXPERTS - NEXUS 7000 IN VIRTUALIZED DATA CENTER in Server Networking 5 years ago

Hi Balaji,I would like to ask the Performance QoS requirements of the OTV Tunnel,  are there any...

canero commented on Nexus 1000v Active/Standby Teaming Between 10G and 1G in Server Networking 5 years ago

Hello,After a few more hours of troubleshooting, our problem turned out to be cleared as follows:1...

canero commented on Nexus 1000v Active/Standby Teaming Between 10G and 1G in Server Networking 5 years ago

Hello Louis,Our 10G Eth interface is Eth3/4, and 1G interface is Eth3/2. We changed the port-...

canero commented on Nexus 1000v Active/Standby Teaming Between 10G and 1G in Server Networking 5 years ago

Hello Louis,If we configure under(config)# interface vethernet 1(config-if)# pinning id 1 ( 1 is...

canero commented on Nexus 1000v Active/Standby Teaming Between 10G and 1G in Server Networking 5 years ago

Hello Louis,In fact we have 14 Blades in IBM H Chassis, each of them seperately connects to Nexus...

Bio












canero's Stats

Points8
Discussion started 29
Answers marked as Correct 0
Endorsed 0
Content Rated 6