chrysostomos1980

Member Since: Dec 16, 2009

Canada - Français
chrysostomos1980 commented on Error on Restore CUCM 8.6 in IP Telephony 11 months ago

Hi pLS Share exactly the error that you get Assume that you restarted teh DRF Master and and local...

chrysostomos1980 commented on Error on Restore CUCM 8.6 in IP Telephony 11 months ago

Hi Amod Did you choose ONLY the PUB into DRS? /cc

chrysostomos1980 commented on S2S VPN Between Juniper and Cisco ASA /Tunnel is UP/Ping not Working in VPN 1 year ago

Hi From cisco asa tunnel-group 217.17.2.168 type ipsec-l2ltunnel-group 217.17.2.168 general-...

chrysostomos1980 commented on CTS-1100 software not upgrading from 1.6.0(3954) version in TelePresence 1 year ago

with factory reset and then tried again to upgrade, everything worked as expectedAlso is one field...

chrysostomos1980 commented on CTS-1100 software not upgrading from 1.6.0(3954) version in TelePresence 1 year ago

Hi Martin Thank you for your answer1) If i try to connect to codec via console what is the benefit?...

chrysostomos1980 commented on sx20 Throught Expressway E&C in TelePresence 1 year ago

The issue with the incoming calls to sx20 resolved by disable the NAT into router for the h323...

chrysostomos1980 commented on sx20 Throught Expressway E&C in TelePresence 1 year ago

Hi OkanlawonFirst thank you very much for your input.Five stars to you1) About certificates.Pls...

chrysostomos1980 commented on Windows Mobile And Jabber in IP Telephony 2 years ago

Hi I found Linphone and is working fine with CUCM Thank youchrysostomos 

chrysostomos1980 commented on Calls from Sip Trunk to UC540 and then to CUE returned ** Service Unavailable** in IP Telephony 2 years ago

Hi  Problem solved It was a BUG to the IOS of UC540Changed the ios fixed the problem  

chrysostomos1980 commented on Calls from Sip Trunk to UC540 and then to CUE returned ** Service Unavailable** in IP Telephony 2 years ago

Hi My friend i have done thousands of UC implementations :) Yes its there all the appropriates...

chrysostomos1980 commented on Calls from Sip Trunk to UC540 and then to CUE returned ** Service Unavailable** in IP Telephony 2 years ago

Hi Thank you for the response againYes i have a trancoder enable and is registered successfully...

chrysostomos1980 commented on Calls from Sip Trunk to UC540 and then to CUE returned ** Service Unavailable** in IP Telephony 2 years ago

Hi Interface                  IP-Address      OK? Method Status               ...

chrysostomos1980 commented on Jabber 9.7 problem with Presence outlouk and with photos in Jabber Clients 2 years ago

HiWe have also a full collaboration edge deployment here ( Expressway C and E)We cant change it to...

chrysostomos1980 commented on CUCM Version 9.X generate alerts every day in IP Telephony 2 years ago

Hi Manish I have put 5 points and didn't mark the question as answered since we are not sure yet if...

chrysostomos1980 commented on CUCM Version 9.x forward feature in IP Telephony 2 years ago

Hi ChrisThat means that all the calls would be returned back to 111And they dont want thatI think...

chrysostomos1980 commented on Jabber 9.7 problem with Presence outlouk and with photos in Jabber Clients 2 years ago

Hi EmmanuelFirst thank you very much for the helpSome questions about EDI:1)If i use EDI instead of...

chrysostomos1980 commented on Jabber 9.7 problem with Presence outlouk and with photos in Jabber Clients 2 years ago

Hii didnt check with other devices , only with windowsI prefer UDS either of EDI<?xml version="1...

chrysostomos1980 commented on Called party transformation pattern For sip trunk in IP Telephony 2 years ago

Hi AllI am using trnaslation rule to move the prefix before to send the call outside to the...

chrysostomos1980 commented on Called party transformation pattern For sip trunk in IP Telephony 2 years ago

Hi We want to add 88 in front of the call to hit the specific dial peer BUT we want to remove the...

chrysostomos1980 commented on Called party transformation pattern For sip trunk in IP Telephony 2 years ago

Hi Sreekanth 2  The previous post was for an old issue Now we have sip trunk from CUCM to VG and...

chrysostomos1980 commented on No RTP Between two sites in IP Telephony 2 years ago

Another (5*) to youThank you so much for the detailed explanations about wiresharkPS:I will not...

chrysostomos1980 commented on No RTP Between two sites in IP Telephony 2 years ago

Hi SreekanthYes my mistake.i put one zero more.The destination ip is 192.168.100.20.Could you pls...

chrysostomos1980 commented on No RTP Between two sites in IP Telephony 2 years ago

Hi SreekanthI have attached the packet captureCUCM Ips: 192.168.1.202-203CUPS: 192.168.1.206source...

chrysostomos1980 commented on No RTP Between two sites in IP Telephony 2 years ago

Thank you Sreekanth I will take the capture and return back with a feedback

chrysostomos1980 commented on No RTP Between two sites in IP Telephony 2 years ago

Hi and thank you for the replyTake packet captures @1/ IP Phones at both sites. Into the switch of...

chrysostomos1980 commented on SX20 UNABLE TO PAIR WITH THE TOUCH in TelePresence 2 years ago

HiThank you for the postMy question is indeed need it that?Because sx20 is register to cucm.so when...

chrysostomos1980 commented on SX20 UNABLE TO PAIR WITH THE TOUCH in TelePresence 2 years ago

HiIts cisco touch panel and connected throught LAN.now its okThank youSomething else if you know...

chrysostomos1980 commented on SX20 UNABLE TO PAIR WITH THE TOUCH in TelePresence 2 years ago

HiThis is very strangeWhen i connect the Codec into THE tv screen then the touch paired succesfully...

chrysostomos1980 commented on RightFax-Voice Gateway-ISP all path via SIP in IP Telephony 2 years ago

Mohit5 stars to youThe reason for the failure whas the double m line in sip invitewith only the ...

chrysostomos1980 commented on SX20 Tandberg and CUCM version 9 in TelePresence 2 years ago

AmitThank so much for your answersDo you know what actual i have to configure into ASA?The natting...

chrysostomos1980 commented on Unified Intelligence Center in Contact Center 2 years ago

Can you help please?

chrysostomos1980 commented on Jump upgrade 7.1.5-9.1 - Callmanager service not starting in IP Telephony 2 years ago

RobLong long time I am very well my friend , and i hope and you alsoAnother one time you show me...

chrysostomos1980 commented on Jump upgrade 7.1.5-9.1 - Callmanager service not starting in IP Telephony 2 years ago

Hi KasperCan you advice pls how you manage to install the licenses for version 7.x into vmware and...

chrysostomos1980 commented on How to change OS pass for CUCM version 9 in VMware in IP Telephony 2 years ago

Thank you AllRegardschrysostomos

chrysostomos1980 commented on How to change OS pass for CUCM version 9 in VMware in IP Telephony 2 years ago

It was my mistake , yes reset not change the OS passBut my question was related for CUCM into...

chrysostomos1980 commented on How to change OS pass for CUCM version 9 in VMware in IP Telephony 2 years ago

But we dont know the old OS pass

chrysostomos1980 commented on IPCCX version 7.0(1)SR03_Build011 /Unable to update Cisco Unified CM config in IP Telephony 2 years ago

Yes this trueWe have migrated cucms from mcs servers to ucs Before was 7.1.5 the cucm and now in...

chrysostomos1980 commented on IPCCX version 7.0(1)SR03_Build011 /Unable to update Cisco Unified CM config in IP Telephony 2 years ago

CUCM Version 9.x Its working fine now but the issue is that we cant change the parameters that i...

chrysostomos1980 commented on Unity Connection version 9.x / Issue with users in IP Telephony 2 years ago

Hi GuysThank you for the replyI  have tried throught CLI Result looks like this:admin:run cuc...

chrysostomos1980 commented on Enable xmpp federation in CUPS 9.x on Premises in IP Telephony 2 years ago

GuysCan you help with that?

chrysostomos1980 commented on CUCM Version 9.1.x Unable to login to user Page in IP Telephony 2 years ago

HiThe password into the LDAP authentication was wrongThank you  for teh ideaPlease rate all useful...

chrysostomos1980 commented on CUCM Version 9 in vmware UNknown Error in IP Telephony 2 years ago

GuysDo you have any idea what is this error?Please rate all useful posts  Regards Chrysostomos ""...

chrysostomos1980 commented on Cisco Jabber Softphone not working in IP Telephony 2 years ago

AokDid you find anyhting?Please rate all useful posts  Regards Chrysostomos ""The Most Successful...

chrysostomos1980 commented on CUCM 9.1 Backup issue (Local Agent is not responding) in IP Telephony 2 years ago

Try this one as per the link you had post and you should be fineTry with the search button and you...

chrysostomos1980 commented on Forward Hunt No answer/Busy > Voicemail Pilot > Call Handler in IP Telephony 2 years ago

you can use your hunt pilot to have something for the no answer and something else for the busyBut...

chrysostomos1980 commented on Cisco Jabber Softphone not working in IP Telephony 2 years ago

check abovewith the others attachedPlease rate all useful posts  Regards Chrysostomos ""The Most...

chrysostomos1980 commented on Cisco Jabber Softphone not working in IP Telephony 2 years ago

AokAttached is the fileI dint see any usuful therePlease rate all useful posts  Regards...

chrysostomos1980 commented on Forward Hunt No answer/Busy > Voicemail Pilot > Call Handler in IP Telephony 2 years ago

As far as i know no you cant.But you can send the call into the call hanlder in case that is no...

Bio












chrysostomos1980's Stats

Points428
Discussion started 147
Answers marked as Correct 18
Endorsed 0
Content Rated 132