ctrujillo@magenta.cl

Member Since: Jan 23, 2010

English
ctrujillo@magenta.cl's Activity on Cisco Support Community
Currently displaying 47 results

ctrujillo@magenta.cl has created load distribution not so even for multicast traffic (ECMP) between a GSR 12410 (XR) and a CRS-1 router

10 months 2 weeks ago
Hi, I have a scenario in which I see the multicast S,G streams are...

ctrujillo@magenta.cl has commented on DMVPN fast convergence with ebgp and capacity planning

1 year 9 months ago
Also, At the hub router of tunel 178, I see it is receiving nhrp regist request...

ctrujillo@magenta.cl has commented on DMVPN fast convergence with ebgp and capacity planning

1 year 9 months ago
Hi Marcin, I made the following test using the debugs you suggested and I...

ctrujillo@magenta.cl has commented on DMVPN Deployment Configuration ( BGP + VRF )

1 year 9 months ago
Hi, Just want to know, if in the examples presented there was also tested H.A...

ctrujillo@magenta.cl has commented on DMVPN fast convergence with ebgp and capacity planning

1 year 9 months ago
Marcin, After deleting the command "if-state nhrp" from both tunnels, I see...

ctrujillo@magenta.cl has commented on DMVPN fast convergence with ebgp and capacity planning

1 year 9 months ago
Marcin, I paste the config of one of the spokes. It has only one physical wan...

ctrujillo@magenta.cl has commented on Tunning the GRE keepalive or the routing protocol timer for fast convergence?

1 year 9 months ago
Richard/Joseph,Our design is also dual hub and each spoke has a tunel to each...

ctrujillo@magenta.cl has created DMVPN fast convergence with ebgp and capacity planning

1 year 9 months ago
Hi.In a dual hub/dual dmvpn design, EBGP is running over the GRE DMVPN tunnel (...

ctrujillo@magenta.cl has created Tunning the GRE keepalive or the routing protocol timer for fast convergence?

1 year 9 months ago
Hi.In a design with a hub router with ~100 GRE/IPSEC tunnels (and still growing...

ctrujillo@magenta.cl has created IP event Dampening timers in XR and IOS

2 years 6 months ago
Hi,Comparing the IP event dampening default timers available in IOS and XR...

ctrujillo@magenta.cl has commented on ASR9000/XR: Migrating from IOS to IOS-XR a starting guide

2 years 8 months ago
Thanks xander, i think we will modify the existing design so we can use up to 4...

ctrujillo@magenta.cl has commented on ASR9000/XR: Migrating from IOS to IOS-XR a starting guide

2 years 8 months ago
Yeah spell checker in iPhone works fine ;) Are there plans in the future for...

ctrujillo@magenta.cl has commented on ASR9000/XR: Migrating from IOS to IOS-XR a starting guide

2 years 8 months ago
Thanks for your reply,So even if it let me configure 7 ospf process, once I...

ctrujillo@magenta.cl has commented on ASR9000/XR: Migrating from IOS to IOS-XR a starting guide

2 years 8 months ago
Hi xander,Regarding the number of ospf process, I can see a maximum of 10 ospf...

ctrujillo@magenta.cl has commented on Deployment with DWDM and ASR9000

2 years 9 months ago
Hi Xander, Do the asr9k platform has any type of restrictions regarding de...

ctrujillo@magenta.cl has commented on Deployment with DWDM and ASR9000

2 years 9 months ago
Hi Xander, Do the asr9k platform has any type of restrictions regarding de...

ctrujillo@magenta.cl has commented on Deployment with DWDM and ASR9000

3 years 2 days ago
Hi Xander, Actually Im having a similar scenario, our asr9k has a A9K-8T/4-L...

ctrujillo@magenta.cl has commented on Deployment with DWDM and ASR9000

3 years 2 days ago
Hi Xander, Actually Im having a similar scenario, our asr9k has a A9K-8T/4-L...

ctrujillo@magenta.cl has created NSR for targeted ldp sessions betwen pseudowire peers is not working

3 years 1 month ago
Hi.According to the following output, NSR is not "available" (N/A) for the...

ctrujillo@magenta.cl has commented on ASR9000/XR: Understanding QOS on the A9K platform, default marking behavior, troubleshooting

3 years 2 months ago
Thanks Xander, Just comparing the properties and understanding the differences...

ctrujillo@magenta.cl has commented on ASR9000/XR: Understanding QOS on the A9K platform, default marking behavior, troubleshooting

3 years 2 months ago
Thanks Xander, Just comparing the properties and understanding the differences...

ctrujillo@magenta.cl has commented on ASR9000/XR: Understanding QOS on the A9K platform, default marking behavior, troubleshooting

3 years 2 months ago
Hi Xander, Appreciate your help in understand the following scenario:The...

ctrujillo@magenta.cl has commented on ASR9000/XR: Understanding QOS on the A9K platform, default marking behavior, troubleshooting

3 years 2 months ago
Hi Xander, Appreciate your help in understand the following scenario:The...

ctrujillo@magenta.cl has commented on IOS-XR OSPFv2 Distribute-list with ACL

3 years 2 months ago
Hi, Dont have a lab yet, but according to the following link, it is possible to...

ctrujillo@magenta.cl has commented on IOS-XR OSPFv2 Distribute-list with ACL

3 years 2 months ago
Hi, Dont have a lab yet, but according to the following link, it is possible to...

ctrujillo@magenta.cl has created safe harbor for IOS XR? recommended version for ASR9000?

3 years 2 months ago
Hi, Now working in a new deployment of some ASR9010 at the edge (PE) of an SP...

ctrujillo@magenta.cl has created safe harbor for IOS XR? recommended version for ASR9000?

3 years 2 months ago
Hi, Now working in a new deployment of some ASR9010 at the edge (PE) of an SP...

ctrujillo@magenta.cl has commented on doubt about port asic in ws-X6704-10GE Linecard

3 years 2 months ago
For any odd reason, the info about the port asics of the last link appered...

ctrujillo@magenta.cl has created doubt about port asic in ws-X6704-10GE Linecard

3 years 2 months ago
Hi, Please can someone help me clarifying whats the correct # of port asic in...

ctrujillo@magenta.cl has commented on forwarding does not work if "label-allocation-mode per-vrf" is not set using BVI interfaces

3 years 4 months ago
Sample config interface BVI303 vrf Ga ipv4 address 192.168.201.82 255.255.255....

ctrujillo@magenta.cl has created forwarding does not work if "label-allocation-mode per-vrf" is not set using BVI interfaces

3 years 4 months ago
Appreciate your helps making me understand the use of the following command:...

ctrujillo@magenta.cl has commented on igmpv3 snooping in catalyst 4900M L2 only Switch

3 years 5 months ago
Appreciate your help Jon,Unfortunately the lab was made 2 hours ago, Right now...

ctrujillo@magenta.cl has commented on igmpv3 snooping in catalyst 4900M L2 only Switch

3 years 5 months ago
It does show nothing.4900A#show ip igmp snooping membership vlan 7014900A#show...

ctrujillo@magenta.cl has commented on igmpv3 snooping in catalyst 4900M L2 only Switch

3 years 5 months ago
Thanks John for your answer.Tried to enable  without succesfull results, Could...

ctrujillo@magenta.cl has commented on igmpv3 snooping in catalyst 4900M L2 only Switch

3 years 5 months ago
Forgot the last output that is showing nothing:4900A#show ip igmp snooping...

ctrujillo@magenta.cl has created igmpv3 snooping in catalyst 4900M L2 only Switch

3 years 5 months ago
Hi.Scenario:Host-A ----------- CATALYST 4900M -------------- Host-BHost A is...

ctrujillo@magenta.cl has commented on ASR9000/XR Using MST-AG (MST Access Gateway), MST and VPLS

3 years 7 months ago
Hi Xander,Very interesting your article Please, can you post an article about...

ctrujillo@magenta.cl has created show platform hardware capacity - % of processor memory consumption for linecard

4 years 1 month ago
Hi,I have a 7609 ROUTER with dual sup 720-3BXL. In slot 1 there is a WS-X6704-...

ctrujillo@magenta.cl has created cisco ACE - control load balancing based in known source ip address

4 years 1 month ago
Hi.I want to statically control which know client source IP address (/32) will...

ctrujillo@magenta.cl has created RHI ISSUE: Removed static routes in the FWSM still appearing in the SUP 720 routing table

4 years 7 months ago
Hi.I have a 6509-E SWITCH with a SUPERVISOR 720-10G and a FWSM configured with...

ctrujillo@magenta.cl has created Re: ACE 4710 Version A3(2.5) device manager cannot authenticate

5 years 3 weeks ago
Hi.After fighting a few hours with the ace and cisco documentation, I found in...

ctrujillo@magenta.cl has commented on ACE 4710 Version A3(2.5) device manager cannot authenticate

5 years 3 weeks ago
Hi.After fighting a few hours with the ace and cisco documentation, I found in...

ctrujillo@magenta.cl has created ACE 4710 Version A3(2.5) device manager cannot authenticate

5 years 3 weeks ago
Hi.Recently I updated an ACE appliance software from A3(2.3) to A3(2.5) version...

ctrujillo@magenta.cl has created Re: ACE 4710. Unable to clear ssh sessions

5 years 1 month ago
Hi Sean. Thanks for your answer.The software version is A3(2.3). The reason I...

ctrujillo@magenta.cl has commented on ACE 4710. Unable to clear ssh sessions

5 years 1 month ago
Hi Sean. Thanks for your answer.The software version is A3(2.3). The reason I...

ctrujillo@magenta.cl has created ACE 4710. Unable to clear ssh sessions

5 years 1 month ago
Hi.Once in the CLI of an ACE 4710, using the command "clear ssh session id" I...

ctrujillo@magenta.cl has created Different input/output power in a 6509-E with 2 6000W power supply configured in redundant mode

5 years 2 months ago
Hi.I noticed a system log in a 6509-E switch with 2 AC 6000W power supply...

Bio

CCIE x2 Service Provider/Routing and Switching # 21813










ctrujillo@magenta.cl's Stats

Points0
Discussion started 16
Answers marked as Correct 0
Endorsed 0
Content Rated 0