English
Scott Fella commented on Cannot reset to Factory Default Cisco 2504 WirelessController in Getting Started with Wireless 1 day ago

Option 5 when you break out.  See this link: https://supportforums.cisco.com/document/8941/how-...

Scott Fella commented on Cannot reset to Factory Default Cisco 2504 WirelessController in Getting Started with Wireless 1 day ago

The way you reset a controller is to console into the device and boot up the controller and then...

Scott Fella commented on No APs showing in Getting Started with Wireless 3 days ago

Just search for "open TAC case". This will get you started. http://www.cisco.com/public/...

Scott Fella commented on Cisco Mobility Express wlc in Getting Started with Wireless 4 days ago

If you do factory reset the AP, you will have to start over!  I just want to make sure you are...

Scott Fella commented on Cisco Mobility Express wlc in Getting Started with Wireless 4 days ago

Probably the wrong guide: The Mode button is used to reset the Access Point to factory defaults. To...

Scott Fella commented on Cisco Mobility Express wlc in Getting Started with Wireless 4 days ago

There is no password recovery. You will need to look at the Mobility Express guide to factory reset...

Scott Fella commented on No APs showing in Getting Started with Wireless 4 days ago

Take a look at this link: https://supportforums.cisco.com/discussion/13100806/1852i-mobility-expre...

Scott Fella commented on No APs showing in Getting Started with Wireless 4 days ago

Show us what you are seeing that is iffice extend.  When you boot up an AP that is mobility Express...

Scott Fella commented on No APs showing in Getting Started with Wireless 6 days ago

Post some screen shots or outputs so we can see. Are these brand new AP's by chance?  If the mode...

Scott Fella commented on RRM / DCA Not Doing Its Job...Please Help! in Getting Started with Wireless 1 week ago

Well we ran into an issue if rx-sop was set other than the default auto. That was a bug so we ended...

Scott Fella commented on RRM / DCA Not Doing Its Job...Please Help! in Getting Started with Wireless 1 week ago

Usually a bug. What code are you running and what model AP's.  -Scott  *** Please rate helpful...

Scott Fella commented on AP1832 configuration in Getting Started with Wireless 1 week ago

What is the full part number on the label of the AP that is failing or the show ver from the AP....

Scott Fella commented on Upgrading from WCS 7.0 to Prime 3.1 in Getting Started with Wireless 1 week ago

Prime 3.1 has higher requirements for the server. If you are going from WCS to Prime 3.1, your best...

Scott Fella commented on recommended number of Users per AP (AIR-CAP2602I-E-K9) in Security and Network Management 1 week ago

You can also download that from the GUI on the controller to a tftp or FTP. -Scott  *** Please rate...

Scott Fella commented on AP1832 configuration in Getting Started with Wireless 1 week ago

Not sure what code your running but look at this bug id: https://bst.cloudapps.cisco.com/bugsearch/...

Scott Fella commented on Converting the Cisco AIR-AP1572EAC-E-K9 to autonomous mode in Getting Started with Wireless 1 week ago

Boot up the AP and issue this command: capwap ap autonomous That should work for you. -Scott  ***...

Scott Fella commented on 3802e with AIR-ANT2566P4W-R in Getting Started with Wireless 1 week ago

Leo is right.  Take a look at the link for the "smart antenna" http://www.cisco.com/c/en/us/td/docs...

Scott Fella commented on Access Point not showing down in Getting Started with Wireless 1 week ago

Open a TAC case because I have never ever seen that happen. If you issue a show AP summary, that...

Scott Fella commented on Wireless Controller redundancy in Unknown due to incompatible software version - Bulk Sync Status Pending in Getting Started with Wireless 1 week ago

Just make sure that you know, when you upgrade the FUS, it can take up to 45 minutes, so I would...

Scott Fella commented on I would like to know differences between bellow mentioned SW for Cat 3850. in Getting Started with Wireless 1 week ago

It does.  We have a few in Russia and I'm able to ssh to the box. -Scott  *** Please rate helpful...

Scott Fella commented on AP1142 wont connect WLC 2504 in Getting Started with Wireless 1 week ago

Your AP has an autonomous code: C1140-K9W7-M and that is why it's not joining. You need to download...

Scott Fella commented on Access Point not showing down in Getting Started with Wireless 1 week ago

Please add more info or screen shots.  If an AP isn't joined because it's down, I have never seen...

Scott Fella commented on Wireless Controller redundancy in Unknown due to incompatible software version - Bulk Sync Status Pending in Getting Started with Wireless 1 week ago

Boot loader has nothing to do with this. You are not suppose to reboot one controller, but both.  ...

Scott Fella commented on Identify TKIP clients in Security and Network Management 1 week ago

You should be able to push this out through GPO is they are domain machines also. -Scott  ***...

Scott Fella commented on Identify TKIP clients in Security and Network Management 1 week ago

Here is my advice... you need to create a new wlan with the same SSID but the profile name...

Scott Fella commented on Wireless Controller redundancy in Unknown due to incompatible software version - Bulk Sync Status Pending in Getting Started with Wireless 1 week ago

With SSO, you can't reboot just one controller. Any mix match on the primary firmware will cause...

Scott Fella commented on Wireless design - stacking access point between floors in Getting Started with Wireless 1 week ago

It is always better to have a site survey performed. The reason for stacking in my opinion is when...

Scott Fella commented on Wireless failover with two WLC 5500s in different datacenters in Security and Network Management 2 weeks ago

Mobility groups are required when using N+1, however if an AP moves by chance to thenother...

Scott Fella commented on How can I view the number of devices connected to a single AP in Security and Network Management 2 weeks ago

If however you want to see historical data, then you need Prime Infrastructure. if you are on v8.1...

Scott Fella commented on How can I view the number of devices connected to a single AP in Security and Network Management 2 weeks ago

Show AP summary should work and also on the GUI under wireless. -Scott  *** Please rate helpful...

Scott Fella commented on Wireless failover with two WLC 5500s in different datacenters in Security and Network Management 2 weeks ago

That is correct if centrally switched. That is why you try to keep the pairs in the same L2.  ...

Scott Fella commented on Wireless failover with two WLC 5500s in different datacenters in Security and Network Management 2 weeks ago

So take a good look at your design and see if that works or not. How you design redundancy will...

Scott Fella commented on High Availability (AP SSO) 5508 WLC Licensing in Getting Started with Wireless 2 weeks ago

The only way is to look at your PO or the label on the box. If you don't have either, then call TAC...

Scott Fella commented on WLC intermittent connection of Users in Getting Started with Wireless 2 weeks ago

Tough to say.... look at the client drivers, make sure your firmware on the controller is not...

Scott Fella commented on Wireless failover with two WLC 5500s in different datacenters in Security and Network Management 2 weeks ago

This is why you must look at your design and understand what the "risk" are during a failover.  Not...

Scott Fella commented on High Availability (AP SSO) 5508 WLC Licensing in Getting Started with Wireless 2 weeks ago

An HA sku controller doesn't require any license. Only the primary in which the AP's will be joined...

Scott Fella commented on CISCO AP 1562i orientation in Ekahau in Getting Started with Wireless 2 weeks ago

Your best off asking your Cisco rep for future support. How it looks right now is that you answer...

Scott Fella commented on Cisco 1552C AP power Issue. in Getting Started with Wireless 2 weeks ago

What I'am asking is if your really wanted an outdoor AP with a cable modem?  You providing outdoor...

Scott Fella commented on security L2 problem in Cisco controller 5500 and ios iPhone and iPad not browsing internet in Security and Network Management 2 weeks ago

That's seems to be an issue with the code then.  Keep us updated if the upgrade does help. -Scott...

Scott Fella commented on security L2 problem in Cisco controller 5500 and ios iPhone and iPad not browsing internet in Security and Network Management 2 weeks ago

Zee is right... try an open SSID first and see if that works or not. Alsoninnoticed your code...

Scott Fella commented on Cisco 1552C AP power Issue. in Getting Started with Wireless 2 weeks ago

Just out of curiosity, is that the correct model you want?  Most get the "e" or the "I" models that...

Scott Fella commented on Switch based WLC are paritial success on inventory status in Security and Network Management 2 weeks ago

There are a few bugs on devices showing partial errors on a handful of different devices. The 3650...

Scott Fella commented on Switch based WLC are paritial success on inventory status in Security and Network Management 2 weeks ago

Make sure your Prime is compatible with the code your running on the switch: http://www.cisco.com/c...

Scott Fella commented on WLC WiFi - random disconnects on 5GHz in Getting Started with Wireless 3 weeks ago

Usually we see this when the client drivers are bad. Downgrading/upgrading fixes that issue in some...

Scott Fella commented on AIR-AP2802I-B-K9 doesn't register in Getting Started with Wireless 3 weeks ago

You have enough AP license on the controller?  Are the AP's on the same subnet as the WLC. As that...

Scott Fella commented on AIR-AP2802I-B-K9 doesn't register in Getting Started with Wireless 3 weeks ago

Register over the WAN?  Is the AP behind a NAT?  If so, you need to reference the OEAP guide. You...

Scott Fella commented on AIR-AP2802i-A-K9 cannot achieve POE full power went connected to cisco switch WS-C2960S-48FPS-L in Getting Started with Wireless 3 weeks ago

I don't know. Do you have a lot of PoE devices connected to that switch?  Maybe an issue with the...

Scott Fella commented on AIR-AP2802i-A-K9 cannot achieve POE full power went connected to cisco switch WS-C2960S-48FPS-L in Getting Started with Wireless 3 weeks ago

The WS-C2960S-24PS-L supports up to 12 ports on 802.3at.  Make sure CDP is enabled and look at the...

Scott Fella commented on 1830 Mobility express in Getting Started with Wireless 3 weeks ago

Make sure the client NIC drivers are up to date. That is usually the culprit and first thing to...

Scott Fella commented on AP without wireless Lan Cotroller in Getting Started with Wireless 3 weeks ago

You should be fine then. The only reason I bring up the subnets is if you want to separate...

Bio

Principal Consulting Engineer with over 10 years working with wireless technologies mainly on Cisco products with a few years experience in Aruba and Meraki technology. Focus on indoor wireless, outdoor bridge and mesh technology, routing and switching and wireless security which includes knowledge of various radius servers (Microsoft IAS & NPS, Cisco ACS and Cisco ISE.

• Cisco NetPro Designated VIP 2011, 2012, 2013, 2014, 2015
• Cisco Certified Network Associate (CCNA)
• Cisco Certified Design Associate (CCDA)
• Wireless LAN for System Engineer
• Wireless LAN for Field Engineers
• Advanced Wireless for System Engineers (AWLANSE)
• Advanced Wireless for Field Engineers (AWLANFE)
• Cisco Lifecycle Services Advanced Wireless
• Aruba Certified Mobility Professional, 2012
• CCIE Wireless Written

User Badges:
  • Badge.
    Super Silver
    17500 points or more
  • Badge.
    Hall of Fame

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Badge.
    Cisco Designated VIP

    2017 Wireless

  • Badge.
    Cisco Designated VIP

    2016 Wireless

  • Badge.
    Cisco Designated VIP

    2015 Wireless

  • Badge.
    Cisco Designated VIP

    2014 Wireless

  • Badge.
    Cisco Designated VIP

    2013 Wireless

  • Badge.
    Cisco Designated VIP

    2012 Wireless

  • Badge.
    Cisco Designated VIP

    2011 Wireless

Scott Fella's Stats

Discussion started
Answers marked as Correct
Endorsed
Content Rated