fuhrersk8

Member Since: Jun 20, 2011

User Badges:

English
fuhrersk8 commented on Catalyst 6800IA electrical grounding in LAN, Switching and Routing 2 days ago

Excellent. Thanks for the information. Regards, 

fuhrersk8 commented on Nexus N5K-5672UP hardware failure in LAN, Switching and Routing 5 days ago

Ok. Basically its just to copy/paste the damaged siwtch config into the new one. Do you recommend...

fuhrersk8 commented on Nexus N5K-5672UP hardware failure in LAN, Switching and Routing 5 days ago

Excellent. Which should be those few commands? Thanks again. Regards,

fuhrersk8 commented on Nexus N5K-5672UP hardware failure in LAN, Switching and Routing 5 days ago

Hello Reza;      Will the new switch accept the FEX's interfaces configuration by just copy/paste...

fuhrersk8 commented on Nexus N5K-5672UP hardware failure in LAN, Switching and Routing 6 days ago

Hi Reza and thanks for your reply; What are the commands for pre-provisioning the FEX's? If there...

fuhrersk8 commented on Nexus Fex Offline When Pre-Provisioning in LAN, Switching and Routing 6 days ago

Hi Reza and thanks for your reply; What are the commands for pre-provisioning the FEX's?

fuhrersk8 commented on VTP version 3 to VTP version 1 change in LAN, Switching and Routing 8 months ago

Understand. My trunks are in desirable non-silent mode. One question, why the access switches were...

fuhrersk8 commented on VTP version 3 to VTP version 1 change in LAN, Switching and Routing 8 months ago

Hello;    I was able to revert to version 1 with no reload necessary as explained. But we had the...

fuhrersk8 commented on VTP version 3 to VTP version 1 change in LAN, Switching and Routing 8 months ago

Excellent. Thanks for your reply. Regards,

fuhrersk8 commented on DHCP not working for Masterclock NTDS44 when connected to 2960S/3560-X switches in LAN, Switching and Routing 8 months ago

Hi and thanks for your reply;       We managed to get it working by disabling/enabling spanning-...

fuhrersk8 commented on ACS 5.8.0.32 not matching Active Directory Authorization Rules for TACACS after upgrade from 5.6 in AAA, Identity and NAC 11 months ago

Hi;    In my case, the AD administrator actually didn't execute the command as stated by Cisco TAC...

fuhrersk8 commented on ACS 5.8.0.32 not matching Active Directory Authorization Rules for TACACS after upgrade from 5.6 in AAA, Identity and NAC 11 months ago

Hi;    Below solution as explained by Cisco TAC: "As you can see the Ability to read tokenGroups...

fuhrersk8 commented on ACS 5.8.0.32 not matching Active Directory Authorization Rules for TACACS after upgrade from 5.6 in AAA, Identity and NAC 1 year ago

Hi Priya and thanks for your support;     Did as you mentioned, but same result.  Thanks again....

fuhrersk8 commented on ACS 5.8.0.32 not matching Active Directory Authorization Rules for TACACS after upgrade from 5.6 in AAA, Identity and NAC 1 year ago

Hi;   Attached more information. Thanks for your support. Regards, 

fuhrersk8 commented on ACS 5.8.0.32 not matching Active Directory Authorization Rules for TACACS after upgrade from 5.6 in AAA, Identity and NAC 1 year ago

Hi;    Basically, I deleted and recreated the AD rules, but still no authorization is being allowed...

fuhrersk8 commented on ACS 5.8.0.32 not matching Active Directory Authorization Rules for TACACS after upgrade from 5.6 in AAA, Identity and NAC 1 year ago

Hello and thanks for the information. I am using Mozilla Firefox 43.0.4.  What does resubmiting...

fuhrersk8 commented on ACS 5.8.0.32 not matching Active Directory Authorization Rules for TACACS after upgrade from 5.6 in AAA, Identity and NAC 1 year ago

Hello;    Not even the ACS admin authorization rule is working. It was working on previous version...

fuhrersk8 commented on ACS 5.8.0.32 not matching Active Directory Authorization Rules for TACACS after upgrade from 5.6 in AAA, Identity and NAC 1 year ago

Hi and thanks for your reply;    It was disabled. I proceeded to enabled it, but same result. The...

fuhrersk8 commented on Management interface IP Address change in 5508 WLC cluster in Other Wireless - Mobility Subjects 1 year ago

Excellent. Thanks for your support.  Regards, 

fuhrersk8 commented on Management interface IP Address change in 5508 WLC cluster in Other Wireless - Mobility Subjects 1 year ago

Hello Manish and thanks for your reply;     WLC version is 7.6.120.0 and currently it would not...

fuhrersk8 commented on Re-Adding a secondary WLC to an existing active primary WLC in Getting Started with Wireless 2 years ago

Hello and thanks for your reply; That is what documentation says but it is not my actual scenario. ...

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

Hello;   Yes. Follow step by step. Regards,

fuhrersk8 commented on Upgrade to ACS 5.4 and license in AAA, Identity and NAC 2 years ago

Hello;   You will need quantity of two (2) base licenses (CSACS-5-BASE-LIC) for primary and...

fuhrersk8 commented on Upgrade to ACS 5.4 and license in AAA, Identity and NAC 2 years ago

Excellent. Thanks for your great support. 

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

  Switch ID is independent of operational state. 

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

Hello;   Correct. It was Primary. After receiving the new Sup720, (RMA from Cisco), we installed it...

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

Hello;    Switch 1 was powered off. 

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

Hello;   Yes. Follow the document as it is. Once you force the switchover, your supervisor should...

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

Hello   Yes. It worked as intended. No interruption in the Active VSS switch. I replaced Supervisor...

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

Excellent. Thanks for your support. 

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

Excellent. Thanks for your reply. In my scenario, the priorities are default (100), is this the...

fuhrersk8 commented on Replace Supervisor Module in Cisco Catalyst 6500 VSS 1440 in LAN, Switching and Routing 2 years ago

Hello and thanks for your reply;   But at that point, still the new supervisor (switch) is not in...

fuhrersk8 commented on Limiting access points joining a specific WLC in Other Wireless - Mobility Subjects 2 years ago

Excellent. Thanks for the information.

fuhrersk8 commented on Limiting access points joining a specific WLC in Other Wireless - Mobility Subjects 2 years ago

Hello Rasika and thanks for your reply;  Yes; I am trying to deny the IP address segment instead of...

fuhrersk8 commented on Cisco ASA 55XX Transparent mode VLAN traversing in Firewalling 2 years ago

   Excellent. Thanks a lot for the great information!   In my case, since I have same VLAN ID's...

fuhrersk8 commented on Port-channel through Cisco ASA in transparent mode in LAN, Switching and Routing 2 years ago

Hello Reza and thanks for your reply;  The ASA version is 7.x if I am not mistaken. Excellent...

fuhrersk8 commented on Switches and Routers CDP neighbours on Cisco Prime Infrastructure 2.0 in Network Management 2 years ago

   Hello Afroz and thanks for your reply. I am looking for the CDP neighbours list of each device....

fuhrersk8 commented on Nexus 2248TP port speed and duplexing in LAN, Switching and Routing 2 years ago

Hello and thanks for reply;      I was trying to configure port speed and duplexing on a 2148. This...

fuhrersk8 commented on Nexus 5548UP vPC fex interfaces configuration in Server Networking 2 years ago

Excellent guys. Thanks for your reply and support.

fuhrersk8 commented on Nexus 5548UP vPC fex interfaces configuration in Server Networking 2 years ago

Hello Arvind and thanks for reply;   For ICMP tests, the L3 gateway is the VSS. 

fuhrersk8 commented on Nexus 5548 fex interface configuration in vPC scenario in LAN, Switching and Routing 2 years ago

Excellent. Thanks again for your great support!

fuhrersk8 commented on Nexus 5548 fex interface configuration in vPC scenario in LAN, Switching and Routing 2 years ago

  One clarification, I am reffering to FEXes host interfaces, for example interface Ethernet101...

fuhrersk8 commented on Nexus 5548 fex interface configuration in vPC scenario in LAN, Switching and Routing 2 years ago

   Excellent and thanks for your reply Reza!   Regards,

fuhrersk8 commented on vPC and VSS port-channel uplinks in Unified Computing 2 years ago

 Hello Steve and thanks for your reply;   I configured one port-channel on the VSS with the four up...

fuhrersk8 commented on AP downgrade when joining WLC in Other Wireless - Mobility Subjects 3 years ago

Excellent and thanks for the great information and support!

fuhrersk8 commented on Catalyst 6500 VSS member stuck in rommon after a reload in LAN, Switching and Routing 3 years ago

Hello guys; just an update: i set the bootflash to the ios version, set config register to x2102...

fuhrersk8 commented on Catalyst 6500 VSS member stuck in rommon after a reload in LAN, Switching and Routing 3 years ago

Hello Reza and thanks for your reply; Setting the bootflash to the current ios software in the...

fuhrersk8 commented on Catalyst 6500 VSS member stuck in rommon after a reload in LAN, Switching and Routing 3 years ago

Hello and thanks for your reply;    Do you mean upgrading to a newer iOS? The problem is that the...

Bio

User Badges:

fuhrersk8's Stats

Points20
Discussion started 119
Answers marked as Correct 0
Endorsed 0
Content Rated 104