gerald.suiza

Member Since: Feb 03, 2011

English
gerald.suiza commented on 4948 2x10G Etherchannel in LAN, Switching and Routing 4 years ago

hi,Thanks for the fast reply..would you know if there is any additional config or is it just the...

gerald.suiza commented on Set up trunk between ESXi 4.1 NICs and Cisco 3550 switch Ports in LAN, Switching and Routing 5 years ago

ESX does not support LACP. You will need to configure your portchannel to "mode on". Here is a...

gerald.suiza commented on Unknown Protocol Drops incremented frequently on router's FastEthernet Interfaces in WAN, Routing and Switching 5 years ago

do the unkown protocol drops increment by "1" every time you do a show interface? if it does it...

gerald.suiza commented on HSRP & BGP Behaviour in WAN, Routing and Switching 5 years ago

personally i would go L3. once configured correctly it will work flawlessly.

gerald.suiza commented on 50mbps flows only? in WAN, Routing and Switching 5 years ago

actually its not that strange..the service provider could have inadvertently done some...

gerald.suiza commented on HSRP & BGP Behaviour in WAN, Routing and Switching 5 years ago

pre-pending will take make an AS path to a peer longer which will be less preferred. so if you pre...

gerald.suiza commented on boot Cisco 4503-E switch from secondary image in LAN, Switching and Routing 5 years ago

use this to specify the boot image location:boot system flash bootflash: [image name]

gerald.suiza commented on Strange ICMP issue across WAN in WAN, Routing and Switching 5 years ago

try and source your ping on the router from the LAN segment subnet

gerald.suiza commented on Etherchannel Interfaces in suspend mode in WAN, Routing and Switching 5 years ago

I would also make sure what the HP blade protocol is for NIC teaming or else the config wont work...

gerald.suiza commented on BGP peering flaps frequently and comes up in few minutes in WAN, Routing and Switching 5 years ago

have you checked layer 1? i would check layer 1 first instead of looking at BGP

gerald.suiza commented on Clocking for Two T-1s in WAN, Routing and Switching 5 years ago

i would not ignore that you have two carriers since the carriers have different clock sources and...

gerald.suiza commented on Clocking for Two T-1s in WAN, Routing and Switching 5 years ago

can you post the output of sh controllers? you can also try to set the clock to independent if the...

gerald.suiza commented on Policy Map Not Marking packets in WAN, Routing and Switching 5 years ago

did you check hits on your acl VOICE-OUT incrementing during, before and after the call?

gerald.suiza commented on Input errors/packet loss on intersite ethernet link in LAN, Switching and Routing 5 years ago

hmm...as i remember huawei is a bit flaky and has compatibility issues...did you have the service...

gerald.suiza commented on Input errors/packet loss on intersite ethernet link in LAN, Switching and Routing 5 years ago

try hardcoding you interface and have your service provider hardcode theirs..it maybe irrelevant...

gerald.suiza commented on Anyone find a tablet, Ipad, Cius, Android based, otherwise that works with console? in Other Network Infrastructure Subjects 5 years ago

this is amazing...i hope you guys develop something for android and windows 7

gerald.suiza commented on 2 MPLS links on same router acting ac Primary/Secondary in WAN, Routing and Switching 5 years ago

i would talk to my service provider and ask them what options you have to influence traffic...

gerald.suiza commented on Load Sharing with the Loopback Address as a BGP Neighbor - BGP session down in WAN, Routing and Switching 5 years ago

the interface output is strange:#sh int po7/2POS7/2 is administratively down, line...

gerald.suiza commented on Load Sharing with the Loopback Address as a BGP Neighbor - BGP session down in WAN, Routing and Switching 5 years ago

as far as i can remember cflow is similar to netflow and also should not affect traffic..

gerald.suiza commented on Load Sharing with the Loopback Address as a BGP Neighbor - BGP session down in WAN, Routing and Switching 5 years ago

this is what that filter does:By default, unicast RPF uses strict mode. Unicast RPF loose mode is...

gerald.suiza commented on Load Sharing with the Loopback Address as a BGP Neighbor - BGP session down in WAN, Routing and Switching 5 years ago

i would also do a debug on the Juniper..i have seen things on a Juniper that are not so pretty.....

gerald.suiza commented on Best Telco Stories in Cisco Cafe 5 years ago

..you been punkd!!

gerald.suiza commented on Weird log on my Internet Router in WAN, Routing and Switching 5 years ago

it came from the error message decoder on the cisco support page..not sure though if you set up an...

gerald.suiza commented on Which device can covert NxT1 into Ethernet? in WAN, Routing and Switching 5 years ago

are you looking for something similar to this?http://www.blackbox.com/Store/Detail.aspx/1-Port-T1-...

gerald.suiza commented on Congestion throughout entire switch in LAN, Switching and Routing 5 years ago

hmm...interface fa1/0/1 is the user port isn't it?...where is the database server connected to? is...

gerald.suiza commented on Best practices before maintenance Catalyst 6000 shutdown in LAN, Switching and Routing 5 years ago

to add to what leo posted..if you have access to dowload IOS images i would get the MD5 checksum...

gerald.suiza commented on Cisco 1941 routers with VWIC2 1MFT-T1 on T1 in WAN, Routing and Switching 5 years ago

hmm..why does your loopbacks have the same ip address as your serials? and are you sure you want...

gerald.suiza commented on Can't view WIC-1DSU-T1-V2 card to troubleshoot in WAN, Routing and Switching 5 years ago

i believe that wic has a service module..you should be able to do a show service-module [interface...

gerald.suiza commented on Weird log on my Internet Router in WAN, Routing and Switching 5 years ago

here's what it means:1. %FW-4-RESPONDER_ZERO_WND_SCALE_FACTOR_INI_NO_SCALE: Accepting packet -...

gerald.suiza commented on 3750G span sessions configuration (limits) in LAN, Switching and Routing 5 years ago

the 3750 can only accomodate 2 SPAN sessionsSee this link:http://www.cisco.com/en/US/products/hw/...

gerald.suiza commented on E1 multilink in WAN, Routing and Switching 5 years ago

that is a good observation of the config but it is no useful to put only one interface into a...

gerald.suiza commented on Dot1x issues in AAA, Identity and NAC 5 years ago

i think you shoudl have this configured : dot1x port-control auto

gerald.suiza commented on Latency problem on ATM interface on Cisco 3825 in LAN, Switching and Routing 5 years ago

what is the bandwidth of your circuit and what is the utilization? you have to bear in mind that...

gerald.suiza commented on limit bandwidth between two routers with QoS in LAN, Switching and Routing 5 years ago

that statement drops the packet since the action is "drop"

gerald.suiza commented on Core Router crashing! in WAN, Routing and Switching 5 years ago

i'd have TAC take a look at this.. I ran into something similar in the past, same router platform...

gerald.suiza commented on Core Router crashing! in WAN, Routing and Switching 5 years ago

hmm...looks like the router is being hammered..is the CPU high throughout the day or only at...

gerald.suiza commented on Core network comparison with collapsed core in LAN, Switching and Routing 5 years ago

another thing is the server side is on NIC teaming but the switch side isn't on an etherchannel.....

gerald.suiza commented on authentication mac-move permit with NAC in Other Security Subjects 5 years ago

anyone run into this before?

gerald.suiza commented on Limit of T1s in Channel Group in WAN, Routing and Switching 5 years ago

yo are correct max is 8 but i would go with the suggestions of the others that replied on a cost...

gerald.suiza commented on HWIC-4ESW compatible with C1921 in LAN, Switching and Routing 5 years ago

according to this it is supported:http://www.cisco.com/en/US/prod/collateral/voicesw/ps6789/ps7290...

gerald.suiza commented on password mismach in LAN, Switching and Routing 5 years ago

when you do a write erase and save you wipe out the entire config. you should be able to access...

gerald.suiza commented on Does the cmd "ip virtual reassembly" cause any impact in Internet Multihoming scenario ? in WAN, Routing and Switching 5 years ago

from what I understand NAT automatically enables VFR if NAT is enabled...does the message happen...

gerald.suiza commented on nm vs. hwic in WAN, Routing and Switching 5 years ago

an hwic can go into an NM...

gerald.suiza commented on Cable for an HWIC-1T in LAN, Switching and Routing 5 years ago

the HWIC uses smart serial connectors to the WIC. the cable you mentioned uses DB60 and DB15...

gerald.suiza commented on Does the cmd "ip virtual reassembly" cause any impact in Internet Multihoming scenario ? in WAN, Routing and Switching 5 years ago

from what I understand NAT automatically enables VFR if NAT is enabled...does the message happen...

gerald.suiza commented on ISP latency in WAN, Routing and Switching 5 years ago

what i would do is trace to a public IP like 4.2.2.2 for example and see where the latency shoots...

gerald.suiza commented on Route-map deny statements with denying access-lists in LAN, Switching and Routing 5 years ago

here's how route-maps work:lets take your route map for example. you have a deny on your route map...

gerald.suiza commented on Cisco Live 2011 in Other Network Infrastructure Subjects 5 years ago

soup#5 is the best!!..

Bio

Been a Network Engineer for 10 years. I worked for a major Service Provider in the United States for 3 years










gerald.suiza's Stats

Points78
Discussion started 9
Answers marked as Correct 5
Endorsed 0
Content Rated 24