Daniele Giordano

Member Since: Feb 23, 2005

English
Daniele Giordano commented on [SOLVED] PGW 2200 and Call Diversion Restriction Indicator (bit M) in Voice over IP 1 week ago

Consider that PGW is in EoS/EoL but according to official documentation you can cantact Cisco TAC...

Daniele Giordano commented on [SOLVED] PGW 2200 and Call Diversion Restriction Indicator (bit M) in Voice over IP 1 week ago

The fix is for version 9.8(1). To install the fix you must stop the service and replace the files,...

Daniele Giordano commented on AS5400XM | Internal hair pinning calls SIP to PRI to SIP configurations in Voice over IP 2 weeks ago

Hi. For my experience, if you need to use DSP, the only way is the E1 loop as you described. I used...

Daniele Giordano commented on [SOLVED] PGW 2200 and Call Diversion Restriction Indicator (bit M) in Voice over IP 2 weeks ago

Hi, yes I've the fix but it's customized for italian Q767 version. Do you use this SS7 variant?...

Daniele Giordano commented on SIP calls on a as5400 and a fully loaded as5850 set up to do 4DS3 TDM traffic. I in Voice over IP 2 weeks ago

The AS5400 can handle up to 16E1 so can handle 16x31=496 TDM to IP calls (or vice versa). If you...

Daniele Giordano commented on VoIP to cell phone "loud noise" issue in Voice over IP 3 months ago

Try to force a voice codec, e.g. G.711, disable comfort-noise, disable silence suppression, update...

Daniele Giordano commented on (temporary failure (41)) in Voice over IP 3 months ago

What signalling protocol do you have implemented in your config?If it SIP, please add the output of...

Daniele Giordano commented on PGW 2200 EoL in Voice over IP 4 months ago

Italtel iVLS is an alternative of PGW. Italtel works with Cisco from many years and it's controlled...

Daniele Giordano commented on AS5400XM open port range in Voice over IP 7 months ago

Hi, you can check the the list of open ports on your AS with the command show control-...

Daniele Giordano commented on ATA 190 - Cannot Dial 4 Digit Extension in IP Telephony 7 months ago

Hi, in your ATA<MAC>.cnf.xml file you have specified this dialplan: <dialTemplate>...

Daniele Giordano commented on High CPU utilization on 7206VXR NPE-G2 due to interrupts in WAN, Routing and Switching 7 months ago

A profiling CPU output: router#show profile tersePROF A3D4 3043DFF 4PROFSKIP 2A9E54 0 0 0 0 0 0 1...

Daniele Giordano commented on High CPU utilization on 7206VXR NPE-G2 due to interrupts in WAN, Routing and Switching 7 months ago

I noticed also a strange 4ms Timer Interrupt in show stacks. router#sh stacks ...

Daniele Giordano commented on CPU process utilization is 90% with no process consuming more than 1% in WAN, Routing and Switching 7 months ago

Hi Experts, same situation, same issue. Do you have found a solution? C7206VXR with NPE-G2 with...

Daniele Giordano commented on High CPU utilization on 7206VXR NPE-G2 due to interrupts in WAN, Routing and Switching 7 months ago

Hi again.I tried the IOS c7200p-adventerprisek9-mz.122-33.SRE2 also but the cpu load is practically...

Daniele Giordano commented on QoS for Voice in Voice over IP 9 months ago

Hi, your class map doesn't mark voip traffic but it uses the existing one. If you want remark or...

Daniele Giordano commented on How to enable h323-remote-address in RADIUS Accounting Start messages? in Voice over IP 9 months ago

Hi Alan, do you have already check these commands: aaa accounting connection h323 To define the...

Daniele Giordano commented on Cisco 2431-16 Voltage Issues in Voice over IP 1 year ago

Hi, do you have already try alt-battery-feed feed4?See also:https://supportforums.cisco.com/...

Daniele Giordano commented on CUBE Incoming call with Alphanumeric field TO problem in Voice over IP 1 year ago

Hi, Do you have already tried a voice translation rule?Something like this:voice translation-rule...

Daniele Giordano commented on DTMF issue on UC560! in Voice over IP 1 year ago

Hi, do you have already tried to change the DTMF on-off time on your Quintum gateway?E.g. 140 or...

Daniele Giordano commented on Connecting FAX to PSTN line using FXS and FXO ports in Voice over IP 1 year ago

In your voice class codec 10 there aren't any codecs declared.Add G.711 codec in this way:voice...

Daniele Giordano commented on Cisco CUBE Reason: Q.850;cause=65 in Voice over IP 1 year ago

Cause 65: bearer capability not implemented. Probably there is a codec negotiation issue.As...

Daniele Giordano commented on How to snoop traffic on PGW 2200 with Wireshark in Voice over IP 1 year ago

I hope to have understood correctly your question.1) enable the snoop on PGW using ./snoop_scrip in...

Daniele Giordano commented on ATA with fax HP LaserJet MFP M880z in Other Collaboration, Voice, and Video Subjects 2 years ago

You can try to download HP LaserJet MFP M880z manual and set ECM and fax speed in this way:- ECM (...

Daniele Giordano commented on Noise between last digit dialed and first ringback in Other Collaboration, Voice, and Video Subjects 2 years ago

Hi, I had the same issue with 2800 series router. In my case was an IOS problem and was fixed with...

Daniele Giordano commented on noise/hissing problem before ring-back-tone in Voice over IP 2 years ago

Hi, I had the same issue with 2800 series router. In my case was an IOS problem and was fixed with...

Daniele Giordano commented on Media flow-around problem when the codec is changed to t38 in Video Over IP 2 years ago

Hi. Do you have try to disable h245 tunnel?voice service voip  h323  h245 tunnel disable Regards.

Daniele Giordano commented on configuring pstn trunk for multiples dial-peers in Voice over IP 2 years ago

Hi, no way with FXS line. You must have at least an ISDN BRI or an E&M trunk.If you don't have...

Daniele Giordano commented on how to disable DSP c5510 [FIXED] in IP Telephony 2 years ago

Hi Aman, this is the command used:C2811_CC#test dsp device 0 1 ?  dspware  Download flash file...

Daniele Giordano commented on how to disable DSP c5510 [FIXED] in IP Telephony 2 years ago

Hi Aman, this is the option list of test voice driver: C2811_CC#test voice driverEnter VPM or HDV...

Daniele Giordano commented on how to disable DSP c5510 [FIXED] in IP Telephony 2 years ago

Hi, I found the right way.In order to disable a C5510 dsp, we must use the command "test dsp device...

Daniele Giordano commented on how to disable DSP c5510 [FIXED] in IP Telephony 2 years ago

Do you mean reload the router or reset the dsp?I want disable the second dsp because every calls...

Daniele Giordano commented on how to disable DSP c5510 [FIXED] in IP Telephony 2 years ago

Hi Aman, the option 4 CHPIR Enable/Disable works like a reset, it doesn't disable the dsp: C2811_CC...

Daniele Giordano commented on fax configuration on as5350 in Voice over IP 2 years ago

Hi, if T.38 is not a must, try to disable it. Fax passthrough has less interop issues.dial-peer...

Daniele Giordano commented on SIP Config Help in IP Telephony 2 years ago

Try to add this:voice hunt-group 1 parallel list 1001,1002 pilot 2000voice translation-rule 10 rule...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi jwood, in your log you can see a call destinatated to "INVITE sip:17852465184" but you don't...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi, try with a voice translation rule as explained in a prevoisu post. Regards.

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi.   1. In your outgoing SIP INVITE the From header is anonymous but the PAI not: From: "...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

From the debug you can see that the cisco router receives this ID request: RX <- IDREQ ri=...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi. Can you post a new debug using "debug ccsip message" and "debug isdn q931"? Regards.

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi.In first and second cases you don't get a busy tone but a ringing tone.In SIP, the busy state is...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi. About CLIR, I'm not sure, but you can try to configre a dial-peer like this: dial-peer voice...

Daniele Giordano commented on destination-pattern T in Voice over IP 2 years ago

Hi. See here:http://www.cisco.com/c/en/us/td/docs/ios/12_2/voice/configuration/guide/... Fixed- and...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi.#31# is an ETSI (European Telecommunications Standard Institute) service code to set "per call...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi, the 403 Forbidden is provided by orange because in your outgoing INVITE the P-Asserted ID is...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi.QUESTIONS and ANSWERS1. (D) +421906200201 also registers, what is wrong,...

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi, the config is OK. If you want modify the P-Asserted-ID in the BYE request you must add a new...

Daniele Giordano commented on SPA112 crash after SRV enabled in ATAs, Gateways and Accessories 2 years ago

Hi. You can find contacts here: http://www.cisco.com/c/en/us/support/web/tsd-cisco-small-business-...

Daniele Giordano commented on SRP520 Series SPC Compiler Tool in Small Business Routers 2 years ago

I never find an SPC compiler for SRP.I've downloaded the XML config from a router using this URL:...

Daniele Giordano commented on SPA112 crash after SRV enabled in ATAs, Gateways and Accessories 2 years ago

The best way is contact STAC and open a case.Regards.

Daniele Giordano commented on Problem with registration Cisco 2801 as SIP gateway with SIP server in Voice over IP 2 years ago

Hi.All outgoing calls from the "second phone" are rejected by orange with a "SIP/2.0 403 Forbidden...

Bio










  • Community Spotlight Award

    Small Business January 2014





  • Community Spotlight Award

    Small Business August 2013





  • Community Spotlight Award

    Small Business March 2012









Daniele Giordano's Stats

Points929
Discussion started 28
Answers marked as Correct 113
Endorsed 5
Content Rated 17