George Stefanick

Member Since: Apr 24, 2005

English
George Stefanick's Activity on Cisco Support Community
Currently displaying 50 results

George Stefanick has commented on High Channel utilization but no RX or TX utilisation

2 days 3 hours ago
Wow thanks ! 

George Stefanick has commented on High Channel utilization but no RX or TX utilisation

2 days 3 hours ago
If you found this helpful please consider rating helpful post ! Thanks ! 

George Stefanick has commented on High Channel utilization but no RX or TX utilisation

2 days 3 hours ago
Yup ! 12 PHY. Don't mess with anything higher .. I've had a lot of success...

George Stefanick has commented on High Channel utilization but no RX or TX utilisation

2 days 3 hours ago
It's my advice if your deisgn can support higher rates you should disabled...

George Stefanick has commented on 1.1.1.1 owned by asia pacific

2 days 4 hours ago
It really not what Cisco is going to do. You can use any IP address you like....

George Stefanick has commented on High Channel utilization but no RX or TX utilisation

2 days 22 hours ago
Hello  under the wirlees tab on the WLC. Left hand side you will see...

George Stefanick has commented on why the 5 Ghz , its free and do not need any license while the 2.4Ghz requires License

6 days 5 hours ago
The bands 900,2.4 and 5 are unlicensed. Many of the other frequncys are...

George Stefanick has commented on why the 5 Ghz , its free and do not need any license while the 2.4Ghz requires License

6 days 7 hours ago
Both are unlicensed .. 

George Stefanick has commented on RF Channel Assignment

6 days 22 hours ago
Why 80 wide ? In my testing I didn't see a lot of gain .. 

George Stefanick has commented on WCL 5508

1 week 43 min ago
That is older code. What APs are you try to join.  APs find the...

George Stefanick has commented on 1852i AP not getting full power on Etherswitch POE module or Power Injector

1 week 50 min ago
What version of code is your WLC on?

George Stefanick has commented on Wireless Signal but can not connect to Wireless Network

1 week 51 min ago
To add to what Tim mentioned..... Unwrap the onion. Get a device connected...

George Stefanick has commented on IT operation Assistant

1 week 21 hours ago
Hello, If you are on newer code you should not have any issues. 

George Stefanick has commented on Antenna Lightning Arrestor needed for outdoor Ap 1552 and 1572

1 week 1 day ago
Correct, only if you add cable. Frankly if there is a strike in the general...

George Stefanick has commented on Flexconnect AP Assistance

1 week 4 days ago
If I understand your question. I think you might achieve this with vlan based...

George Stefanick has commented on CUWN Design Question

1 week 4 days ago
Hi Chris, Flex has come a long way since the days of old. I was going to...

George Stefanick has commented on Roaming issues - Samsung Galaxy Xcover 2 and 3 - WLC 5500 - SW 8.1.131.0

2 weeks 3 days ago
The challenge with these devices is vendor support and drivers. Hard to say...

George Stefanick has commented on Roaming issues - Samsung Galaxy Xcover 2 and 3 - WLC 5500 - SW 8.1.131.0

2 weeks 3 days ago
Is it only these devices ? If so sounds like a client issue. Did you attempt to...

George Stefanick has commented on Power level of Access point

2 weeks 4 days ago
Old post live on :).  The 3700/3800 changes a good bit of what  ...

George Stefanick has commented on power level in 3702 and other ap's

2 weeks 5 days ago
Great question. I actually asked this with Cisco and other vendors. You might...

George Stefanick has commented on Meraki Wireless Authentication

4 weeks 8 hours ago
Afraid not. Your wireless clients supplicants use 802.1X as a frame work to...

George Stefanick has commented on How to programmatically access Probe request (802.11) on the wireless router or access point

4 weeks 8 hours ago
Not sure I understand it seems like you want to see probes on your device ?...

George Stefanick has commented on Radio (A) is showing not supported

1 month 3 days ago
Good find Leo.. 

George Stefanick has commented on Radio (A) is showing not supported

1 month 3 days ago
Is your 5 GHz network enabled ? See below [[{"fid":"1288126","view_mode...

George Stefanick has commented on Join Multiple Domain-AP in wireless controller version 8.2 with mesh environment

1 month 3 days ago
Is that right .. I did not know this ... 

George Stefanick has commented on Recommended WLC 2504 SSID setup with AD

1 month 3 days ago
Hey Tibor, Did that work? You good?

George Stefanick has commented on Multiple SSIDs Switch Config

1 month 3 days ago
You might want to get started with this .. http://www.cisco.com/c/en/us/...

George Stefanick has commented on Air-CAP1552E-A-K9 AP reset to factory default

1 month 3 days ago
When you console in to the AP did you do:  clear capwap private-config

George Stefanick has commented on Cisco WLC2504 - Specify band per SSID. Possible?

1 month 3 days ago
See below .. [[{"fid":"1288116","view_mode":"default","fields":{"format":"...

George Stefanick has commented on latency during video meetings

1 month 3 days ago
I wish I could day click here and click there and sprinkle a little pixie dust...

George Stefanick has commented on Radio0-802.11N2.4GHz Radio1-802.11AC5GHz

1 month 3 days ago
Yea could be many things.. Share the AP config. Also is your WLAN broadcasting...

George Stefanick has commented on DCHP not passing on to AP Clients

1 month 3 days ago
I would sniff it bro. Thats the next logical think to do. Mirror the port to...

George Stefanick has commented on Hotel Wifi Solution

1 month 3 days ago
I agree the 2504 is an option you might consider. I worry about the overall...

George Stefanick has commented on How to retrieve RSSI values of all connected devices to my wlan router

1 month 3 days ago
I know there are API available but I never went deep into it.  A few...

George Stefanick has commented on Wireless issues with Cisco 1600 AP and 2504 controller

1 month 4 days ago
What client are you using to test with ? Intel has UAPSD comparability issues....

George Stefanick has commented on Zap performance testing tool

1 month 4 days ago
Actually the are much different. IPfer does an average of time a bandwidth. Zap...

George Stefanick has commented on WLC 5508/Prime/Microsoft NPS (Radius) Connectivity issues

1 month 6 days ago
Do you have a client debug while the behavior happens ? I assume the issue is...

George Stefanick has commented on Cisco Aironet AP 2700 Series (Autonomuos Mode / Standalone Configuration)

1 month 6 days ago
What radio (frequency) did you configure on the ap and on the client. post your...

George Stefanick has commented on tacacs+ server command configuration

1 month 6 days ago
hello! You might want to post this on the switch / security forums.

George Stefanick has commented on Cisco AnyConnect slow speeds on MacBook Air

1 month 6 days ago
I agree with Philip.  Compare your download performance on and off VPN...

George Stefanick has commented on DCHP not passing on to AP Clients

1 month 6 days ago
Do this take the ap off the port make it an access point for vlan 208 and see...

George Stefanick has commented on Multiple SSID with Multiple AAA Server

1 month 6 days ago
Sounds like the WLAN tried the first AAA on the list and it didnt respond in...

George Stefanick has commented on Recommended WLC 2504 SSID setup with AD

1 month 1 week ago
Ok thats different from local eap. Local eap is on the WLC.  On the...

George Stefanick has commented on Recommended WLC 2504 SSID setup with AD

1 month 1 week ago
Also a blog I wrote about looking down EAP clients  http://community....

George Stefanick has commented on Recommended WLC 2504 SSID setup with AD

1 month 1 week ago
yup, check these out  http://www.cisco.com/c/en/us/support/docs/...

George Stefanick has commented on Recommended WLC 2504 SSID setup with AD

1 month 1 week ago
Yes using EAP peap and then lock the clients down config wise. You did good...

George Stefanick has commented on Cisco AP 3702I with RM3000M

1 month 1 week ago
What coed is the WLC ? 

George Stefanick has commented on Profile Wi-Fi users by authentication type

1 month 1 week ago
Thank you for the rating .. Check back if you have problems .. 

George Stefanick has commented on Profile Wi-Fi users by authentication type

1 month 1 week ago
Yes you can do this as well using a radius attribute.  1. The acl would...

George Stefanick has commented on Enabling Fast Transition with Assisted Roaming on Legacy SSID

1 month 1 week ago
Having done considerable device testing you will find that many devices won't...

Bio

Ive been working on wireless since 2000. Focused on Cisco wireless and wired networks. Cisco and CWNP certified.








  • Cisco Designated VIP

    2016 Wireless





  • Community Spotlight Award

    Best Publication, October 2015





  • Community Spotlight Award

    Mobile User, February 2015





  • Community Spotlight Award

    Member's Choice, January 2015





  • Cisco Designated VIP

    2014 Wireless





  • Cisco Designated VIP

    2013 Wireless





  • Cisco Designated VIP

    2012 Wireless









George Stefanick's Stats

Points6673
Discussion started 50
Answers marked as Correct 531
Endorsed 14
Content Rated 298
Website: