The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hi guys,I'm using Cisco DNA Center version 2.3.5.5-70026. The latest version is 2.3.7.7, but my Cisco DNA Center application can't detect the new latest version to visible the upgrade button. I remember the application will detect the next version to...
Hi AllI am looking at some switch upgrades, I need 10G base T copper and 25G uplinks.We normally use the C9200-24UXB switches, these have bigger buffers (64MB)I need a few more ports and the best forwarding rate possible, so I am looking at the 9300X...
I have my requirement as below.There are 6 locations which needs to be connected over WAN.Location-1 : IT Office (3 Floors)Floor 1 : Company AFloor 2 : Company BFloor 3 : Company CEach company needs to be logically separated. They may have same IP Se...
Good day everyone, I am interested in Segment Routing WECMP. I've searched about load balancing in Segment Routing and found that there is a formula by which load balancing calculates. But i didn't find the logic that on which information it load bal...
Hello, desperately need help from all the smart people. I am upgrading my routers and am stumped as to why these strange tones are coming through my T1 Test set. I have tested a few configurations between my Cisco 3925s, 2900s and 8300s and the sym...
Hello,I'm working on a lab assignment in packet tracer and when go into any of my devices and switch from static to DHCP it shows a message stating "DHCP failed. APIPA is being used."I have no idea what this means and I'm not getting any feedback fro...
Hi dear community,I have a good one for you regarding the setup of a vpls (ldp signaled) between a Cisco ISR1100X and a Juniper SRX300.As an example i am sending a simple ping between each node at each side of the VPLS.Both nodes are in Vlan 18 and h...