jgeorge@dynamicquest.com

Member Since: Apr 06, 2011

User Badges:

English
jgeorge@dynamicquest.com commented on CERM-4-TUNNEL_LIMIT error on 2901, not sure why? in WAN, Routing and Switching 4 years ago

-bump-I'm also seeing that VPN unable to pass traffic for about 5 minutes once a day. Could this be...

jgeorge@dynamicquest.com commented on CERM-4-TUNNEL_LIMIT error on 2901, not sure why? in WAN, Routing and Switching 4 years ago

The device is running a permanent license for securityk9. I did have a temporary license but that...

jgeorge@dynamicquest.com commented on How to set up UC320 to allow user to pick up another ext when it is ringing? in Voice Systems 4 years ago

I'm going to be going to the site where the UC is at in a bit and I will try this out.Thanks.

jgeorge@dynamicquest.com commented on Added a guest network to a Cisco router, can't get the space to NAT overload in LAN, Switching and Routing 5 years ago

A SVI is created for fa3 and is being used. I'm not sure what you are trying to say?

jgeorge@dynamicquest.com commented on Added a guest network to a Cisco router, can't get the space to NAT overload in LAN, Switching and Routing 5 years ago

Before I do that I have a few questions:Why remove the "ip nat inside source list 10 interface...

jgeorge@dynamicquest.com commented on DNS redirect on a ASA5505 in Firewalling 5 years ago

Any ideas?

jgeorge@dynamicquest.com commented on ASA 5505 8.2(1) is rebooting after high xlate usage in Firewalling 5 years ago

http://www.cisco.com/en/US/docs/security/asa/asa82/release/notes/asarn82.html#wp321918I thought the...

jgeorge@dynamicquest.com commented on ASA 5505 8.2(1) is rebooting after high xlate usage in Firewalling 5 years ago

Anyone know of a next step I can take to find a cause for this issue?

jgeorge@dynamicquest.com commented on VOIP QoS over L2L VPN on a ASA5505 in VPN 5 years ago

How do you apply this type of QoS when there is more the one tunnel in place?Do I need to make 5...

jgeorge@dynamicquest.com commented on VOIP QoS over L2L VPN on a ASA5505 in VPN 5 years ago

Maybe I should ask the question this way.I have 5 Site to Site VPN tunnels. I want to apply the QoS...

jgeorge@dynamicquest.com commented on VOIP QoS over L2L VPN on a ASA5505 in VPN 5 years ago

How should I do that though?Lets say the site with the UC has 5MB connection UP.I want to reserve...

jgeorge@dynamicquest.com commented on VOIP QoS over L2L VPN on a ASA5505 in VPN 5 years ago

Thanks that makes some more sense. I still have the second question though, could you help with...

jgeorge@dynamicquest.com commented on VOIP QoS over L2L VPN on a ASA5505 in VPN 5 years ago

Any other thoughts on this?

jgeorge@dynamicquest.com commented on VOIP QoS over L2L VPN on a ASA5505 in VPN 5 years ago

Thanks for the link but that is where I got my config that I posted above...The artical didn't...

jgeorge@dynamicquest.com commented on Question regarding full mesh vpn tunnels with ASA5505. in VPN 5 years ago

Sorry I don't think there is much more info to give. I was bacily looking to see if there was an...

jgeorge@dynamicquest.com commented on ASA: How to connect server with a external IP address already assigned? in Firewalling 5 years ago

Correct soultion:Add a switch after the internet modem and connect the ASA and the spam filter to...

jgeorge@dynamicquest.com commented on ASA: How to connect server with a external IP address already assigned? in Firewalling 5 years ago

Thanks for your help but I'm having a hard time following what you are trying to say. The IP scheme...

jgeorge@dynamicquest.com commented on ASA: How to connect server with a external IP address already assigned? in Firewalling 5 years ago

Both 24.x.x.x address are on the same subnet. They are public IP addresses.I have a outside, inside...

jgeorge@dynamicquest.com commented on ASA: How to connect server with a external IP address already assigned? in Firewalling 5 years ago

Note: Both 24.172.X.X address are on the same subnetI need both servers to send mail traffic back...

jgeorge@dynamicquest.com commented on Is this the correct config for a Remote Access VPN for ASA 8.4? in VPN 5 years ago

Thanks for the responce but I had a mistake in the config I posted above. I corrected it but the...

jgeorge@dynamicquest.com commented on Some questions about implementing ASA Active/Standby Failover in Network Management 5 years ago

I should have just drawn 1 ISP cloud I guess. The routers above the ASA have BGP running on them so...

jgeorge@dynamicquest.com commented on ASA 5505 8.2(1) - Poor WAN connection speed in Firewalling 6 years ago

In regards to:url-server (inside) vendor websense host 192.192.192.23 timeout 10 protocol UDP...

jgeorge@dynamicquest.com commented on ASA 5505 8.2(1) - Poor WAN connection speed in Firewalling 6 years ago

I only have remote access to the ASA currently but I will get all the information I can till I can...

jgeorge@dynamicquest.com commented on ASA 5505 8.2(1) - Poor WAN connection speed in Firewalling 6 years ago

Thanks for pointing that out. I forgot to mention at one point for troublshooting I tried to chage...

jgeorge@dynamicquest.com commented on UC540 IOS download section not showing up in IP Telephony 6 years ago

Ha, I tried to go to the site at first and I just entered in my login info wrong, got denied so I...

jgeorge@dynamicquest.com commented on UC540 IOS download section not showing up in IP Telephony 6 years ago

Where can I find these packs? I saw Unified Communications Software Packs  but it doesn't contain...

jgeorge@dynamicquest.com commented on UC540 IOS download section not showing up in IP Telephony 6 years ago

Hmmm, I must be pretty far off. Any help at all?

Bio

User Badges:

jgeorge@dynamicquest.com's Stats

Points1
Discussion started 16
Answers marked as Correct 0
Endorsed 0
Content Rated 11