jimmysands73_2

Member Since: Mar 08, 2009

English
jimmysands73_2's Activity on Cisco Support Community
Currently displaying 50 results

jimmysands73_2 has commented on NATIVE_VLAN_MISMATCH on switchports configured as access

1 year 10 months ago
Have you wiggled the cable?

jimmysands73_2 has commented on has anyone seen this cabling issue?

1 year 12 months ago
I am guessing Layer 1.  Might be asking the obvious here, but have you verified...

jimmysands73_2 has commented on odd pinging problem

2 years 11 hours ago
You never said what the problem is.  Are we to assume your concerned about the...

jimmysands73_2 has commented on SSDP flooding issue...

2 years 4 days ago
Forgot to mention the machine in question is just a normal windows machine that...

jimmysands73_2 has created SSDP flooding issue...

2 years 4 days ago
One windows based machine floods network randomly over the course of several...

jimmysands73_2 has commented on disable STP on SG200?

2 years 1 month ago
BPDU Filter would disable sending/recv'g (processing) any BPDUs I believe. Its...

jimmysands73_2 has commented on ACL Help Needed PLEASE

2 years 1 month ago
Your IP address of your camera is not in your nat pool/ip acl...ip nat inside...

jimmysands73_2 has commented on PT, assigning IP to switch using DHCP via router

2 years 2 months ago
Thats due to a limitation of PT.Example, try the debug command, you will see...

jimmysands73_2 has commented on Suggestion for tips during the exam test?

2 years 3 months ago
Practice, practice, practice.I did so much practice once I called my...

jimmysands73_2 has commented on How to note flapping links in log....

2 years 3 months ago
Thank you.

jimmysands73_2 has created How to note flapping links in log....

2 years 3 months ago
How does one setup a Cisco rtr or sw to show links going up/down in the local...

jimmysands73_2 has commented on LAN users have no internet access

2 years 3 months ago
Has this been working in the past? Have any changes been made recenty?

jimmysands73_2 has commented on EIGRP topology question....

2 years 3 months ago
I think I found out why, its known as a non-sucessor because if that was...

jimmysands73_2 has created EIGRP topology question....

2 years 3 months ago
I am doing my own made up lab in GNS3, and I do not understand some results. ...

jimmysands73_2 has commented on PVIDs vs vlans...

2 years 3 months ago
Thanks all, makes sense.

jimmysands73_2 has commented on Do I need to create all VLANS on all switches?

2 years 4 months ago
Just curious....say he had 100+ switches, could he not setup a VTP server, then...

jimmysands73_2 has created SSDP packets causing network confusion....

2 years 4 months ago
Let me ask this....I work at a local school district.  A site (school) has a...

jimmysands73_2 has commented on PVIDs vs vlans...

2 years 4 months ago
TY....another vendor has PVID settings, which I have not seen before as I work...

jimmysands73_2 has created PVIDs vs vlans...

2 years 4 months ago
What is a PVID used for?It seems to me this setting is the same as making a...

jimmysands73_2 has commented on High RX Power Alarm

2 years 5 months ago
Reset cable, test, possibly diff sfp, test. Possibly other end too high (faulty...

jimmysands73_2 has commented on STP causes four day outage...

2 years 6 months ago
Yawn...its early this moring in Vegas >>Some other may have heard about this...

jimmysands73_2 has created STP causes four day outage...

2 years 6 months ago
Posted on Cisco Learning Network.....I really enjoyed the reading and learning...

jimmysands73_2 has commented on Device in CDP Neighbourship but Not Pingable and Telnet/SSH

2 years 6 months ago
Andriy, your question is for Mohammad (IOW Mohammad != Jimmy I would verify two...

jimmysands73_2 has commented on question about vlan tagging

2 years 6 months ago
Let me try a different approach...The vlan 10 question, as it exits the PC and...

jimmysands73_2 has commented on Device in CDP Neighbourship but Not Pingable and Telnet/SSH

2 years 6 months ago
Did you test it before and it worked (you could telnet and ping it)?  If so,...

jimmysands73_2 has created Interface reset....

2 years 6 months ago
Question a few days ago, I did a small lab this morning.When I unplugged the...

jimmysands73_2 has commented on is that network outage related to those topology change events?

2 years 6 months ago
By brownout are you saying its electrical issues?  This cause a lot of...

jimmysands73_2 has commented on Why C2960 is dropping packets?

2 years 6 months ago
Not related...but>> 1 interface resetsDoes this mean layer 1 is dropping or...

jimmysands73_2 has commented on LAN infra troubleshooting guide

2 years 6 months ago
I could not get to that link, unsure of the OP...but here is a very generic...

jimmysands73_2 has commented on Access and Trunk configurations on the same port.

2 years 6 months ago
Aye, aye, ty.  Great explanation.

jimmysands73_2 has commented on Access and Trunk configurations on the same port.

2 years 6 months ago
Ive seen these configs on devices and always wondered about them, thanks for...

jimmysands73_2 has commented on How to prevent a router from sending out ICMP messages

2 years 6 months ago
Just curious....how processor intensive is this to send a simple "...

jimmysands73_2 has commented on How ping works in each layer

2 years 6 months ago
That mades sense, thank you.

jimmysands73_2 has commented on How ping works in each layer

2 years 6 months ago
So when we say 'ping' that command is irrelevant, we could rename this command...

jimmysands73_2 has commented on How ping works in each layer

2 years 6 months ago
To add, if I may, to the OP question....on the OSI model, is ping a layer 4...

jimmysands73_2 has commented on spanning tree root guard command

2 years 6 months ago
In a stable topology, this is only needed on the all the root bridge ports.No...

jimmysands73_2 has commented on Issue with switch port voice vlan config

2 years 6 months ago
I would also verify what the OP didnt say, is the phone getting power?  Layer...

jimmysands73_2 has commented on Can I get a layer 2 switch with at least 8 Fibre/SFP connections?

2 years 6 months ago
3550-12ghttp://www.cisco.com/en/US/products/hw/switches/ps646/...

jimmysands73_2 has commented on PoE for an NME-16es

2 years 6 months ago
I agree with others, sounds like the IOS you have does not support that.

jimmysands73_2 has commented on Host flapping between ports

2 years 6 months ago
Thank you fischer.rolf. and Mike.I thought I might help by saying what make/...

jimmysands73_2 has commented on Host flapping between ports

2 years 6 months ago
I am curious why doesnt that MAC address appear on OUI finder?http://www....

jimmysands73_2 has commented on LAN between Foundry and Cisco

2 years 7 months ago
If properly setup, there is no reason that would not work.

jimmysands73_2 has commented on Can't configure a data T1 on a Cisco 1760 router

2 years 7 months ago
I have only worked with frame relay in labs, but what side (cu or isp) is...

jimmysands73_2 has commented on Making an interface a trunk

2 years 8 months ago
If the switch supports different types of encapsuplations, then you could also...

jimmysands73_2 has commented on DHCP not handing out across VLANs

2 years 8 months ago
Curious...interface Vlan143description ( VLAN 143 ) .143 subnet (Existing VLAN...

jimmysands73_2 has commented on why some of the "aaa" commands are taking up three lines?

2 years 8 months ago
Obamacare

jimmysands73_2 has commented on Fibre Connection to Switch

2 years 8 months ago
No matter what type of connector is on both ends, you can buy cables with the...

jimmysands73_2 has commented on show cdp neighbors command shows two devices connected through the same local port

2 years 8 months ago
Second Adams remark via some Extreme gear also.

jimmysands73_2 has commented on switch issue - self reboot

2 years 9 months ago
You probably already went down this road....Are all the power sockets on the...

jimmysands73_2 has commented on How does layer 2 switch recognize DHCP Snooping ?

2 years 9 months ago
Thank you for your time and information.

Bio

CCNA, starting ROUTE this fall (09/2010)....again!










jimmysands73_2's Stats

Points265
Discussion started 58
Answers marked as Correct 21
Endorsed 0
Content Rated 176