jimmysands73_2

Member Since: Mar 08, 2009

English
jimmysands73_2 commented on AIR-CAP2702I-A-K9 boot up issues... in Other Wireless - Mobility Subjects 9 months ago

So I called Cisco, got a charming tech named Tim, he advised/emailed to format flash: and reload...

jimmysands73_2 commented on AIR-CAP2702I-A-K9 boot up issues... in Other Wireless - Mobility Subjects 9 months ago

That command produced a substantial amount of output....I chopped off some of it at the end, if you...

jimmysands73_2 commented on AIR-CAP2702I-A-K9 boot up issues... in Other Wireless - Mobility Subjects 9 months ago

Will get back to you tomorrow when I go onsite. Thanks for your time. The bug checker you link...

jimmysands73_2 commented on AIR-CAP2702I-A-K9 boot up issues... in Other Wireless - Mobility Subjects 9 months ago

The controller currently has about 68 other APs asscociated to it jfyi. Requested info: (Cisco...

jimmysands73_2 commented on AP offline do not show offline on Controller... in Getting Started with Wireless 1 year ago

Is there any sort of white paper or any sort of literature on Ciscos web site discussing this?  If...

jimmysands73_2 commented on AP offline do not show offline on Controller... in Getting Started with Wireless 1 year ago

What can be done as far on the management side to see when an AP goes down?  I know with Meru, we...

jimmysands73_2 commented on has anyone seen this cabling issue? in LAN, Switching and Routing 3 years ago

I am guessing Layer 1.  Might be asking the obvious here, but have you verified they are punched...

jimmysands73_2 commented on odd pinging problem in LAN, Switching and Routing 3 years ago

You never said what the problem is.  Are we to assume your concerned about the ping times?This...

jimmysands73_2 commented on SSDP flooding issue... in LAN, Switching and Routing 3 years ago

Forgot to mention the machine in question is just a normal windows machine that is used to play ....

jimmysands73_2 commented on disable STP on SG200? in Small Business Switches 3 years ago

BPDU Filter would disable sending/recv'g (processing) any BPDUs I believe. Its the equipvilant of...

jimmysands73_2 commented on ACL Help Needed PLEASE in LAN, Switching and Routing 3 years ago

Your IP address of your camera is not in your nat pool/ip acl...ip nat inside source list 101...

jimmysands73_2 commented on PT, assigning IP to switch using DHCP via router in LAN, Switching and Routing 3 years ago

Thats due to a limitation of PT.Example, try the debug command, you will see you get two or three...

jimmysands73_2 commented on Suggestion for tips during the exam test? in LAN, Switching and Routing 3 years ago

Practice, practice, practice.I did so much practice once I called my girlfriend once 'Hey slash 22...

jimmysands73_2 commented on LAN users have no internet access in LAN, Switching and Routing 3 years ago

Has this been working in the past? Have any changes been made recenty?

jimmysands73_2 commented on EIGRP topology question.... in Getting Started with LANs 3 years ago

I think I found out why, its known as a non-sucessor because if that was introduced, a routing...

jimmysands73_2 commented on PVIDs vs vlans... in Getting Started with LANs 3 years ago

Thanks all, makes sense.

jimmysands73_2 commented on Do I need to create all VLANS on all switches? in LAN, Switching and Routing 3 years ago

Just curious....say he had 100+ switches, could he not setup a VTP server, then all others as...

jimmysands73_2 commented on PVIDs vs vlans... in Getting Started with LANs 3 years ago

TY....another vendor has PVID settings, which I have not seen before as I work nornally with Cisco...

jimmysands73_2 commented on High RX Power Alarm in LAN, Switching and Routing 3 years ago

Reset cable, test, possibly diff sfp, test. Possibly other end too high (faulty)?Error Message...

jimmysands73_2 commented on STP causes four day outage... in LAN, Switching and Routing 3 years ago

Yawn...its early this moring in Vegas >>Some other may have heard about this case.  They...

jimmysands73_2 commented on Device in CDP Neighbourship but Not Pingable and Telnet/SSH in LAN, Switching and Routing 3 years ago

Andriy, your question is for Mohammad (IOW Mohammad != Jimmy I would verify two things, when I can...

jimmysands73_2 commented on question about vlan tagging in LAN, Switching and Routing 3 years ago

Let me try a different approach...The vlan 10 question, as it exits the PC and enters the switch, I...

jimmysands73_2 commented on Device in CDP Neighbourship but Not Pingable and Telnet/SSH in LAN, Switching and Routing 3 years ago

Did you test it before and it worked (you could telnet and ping it)?  If so, what changed?  If...

jimmysands73_2 commented on is that network outage related to those topology change events? in LAN, Switching and Routing 3 years ago

By brownout are you saying its electrical issues?  This cause a lot of weirdness....if devices are...

jimmysands73_2 commented on Why C2960 is dropping packets? in LAN, Switching and Routing 3 years ago

Not related...but>> 1 interface resetsDoes this mean layer 1 is dropping or layer 2?  I...

jimmysands73_2 commented on LAN infra troubleshooting guide in LAN, Switching and Routing 3 years ago

I could not get to that link, unsure of the OP...but here is a very generic one...http://home....

jimmysands73_2 commented on Access and Trunk configurations on the same port. in LAN, Switching and Routing 3 years ago

Aye, aye, ty.  Great explanation.

jimmysands73_2 commented on Access and Trunk configurations on the same port. in LAN, Switching and Routing 3 years ago

Ive seen these configs on devices and always wondered about them, thanks for the explanation.

jimmysands73_2 commented on How to prevent a router from sending out ICMP messages in LAN, Switching and Routing 3 years ago

Just curious....how processor intensive is this to send a simple "administratively prohibited...

jimmysands73_2 commented on How ping works in each layer in LAN, Switching and Routing 3 years ago

That mades sense, thank you.

jimmysands73_2 commented on How ping works in each layer in LAN, Switching and Routing 3 years ago

So when we say 'ping' that command is irrelevant, we could rename this command to be say,...

jimmysands73_2 commented on How ping works in each layer in LAN, Switching and Routing 3 years ago

To add, if I may, to the OP question....on the OSI model, is ping a layer 4 feature or layer 7...

jimmysands73_2 commented on spanning tree root guard command in LAN, Switching and Routing 3 years ago

In a stable topology, this is only needed on the all the root bridge ports.No down time since no re...

jimmysands73_2 commented on Issue with switch port voice vlan config in LAN, Switching and Routing 3 years ago

I would also verify what the OP didnt say, is the phone getting power?  Layer 1, layer 2, layer 3...

jimmysands73_2 commented on Can I get a layer 2 switch with at least 8 Fibre/SFP connections? in LAN, Switching and Routing 3 years ago

3550-12ghttp://www.cisco.com/en/US/products/hw/switches/ps646/products_data_sheet09186a00800913d0....

jimmysands73_2 commented on PoE for an NME-16es in LAN, Switching and Routing 3 years ago

I agree with others, sounds like the IOS you have does not support that.

jimmysands73_2 commented on Host flapping between ports in LAN, Switching and Routing 3 years ago

Thank you fischer.rolf. and Mike.I thought I might help by saying what make/model the device was,...

jimmysands73_2 commented on Host flapping between ports in LAN, Switching and Routing 3 years ago

I am curious why doesnt that MAC address appear on OUI finder?http://www.wireshark.org/tools/oui-...

jimmysands73_2 commented on LAN between Foundry and Cisco in LAN, Switching and Routing 3 years ago

If properly setup, there is no reason that would not work.

jimmysands73_2 commented on Can't configure a data T1 on a Cisco 1760 router in LAN, Switching and Routing 3 years ago

I have only worked with frame relay in labs, but what side (cu or isp) is responsible for setting...

jimmysands73_2 commented on Making an interface a trunk in LAN, Switching and Routing 3 years ago

If the switch supports different types of encapsuplations, then you could also use sw tr en isl. ...

jimmysands73_2 commented on DHCP not handing out across VLANs in LAN, Switching and Routing 3 years ago

Curious...interface Vlan143description ( VLAN 143 ) .143 subnet (Existing VLAN)ip address 10.147....

jimmysands73_2 commented on Fibre Connection to Switch in LAN, Switching and Routing 3 years ago

No matter what type of connector is on both ends, you can buy cables with the right ends on them. ...

jimmysands73_2 commented on switch issue - self reboot in LAN, Switching and Routing 3 years ago

You probably already went down this road....Are all the power sockets on the same circuit?Do you...

jimmysands73_2 commented on How does layer 2 switch recognize DHCP Snooping ? in LAN, Switching and Routing 3 years ago

Thank you for your time and information.

jimmysands73_2 commented on Method for detecting loops..... in Getting Started with LANs 4 years ago

Thanks all!  Great feekback!

Bio

CCNA, starting ROUTE this fall (09/2010)....again!










jimmysands73_2's Stats

Points265
Discussion started 62
Answers marked as Correct 20
Endorsed 0
Content Rated 177