If I am currently in Emeritus status then go back to Active CCIE. Can I go back to Emeritus again if i decide not to take a recertification exam the next time that I am due to recertify or I must recertify for another 10 years to quality for Emeritu...
Or Is it "necessary" to apply priority queue outbound on an interface a phone is attached? Thanks. Is below config a common practice?!policy-map QOSclass VOICEpriority level 1!police rate percent Xpolicy-map QOSservice-policy output QOS!Interface Gx...
Hi - How to determine FP2100 in asa mode installed with anyconnect license?
Below is the show version outputs. It said AnyConnect Premium Peers : 3500
Does it mean this box is capable to handle up to 3500 anyconnect client or client-less connecti...
Hi -
How to read below qos commands in "same" Class-map?
Class Qos
bandwidth remaining X %
police cir Y% conform-action transmit exceed drop
I am reading them as follow:
#1 When there is a congestion, bandwidth remaining X % command will be u...
Hi - gajownikCan you confirm CSCvv93458 was also fixed in Cisco Secure client? I am running v 5.1.1.42, i am still seeing the issue. VPN tunnel restarted when temporary IPv6 addresses was created or modified.
Thanks for the reply Tobias Moritz.Will Cisco Secure Client 5.1.0.136 (released on 10.27.23) contain the fix? Is this the 5.0 MR6 release? Where did you find the MR5 or MR6 information? Thanks
Hi Tobias - I am testing Cisco Secure Client version 5.0.05040 but WebView2 issue is still no fixed. Just curious, what was the version you tested working> Thanks