John Peterson

Member Since: Oct 10, 2011

English
John Peterson commented on CEF and access-list in LAN, Switching and Routing 2 years ago

Hi Peter,Are  ACLs also stored in TCAM for a Cisco router?We have a router with few ACLs on the...

John Peterson commented on VPC Peer Link in LAN, Switching and Routing 2 years ago

Hi Lex,I'm afraid we already have the N1K implemented. Were you able to advise on the comments...

John Peterson commented on VPC Peer Link in LAN, Switching and Routing 2 years ago

ok, so as I read your reply I would like to confirm the following: Hosts which are not connected to...

John Peterson commented on VPC Peer Link in LAN, Switching and Routing 2 years ago

Hi Reza, Digging up a old thread here...We have a number of VLANs which will be used by virtual...

John Peterson commented on Difference between (QoS) exceed and violate? in WAN, Routing and Switching 2 years ago

Hi Milan, Does this also relate when policing traffic in QoS?

John Peterson commented on Nexus 5k Scheduled Reload in LAN, Switching and Routing 2 years ago

Hi Richard, Are you able to elaborate on your answer, from my understanding the 'rollback' cmd has...

John Peterson commented on Is PBR supported when processing IPv4 and IPv6 traffic? in LAN, Switching and Routing 2 years ago

Hi Reza,If you select Index and then 'P' and client on PBR defined, then my orginal posts still...

John Peterson commented on Valn between cisco & sonicwall ? in LAN, Switching and Routing 3 years ago

Hi Vinish,TBH no is going to give you the configuration for the above. I would recommend searching...

John Peterson commented on Clients disconnect on LAP vWLC in Getting Started with Wireless 3 years ago

Hi Scott,In relation to the clients dropping off we are seeing a number of Rouge AP alerts from the...

John Peterson commented on Clients disconnect on LAP vWLC in Getting Started with Wireless 3 years ago

Ahh makes sense, to obtain the full Flexconnect feature local switching has to be enabled. Cisco...

John Peterson commented on Clients disconnect on LAP vWLC in Getting Started with Wireless 3 years ago

Thanks,We are not using local switching at the moment, but as the vwlc only supports flexconnect I...

John Peterson commented on portmap translation creation failed for tcp src inside:192.168.91.35/32483 dst dmz4:10.10.7.21/443 in Firewalling 3 years ago

Hi Julio,I today was having the same issue.Who doing hairpining NAT on a tcp port, to and from the...

John Peterson commented on Can I terminate a EoMPLS or xconnect on a trunk link? in WAN, Routing and Switching 3 years ago

Hi mate,Any news?Sent from Cisco Technical Support iPhone App

John Peterson commented on Can I terminate a EoMPLS or xconnect on a trunk link? in WAN, Routing and Switching 3 years ago

We have a L3 switch which terminated our clients lease line connections these are mostly L2 and...

John Peterson commented on Can I terminate a EoMPLS or xconnect on a trunk link? in WAN, Routing and Switching 3 years ago

Hi,Don't really understand, if I had my trunk as Gi1/0/1Gi1/0/1switchport mode trunkswitchport...

John Peterson commented on How do I suppress routes when one of the remote site is active? in WAN, Routing and Switching 3 years ago

HiThat won't be possible as the site has be a replica, in case site A goes down. The routes at the...

John Peterson commented on How do I suppress routes when one of the remote site is active? in WAN, Routing and Switching 3 years ago

Hi Muhammad,I don't really know, I was hoping someone from here could help, that is my problem. The...

John Peterson commented on How do I suppress routes when one of the remote site is active? in WAN, Routing and Switching 3 years ago

Thanks,I dont't really have any ip address at the moment. I aware of the BGP and routing...

John Peterson commented on How do I suppress routes when one of the remote site is active? in WAN, Routing and Switching 3 years ago

Hi Muhammad,I currenly don't have any config are but one project which should have been completed 2...

John Peterson commented on How do I suppress routes when one of the remote site is active? in WAN, Routing and Switching 3 years ago

Anybody have any thoughts?Sent from Cisco Technical Support iPhone App

John Peterson commented on How to manage MP-BGP relationships with MPLS in WAN, Routing and Switching 3 years ago

Thanks, I'm reading on RR and it's seems the client of each cluster can only be one hop away from...

John Peterson commented on route-reflector clusters in MPLS 3 years ago

Is this correct, for RR clusters, within iBGP . I thought that RR would push about routes out to...

John Peterson commented on How to manage MP-BGP relationships with MPLS in WAN, Routing and Switching 3 years ago

Thank you.It seemed that for some reason address-family ipv4 got added in. Once I removed this and...

John Peterson commented on How to manage MP-BGP relationships with MPLS in WAN, Routing and Switching 3 years ago

Thanks when configuring RR I keep on getting,% Activate the neighbor for the address familySent...

John Peterson commented on How to manage MP-BGP relationships with MPLS in WAN, Routing and Switching 3 years ago

Ah perfect, I was under the impression that the RR were only for iBGP relationship.Sent from Cisco...

John Peterson commented on Migrate from router to ASA in Firewalling 4 years ago

You should be able to create a dialer interface and then map to your ATM.Have a look at this guide:...

John Peterson commented on Migrate from router to ASA in Firewalling 4 years ago

Hi Marco,One of the configuration I did was let the dialer interface get an IP address from the ISP...

John Peterson commented on Stub router not updating routing table - EIGRP in LAN, Switching and Routing 4 years ago

Thanks John, really apperciate your time.I think you are right, I'm going to give it a go. How did...

John Peterson commented on Stub router not updating routing table - EIGRP in LAN, Switching and Routing 4 years ago

Thought so.I have attached the config to this post.Thanks for all your help.John.

John Peterson commented on Stub router not updating routing table - EIGRP in LAN, Switching and Routing 4 years ago

Thanks John,I'm not able to shutdown the interfaces and I have sub interfaces on the physical...

John Peterson commented on Stub router not updating routing table - EIGRP in LAN, Switching and Routing 4 years ago

Hi J,I have been testing for the past 3 hours and its seems the problem is intermittent, for...

John Peterson commented on Stub router not updating routing table - EIGRP in LAN, Switching and Routing 4 years ago

Hi,All routers are in eigrp, when I excute the clear ip eigrp neighbors, the route get removed and...

John Peterson commented on Stub router not updating routing table - EIGRP in LAN, Switching and Routing 4 years ago

Yes mate,I have attached a folder which includes the debug outputs from Router C and a section of...

John Peterson commented on Should we be using router on a sick? in LAN, Switching and Routing 4 years ago

ThanksThere if I was to use a L3 switch which had a through of 32gi it would allow routing speeds...

John Peterson commented on Should we be using router on a sick? in LAN, Switching and Routing 4 years ago

The devices are going to be edge devices running eigrp to our other sites which have private links....

John Peterson commented on Should we be using router on a sick? in LAN, Switching and Routing 4 years ago

Thanks, The concern is that L3 switch are pricey with full eigrp therefore thinking using router on...

John Peterson commented on Should we be using router on a sick? in LAN, Switching and Routing 4 years ago

Thanks Layer 3 switch was an option as we won't we using any o the routing features like VPN etc...

John Peterson commented on eigrp multiple vlan - trunk or sub interfaces? in LAN, Switching and Routing 4 years ago

Thanks,I've be running EIGRP as I would like to advertise the local network to each site. I guess...

John Peterson commented on 800 Series Router WAN Throughput in WAN, Routing and Switching 4 years ago

I understand but these router in our labs we use on production environment post testing features....

John Peterson commented on 800 Series Router WAN Throughput in WAN, Routing and Switching 4 years ago

Hi Paolo,Thank you,Therefore a Cisco 881 should be able to router over 100Mbps of traffic?I also...

John Peterson commented on 800 Series Router WAN Throughput in WAN, Routing and Switching 4 years ago

Hi,I'm also having the same confusion. Our 881 shows on paper to push  roughly 12Mbps, but when...

John Peterson commented on Switch - backplane, forwarding rate, throughput, bandwidth in LAN, Switching and Routing 4 years ago

Giuseppe Larosa wrote:Hello John,we have to refer to specific model datasheethttp://www.cisco.com/...

John Peterson commented on Switch - backplane, forwarding rate, throughput, bandwidth in LAN, Switching and Routing 4 years ago

When the forwarding capabilities of a backplane or switching fabric are greater then the sum of...

John Peterson commented on failover to different tunnels on ASA with one ISP, is this possible? in VPN 4 years ago

Hi,The red line is the new VPN and I want to route all taffic to the priviate network behind ASA C...

John Peterson commented on failover to different tunnels on ASA with one ISP, is this possible? in VPN 4 years ago

Hi Javier,Maybe it will help if I explain our network.If you think of it like a triangle with the...

John Peterson commented on Block traffic between two vlans on a Cat3560C + Internet Access in LAN, Switching and Routing 4 years ago

Hi Peter,No need to apologize, any amount of your time is highly appreciated by me, therefore thank...

John Peterson commented on Block traffic between two vlans on a Cat3560C + Internet Access in LAN, Switching and Routing 4 years ago

Hi Peter,I was wondering if you have an chance to look at the above?ThanksJ.

John Peterson commented on Block traffic between two vlans on a Cat3560C + Internet Access in LAN, Switching and Routing 4 years ago

Hi Peter,Thank you very much for reply, really apperciate it.Sorry for the late reply. The laptop...

John Peterson commented on Block traffic between two vlans on a Cat3560C + Internet Access in LAN, Switching and Routing 4 years ago

Any advise would be much appreciated.

John Peterson commented on Block traffic between two vlans on a Cat3560C + Internet Access in LAN, Switching and Routing 4 years ago

Hi,From one of the above post you mentation that an accless-list always has an explict deny in the...

Bio












John Peterson's Stats

Points7
Discussion started 53
Answers marked as Correct 0
Endorsed 0
Content Rated 40