Kayle Miller

Member Since: Jan 24, 2007

English
Kayle Miller commented on Power level of Access point in Getting Started with Wireless 4 months ago

Just to clarify in regards to the Power Levels a TX Power of 1 is the highest transmit power as...

Kayle Miller commented on Power level of Access point in Getting Started with Wireless 4 months ago

Bruno, the Min/Max Transmit Power is a setting that can be configured on the controller to limit or...

Kayle Miller commented on AIR-CAP26021-E-K9 not connecting to network in Getting Started with Wireless 1 year ago

The only thing to keep in mind with a Virtual Controller is that it's only designed to support...

Kayle Miller commented on Cisco Prime Floor View Wrong AP Heatmaps in Getting Started with Wireless 1 year ago

A couple of things are the floors scaled to proper dimensions and all matching as having the same...

Kayle Miller commented on 802.11a not coming up in Getting Started with Wireless 1 year ago

If you reference this document you will notice that although Australia is -Z for stand-alone access...

Kayle Miller commented on 5508 WLC - Multiple AP Management Interfaces in Getting Started with Wireless 1 year ago

Refer to this post this should help you with what you are trying to do. https://supportforums.cisco...

Kayle Miller commented on Expand a WLAN coverage through APs (2600 series) in Getting Started with Wireless 1 year ago

Any method you do to connect these devices wirelessly will have an impact on bandwidth; it sounds...

Kayle Miller commented on Db values in the elevation charts of antennas in Getting Started with Wireless 1 year ago

The short answer is no and here is a document that goes into great detail on Antenna Patterns http...

Kayle Miller commented on Cisco Aironet 1130G Can not find Airplay device in Getting Started with Wireless 1 year ago

Are these stand-alone autonomous access points? or are they controller based access points?If the...

Kayle Miller commented on How to disable IP to Mac Binding at Cisco AP Autonomous in Getting Started with Wireless 1 year ago

Assuming that I am interpreting your diagram correctly the AP on the left should be a work-group...

Kayle Miller commented on Users limits on AP Aironet 702 in Getting Started with Wireless 1 year ago

I don't believe that there is an access level that will allow only the PSK for an SSID, the access...

Kayle Miller commented on AIR-CAP26021-E-K9 not connecting to network in Getting Started with Wireless 1 year ago

My suggestion would be to purchase a Cisco mobility express bundle; that would get you 2 new access...

Kayle Miller commented on access point with only 1 km diameter in Getting Started with Wireless 1 year ago

The Cisco 1300 Series could do a point to point link over 1km but if you are looking to actually...

Kayle Miller commented on SNR and RSSI Values. in Getting Started with Wireless 1 year ago

Grigione, If you goto this site http://www.pasternack.com/t-calculator-fspl.aspx?gclid=...

Kayle Miller commented on SNR and RSSI Values. in Getting Started with Wireless 1 year ago

Grigione,  so if your application is showing you a -20 dBm at the antenna you say that your output...

Kayle Miller commented on SNR and RSSI Values. in Getting Started with Wireless 1 year ago

I think what you are seeing in your client is either the SNR (which should be a Positive Number) or...

Kayle Miller commented on SNR and RSSI Values. in Getting Started with Wireless 1 year ago

Yes George we are getting 'OLD'!! :(

Kayle Miller commented on SNR and RSSI Values. in Getting Started with Wireless 1 year ago

Grigione2015,There is a very long a detailed explanation that could be put forth, but the from a...

Kayle Miller commented on Template that fails on deployment in Other Wireless - Mobility Subjects 2 years ago

This is my Excel Workbook to do all the H-REAP Commands from CLI, the FlexConnect Commands are...

Kayle Miller commented on SNR, RSSI, EIRP and Free Space Path Loss in Getting Started with Wireless 2 years ago

Actually above it's correct, but the math line is where i made the typo.. Good catch though.

Kayle Miller commented on Wireless Clients disconnect, not able to reconnect in Other Wireless - Mobility Subjects 3 years ago

That is a good catch and correct, it could very well be that.

Kayle Miller commented on Wireless Flexconnect and QoS in Getting Started with Wireless 3 years ago

Will,     If you are running the AP's in Flexconnect mode and are implenting QoS it does need to...

Kayle Miller commented on SSL Cert error in Security and Network Management 3 years ago

If you follow all the steps correctly it should work, you cannot leave the password as Scott...

Kayle Miller commented on Wireless Clients disconnect, not able to reconnect in Other Wireless - Mobility Subjects 3 years ago

Sebastian,     Have you gone under each AP and enabled the VLAN Support, and then specified the...

Kayle Miller commented on Issues updating Cisco 4404 WLC in Security and Network Management 3 years ago

Kevin,     I would download the updated 4.1 bootloader and the up dated 4.2 boot loaders; install...

Kayle Miller commented on Cisco 2500 Wireless Controller Web Access in Wireless IP Voice and Video 3 years ago

Randall,     If you are still having issues try these 2 commands at the console and see if it...

Kayle Miller commented on Network Busy message with 7920 phones in Wireless IP Voice and Video 3 years ago

Anvar,     As foolish as this may sound make sure that 12mb is supported on the controller...

Kayle Miller commented on About the output of "show dot11 associations" command. in Wireless IP Voice and Video 3 years ago

Shigeru,     Is this an autonomous access point? If so it may simply be that the firmware doesn't...

Kayle Miller commented on ASCOM wifi phone problems in Wireless IP Voice and Video 3 years ago

Ascom has also had issues in the past with connectivity to an SSID that has Aironet Extensions...

Kayle Miller commented on Wireless Clients disconnect, not able to reconnect in Other Wireless - Mobility Subjects 3 years ago

Sebastian,     Can you provide a bit more detail? Are the AP's in FlexConnect/H-REAP Mode?Are they...

Kayle Miller commented on cannot access GUI on WLC 7.2 in Getting Started with Wireless 3 years ago

Mike,     If you have an interface name that is messed up.. Can you telnet or SSH to the controller...

Kayle Miller commented on How to program Cisco Aironet 1240AG and HP ProCurve 6200yl for 2 vlan's in Getting Started with Wireless 3 years ago

Matthew,     The IOS AP's will support multiple vlans it's all in the configuration. The below...

Kayle Miller commented on Internet through wireless very slow in Getting Started with Wireless 3 years ago

Ross,     I just wanted to clarify something; Are all the wireless users slow or just certain...

Kayle Miller commented on Set Lobby Ambassador Defaults - Cisco ACS remote authentication in Other Wireless - Mobility Subjects 3 years ago

I believe in ACS that if you pass the following radius attribute to WCS you'll be able to give a...

Kayle Miller commented on WCS Wrong RRM Groups in Other Wireless - Mobility Subjects 4 years ago

If at somepoint it pulled a template from the controllers it stores it and if it changes and...

Kayle Miller commented on no software for "air mp-20b WLAN card in Other Wireless - Mobility Subjects 4 years ago

Mark,     I can't say that i have ever seen a driver for that Mini-PCI card, that particular part...

Kayle Miller commented on Minimal WLC5508 CLI configuration to access the GUI? in Getting Started with Wireless 4 years ago

yes Julio you can access the GUI thru the service port as long as it has an IP address and your...

Kayle Miller commented on Minimal WLC5508 CLI configuration to access the GUI? in Getting Started with Wireless 4 years ago

if you were connecting to the service port it shouldn't be a problem but if you connected to the...

Kayle Miller commented on AP won't join (LAP1242 and WLC 5500 series) in Getting Started with Wireless 4 years ago

Quick question, are there other AP's on this controller already??  If not double check the date and...

Kayle Miller commented on please tell how to password recovery Wireless LAN Controller 4402 in Getting Started with Wireless 4 years ago

Both responses are relatively accurate, Rob is correct depending on the code revision, but Ramraj...

Kayle Miller commented on WLC 4402 w/ corrupt software in Getting Started with Wireless 4 years ago

Open a TAC Case is the best route especially if the manually updates images doesn't work, they...

Kayle Miller commented on AP won't join (LAP1242 and WLC 5500 series) in Getting Started with Wireless 4 years ago

This may seem stupid but could also be overlooked.. I noticed the AP is an -E Regulatory domain,...

Kayle Miller commented on 1242AG wont holt bootloader in Getting Started with Wireless 4 years ago

Lloyd,     Your goal is to make this into a Autonomous access point correct, then my best...

Kayle Miller commented on WLC 5508 Web Auth Splash Page: Is it possible to place a download? in Getting Started with Wireless 4 years ago

Michael,     You should be able to, I had a client due something similar to that.. You'd need to...

Kayle Miller commented on Adjusting the Maximum Power level Assignment Value in Getting Started with Wireless 4 years ago

the default on most code revs is Max at 30 and the min is -10   (note the minus sign).. If your...

Kayle Miller commented on SNMP operation to Device failed: Attempt to set conflicting attribute value in Getting Started with Wireless 4 years ago

Justin,   If the controllers are workign properly and everything seems good, then the first thing...

Kayle Miller commented on Smartphone Exchange not working from internal network. in Other Wireless - Mobility Subjects 4 years ago

Josh,    To me the simpliest solution would be to have you network admin who manages DNS ad an...

Kayle Miller commented on WLC 2112 - APs disassociating in Getting Started with Wireless 4 years ago

Matt,   This maybe a long shot but do you have multiple controllers?  If so are any of them setup...

Kayle Miller commented on WLC 2112 - APs disassociating in Getting Started with Wireless 4 years ago

Typically a heartbeat timeout means it's losing the connection to the controller (ie: capwap...

Bio












Kayle Miller's Stats

Points525
Discussion started 11
Answers marked as Correct 34
Endorsed 0
Content Rated 67