lowfell

Member Since: Jan 15, 2004

User Badges:

English
lowfell commented on Is Tunnel mode a mandatory command when configuring IPv6 Tunnels? in WAN, Routing and Switching 3 weeks ago

I'm just trying to understand Tunnel configs for when i sit TSHOOT. I understand now that the...

lowfell commented on Is Tunnel mode a mandatory command when configuring IPv6 Tunnels? in WAN, Routing and Switching 3 weeks ago

Hello George. would the tunnel still function WITHOUT tunnel mode statement? You say it defaults...

lowfell commented on OSPF State Confusion in WAN, Routing and Switching 3 weeks ago

Thanks Jon. I've got it now! Much appreciated.

lowfell commented on OSPF State Confusion in WAN, Routing and Switching 3 weeks ago

The point I was trying to make is that you can have a physical point to point link but OSPF still...

lowfell commented on OSPF State Confusion in WAN, Routing and Switching 3 weeks ago

So you are saying that   Router1 is the DR ? & not Router2 ? If router one is the DR then the...

lowfell commented on Redistributing OSPF in to RIPng ? in WAN, Routing and Switching 3 weeks ago

Thanks for your help Mark. Greatly appreciated.

lowfell commented on Redistributing OSPF in to RIPng ? in WAN, Routing and Switching 3 weeks ago

Ok, Mark. According to that post he needs to add this to R4 (config-router)redistribute ospf 6...

lowfell commented on Redistributing OSPF in to RIPng ? in WAN, Routing and Switching 3 weeks ago

I don't see rip on the diag Ripng is in the middle diagram labelled Ipv6 Topology. Ripng RIP_ZONE...

lowfell commented on GRE IPV6 Confusion! in WAN, Routing and Switching 3 weeks ago

Thanks Philip. That's much appreciated.

lowfell commented on GRE IPV6 Confusion! in WAN, Routing and Switching 3 weeks ago

So if its                                                 R1#tunnel mode ipv6 then the other side...

lowfell commented on GRE IPV6 Confusion! in WAN, Routing and Switching 3 weeks ago

It is tunnelling IPv6 over IPv4 So in this instance is it mandatory to have #tunnel mode ipv6 ?

lowfell commented on self-service-onboarding-setting-cspc-2.6 collector Problems in Smart Net Total Care 7 months ago

Why do i not have the Smart NET Total care TAB ? Also what is the difference between selecting the...

lowfell commented on self-service-onboarding-setting-cspc-2.6 collector Problems in Smart Net Total Care 7 months ago

Thjanks for the swift Reply Lyndon. when I click the back button the otions I have are  Cisco...

lowfell commented on Is there a FULL CSPC-Collector Admin/Config Guide? in Smart Net Total Care 1 year ago

Thanks for your Help Lynden. Greatly appreciated. Brian

lowfell commented on Client unable to get ip address with "ip dhcp required" enabled on 5760 3.03 in Other Wireless - Mobility Subjects 2 years ago

Yhis issue is now resolved. All I bneeded to do was tick the DHCP required on THE MAIN CONTROLLER...

lowfell commented on CUPC 8.5(5) Busy users still showing as busy, even when logged out in Unified Communications Applications 5 years ago

Can anybody help with this here, is it a known issue, anyone?

lowfell commented on CUCM 7.1 Subscriber backup failure in Unified Communications Applications 6 years ago

Sure there no sync errors between pub and subs?  (dbreplications)Thanks for the reply. Where would...

lowfell commented on ASA5505 Site2Site Tunnel to CheckPoint not working plus ASDM errors in VPN 8 years ago

I always press the save button before refreshing. In my experience the The ASDM is good ONLY for...

lowfell commented on IOS naming conventions RANT in WAN, Routing and Switching 10 years ago

Many thanks Spremkumar, but I already have this document & it still does not Explain what YT or...

Bio

User Badges:

lowfell's Stats

Points0
Discussion started 21
Answers marked as Correct 0
Endorsed 0
Content Rated 4