marmugam

Member Since: Oct 31, 2005

English
marmugam commented on CME: Issue with calls from Polycom IP 7000 to IP phone over H.323 VoIP trunk in IP Telephony 4 years ago

And we cannot disable SIP EO in CME. So we are running out of gas in this setup.

marmugam commented on CME: Issue with calls from Polycom IP 7000 to IP phone over H.323 VoIP trunk in IP Telephony 4 years ago

Hello Swati,My expertise in Video is 0, however looking at the documentation, I think h323 fast...

marmugam commented on MOH LIVE feed is not working in CME SRST mode in IP Telephony 4 years ago

Hi,Moh not played between two remote IP phones or Btw remote ip phone and PSTN. Can you share the...

marmugam commented on Calls between two pbxs connected to a call manager not working in IP Telephony 4 years ago

Hi rramlal, You are right about the number which is passed to CCM, it is indeed "85221300...

marmugam commented on CME: Issue with calls from Polycom IP 7000 to IP phone over H.323 VoIP trunk in IP Telephony 4 years ago

Hello Swati,Call is hitting this dial-peer102  to CCM. I thik you have removed the "voice -class...

marmugam commented on Calls between two pbxs connected to a call manager not working in IP Telephony 4 years ago

Hi,// Received H225 Setup 097863485| 2012/05/09 13:30:50.658|...

marmugam commented on Calls between two pbxs connected to a call manager not working in IP Telephony 4 years ago

Hi,++ Assuming H323 is used for signalling  between both the PBX with CCM.++ The fact that same...

marmugam commented on CME: Issue with calls from Polycom IP 7000 to IP phone over H.323 VoIP trunk in IP Telephony 4 years ago

Hello Swati,I had the same symptoms when I didn't select inbound fast start in CCM. As IP-IP GW...

marmugam commented on CME: Issue with calls from Polycom IP 7000 to IP phone over H.323 VoIP trunk in IP Telephony 4 years ago

Hello Swati,++ Make a test call and capture the following debugs++ debug ccsip message++ debug h225...

marmugam commented on cucm 8.5.1 SCCP45.9-1-1SR1S phones cannot load firm in IP Telephony 4 years ago

            From the relase notes   http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/firmware/...

marmugam commented on config a hotline on a fxs (CUCM - MGCP) in IP Telephony 4 years ago

HI Alberto,I was trying this in my lab and got it working. Here is what I did:-++ Created partition...

marmugam commented on cucm 8.5.1 SCCP45.9-1-1SR1S phones cannot load firm in IP Telephony 4 years ago

++ If this is new phone and was not registered to any 7.x cluster before, then it cannot be ITL...

marmugam commented on Ring tone OK but call disconnected at off-hook in IP Telephony 4 years ago

Hi,You wll not see any h323 related events as this call is coming in from analog line to a phone...

marmugam commented on Ring tone OK but call disconnected at off-hook in IP Telephony 4 years ago

Hi,Is this is the call flow:-Inbound call-----FXO----- 2911(CME)---IP phone++ Looks like the call...

marmugam commented on CUCM : Conference bridge and Transcoding in IP Telephony 4 years ago

I undersantd you far end receives Silence. But when you resume the call does the call gets...

marmugam commented on config a hotline on a fxs (CUCM - MGCP) in IP Telephony 4 years ago

Ok, the steps you have mentioned from  a different thread looks logical to me. But make sure that...

marmugam commented on config a hotline on a fxs (CUCM - MGCP) in IP Telephony 4 years ago

Forgive me Just realised, with the help of  Attendant DN   it will automatically the ring all the...

marmugam commented on config a hotline on a fxs (CUCM - MGCP) in IP Telephony 4 years ago

Hi,++ What happens when you configure Attendant DN in MGCP ep configuration, did you hear fast busy...

marmugam commented on config a hotline on a fxs (CUCM - MGCP) in IP Telephony 4 years ago

Hi,If the fxs ports are controlled by MGCP, then you dont need connection plar.  In the MGCP...

marmugam commented on Intermittent issue with incoming calls in IP Telephony 4 years ago

Hi,Looked into th failed scenario, call was released by  far end Telco/PBX switch.Looks like this...

marmugam commented on Inbound call issue.Cause i = 0x809C - Invalid number format (incomplete number) in IP Telephony 4 years ago

hi,++ In the above setup message, there was no called number, so wondering how the receiving end...

marmugam commented on DSP error getting in IP Telephony 4 years ago

Yes, you have pvdm3, where cisco fax relay is not supported. However, like I mentioned I wouldn't...

marmugam commented on DSP error getting in IP Telephony 4 years ago

Hi Kailash,The above error message should happen during the fax call. Do you know thats the case...

marmugam commented on RightFax dtmf with cisco IOS in IP Telephony 4 years ago

HI,++ The attached debugs only voip dialpeer debugs.++ Check with Rightfax server what is accepted...

marmugam commented on Calls via a gateway being dropped when transferred internally in IP Telephony 4 years ago

Hi,Can you give the call flow ?Eg:-Phone-----PSTN/PRI/CAS------Voice gateway----???...SIP/h323/mgcp...

marmugam commented on 8941 external call issue in IP Telephony 4 years ago

Did you use DNA ? Ok, If it is PRI T1 quickly enable debug isdn q931 and see if the call makes it...

marmugam commented on 8941 external call issue in IP Telephony 4 years ago

Hi,WHats the symptom ? U get fast busy /reorder right away or u hear ringback and call disconnets?...

marmugam commented on DTMF from SIP to ISDN in IP Telephony 4 years ago

Hello Bernard,Logs are not complete, no hpi debugs , no voip rtp session,  debug voip ccapi inout...

marmugam commented on Music-on-Hold (MOH) and multicast on CUCM 8.5 in IP Telephony 4 years ago

HI,++ Ok, When IP phoen A in manin site places the call on hold with  IP phone B in remote site....

marmugam commented on DTMF from SIP to ISDN in IP Telephony 4 years ago

Hello Bernard,If it is getting to GW, then if it is not going to IVR across PSTN, then the only...

marmugam commented on Music-on-Hold (MOH) and multicast on CUCM 8.5 in IP Telephony 4 years ago

Hi,++ When you enable MMOH in MRG and if it works for certain users/regions and certain users get...

marmugam commented on IP communicator status rejected in IP Telephony 4 years ago

If Erasing ITL doesn't work,  unplug the phone and plug it again and wait for oe iteration of...

marmugam commented on Disconnect Cause = 47 --- Q931 Debug --- Issue in IP Telephony 4 years ago

Like Paulo, mentioned there is no call proceeding message from PBX at all, can you check with them...

marmugam commented on MGCP gateway can't make outbound calls in IP Telephony 4 years ago

HI,Do you  still have that setup, if so can you collect the logs there or can you compare the...

marmugam commented on MGCP gateway can't make outbound calls in IP Telephony 4 years ago

++ And they didnt sent an Alering message, which tells me,  that  they were not able to route the...

marmugam commented on MGCP gateway can't make outbound calls in IP Telephony 4 years ago

From the logs atatched:-++ Is this the call ?Apr 24 19:02:00.516: ISDN Se1/0:15 Q931: TX ->...

marmugam commented on MGCP gateway can't make outbound calls in IP Telephony 4 years ago

Hi,Like others mentioned, what is the symptom when you call? ++ Run DNA and make sure there is no...

marmugam commented on CUBE deploy with transoding and PSTN in IP Telephony 4 years ago

HI,DSP Pool for dspfarm and for TDM_IP legs is different, so there will not be any issue in one...

marmugam commented on H323 failover between two routers in IP Telephony 4 years ago

Hi,This is the call flow per my understanding, correct me if I m wrong:-IP phone--CCM---h225----...

marmugam commented on H323 failover between two routers in IP Telephony 4 years ago

++ OK, Looked into the Router log attached, Cant be MX timeout as Alerting is recevied @ 12:33:40...

marmugam commented on H323 failover between two routers in IP Telephony 4 years ago

HI,Sounds like Media Exchange timeout in CCM Service parameter (Mx timeout), Ideally it is 12...

marmugam commented on SIP trunk on CUCM 7 - T.38 Issues in IP Telephony 4 years ago

Hi,Are you sure,  it worked before with T38, as ATA186 doesn't support T38 or cisco fax relay. It...

marmugam commented on No Ringback heard on incoming calls form PSTN when transfered in IP Telephony 4 years ago

OK, looks like you got Sip trunk as well,  so best option here is to use the annuciator. As, in SIP...

marmugam commented on How to change DSCP value of Skinny KeepAliveMessage in IP Telephony 4 years ago

Can you attach the following logs, before 15 mins and after code yellow entry /exit.++ Detailed ccm...

marmugam commented on SIP trunk on CUCM 7 - T.38 Issues in IP Telephony 4 years ago

Hi,I got one side of call-leg from your description, but what is complete e2e call flow? Sonus----...

marmugam commented on No Ringback heard on incoming calls form PSTN when transfered in IP Telephony 4 years ago

hello there,Is this the call flow:-PSTN----CIsco GW---h225----CCM----IP phone--transfer ---IP phone...

marmugam commented on SRST, Immediate Busy in IP Telephony 4 years ago

++ Is it for analog phones hooked up to GW or IP phones homed to SRST GW ? And can you attach show...

marmugam commented on calls CFA to voicemail fails from SIP Trunk in IP Telephony 4 years ago

Can you make a test call and provide detailed CCM traces  with the calling details ??

marmugam commented on calls CFA to voicemail fails from SIP Trunk in IP Telephony 4 years ago

++ Callmanager sent 503 service unavailable with cause value 47, "Resource unavailable". Looks like...

Bio












marmugam's Stats

Points43
Discussion started 0
Answers marked as Correct 6
Endorsed 0
Content Rated 1