mat_rouch

Member Since: Dec 19, 2008

English
mat_rouch's Activity on Cisco Support Community
Currently displaying 45 results

mat_rouch has commented on ntp clock synchronization flapping continuously

1 month 3 weeks ago
I cannot remove the "nap master" command, since both of these routers...

mat_rouch has created ntp clock synchronization flapping continuously

1 month 3 weeks ago
I have a pair of 2951 routers that are acting as NTP servers for my internal...

mat_rouch has created A question about the part number for an ASA5525-X failover unit

9 months 3 days ago
I am looking at purchasing two ASA5525-X firewalls to be used as a...

mat_rouch has created voice qos config for switch uplinks

11 months 2 weeks ago
My network uses cisco IP phones (primarily model 7942) connecting to 2960...

mat_rouch has commented on Question about RPS2300 and 'redundancy" config on IOS router

1 year 1 month ago
To clarify, the 2951 router has an RPS-ADPTR-2921-51 module installed which...

mat_rouch has commented on Question about RPS2300 and 'redundancy" config on IOS router

1 year 1 month ago
To clarify, the 2951 router has an RPS-ADPTR-2921-51 module installed which...

mat_rouch has created Question about RPS2300 and 'redundancy" config on IOS router

1 year 1 month ago
We have a 2951 router connected to an RPS2300 remote power supply.  On the...

mat_rouch has created Can a zbf be used as an application proxy

1 year 3 months ago
By that I mean, can it it accept an incoming connection, then turn around and...

mat_rouch has commented on ZBF - List of what port numbers the "protocols" correspond to

1 year 9 months ago
Thanks Alain, that's what I was looking for.jcarvaja, the command you...

mat_rouch has commented on ZBF - List of what port numbers the "protocols" correspond to

1 year 9 months ago
Felipe,That's kind of the reverse of what I am looking for.  I know that the...

mat_rouch has created ZBF - List of what port numbers the "protocols" correspond to

1 year 9 months ago
Can anyone point me to a list of ZBF protocol names that includes information...

mat_rouch has created WAP321 clustering question

1 year 10 months ago
I have two WAP321s at one of my offices.  They are in a cluster.  When an end-...

mat_rouch has commented on Strange problem with route selection when using eBGP and EIGRP

2 years 1 month ago
Milan, you were correct.  I adjusted the BGP weights per your recommendations...

mat_rouch has commented on Strange problem with route selection when using eBGP and EIGRP

2 years 1 month ago
I think you guys are correct.  I am implementing the changes you recommended...

mat_rouch has commented on Strange problem with route selection when using eBGP and EIGRP

2 years 1 month ago
Thanks for the replies.  I do need to retain the redistribution, since...

mat_rouch has created Strange problem with route selection when using eBGP and EIGRP

2 years 1 month ago
I have a mixed WAN environment with both eBGP and EIGRP routes.  The BGP routes...

mat_rouch has commented on Logging/Viewing dropped packets on Zone-Based Firewall

2 years 2 months ago
I added "ip inspect log drop-pkt" and it made no difference.  Is there...

mat_rouch has commented on Logging/Viewing dropped packets on Zone-Based Firewall

2 years 2 months ago
I am getting other logs sent to the syslog server, yes, just not the firewall-...

mat_rouch has created Logging/Viewing dropped packets on Zone-Based Firewall

2 years 2 months ago
I have a Zone-Based Firewall installation running on a 2911 router running...

mat_rouch has commented on Zone Based Firewall - changing rule order in policy-maps

2 years 2 months ago
OK, thanks for the info.

mat_rouch has commented on Zone Based Firewall - changing rule order in policy-maps

2 years 2 months ago
OK, good to know.  One other question: I have tried using CCP to manage my ZBF...

mat_rouch has created Zone Based Firewall - changing rule order in policy-maps

2 years 2 months ago
I have a questions about configuring ZBF at the command line. I need to insert...

mat_rouch has commented on Attempting to use SNMP v3 between 2900 router and SpiceWorks

2 years 5 months ago
Got it.  I had control-plane management defined on the router and had not...

mat_rouch has created Attempting to use SNMP v3 between 2900 router and SpiceWorks

2 years 5 months ago
I am attempting to set up snmp v3 monitoring of my 2900 series routers from the...

mat_rouch has commented on License requirement for Zone-Based Firewall

2 years 6 months ago
That's what I needed to know, thanks.

mat_rouch has created License requirement for Zone-Based Firewall

2 years 6 months ago
I am looking to implement Zone-Based Firewall on some 2900 series routers (2911...

mat_rouch has created Basic questions about downloading updates and smartnet licensing

2 years 9 months ago
I have been trying to get a definitive answer to these questions by browsing...

mat_rouch has commented on Question about multiple certificates on an ASA

2 years 9 months ago
Thanks Daniel, that was exactly what I needed to know.Thanks for the link,...

mat_rouch has created Question about multiple certificates on an ASA

2 years 9 months ago
I have an ASA5540 running 8.4(3) which has CA and identity certificates from...

mat_rouch has commented on question about nat on asa v8.0 with same-security interfaces

3 years 1 month ago
I had been under the impression that if there was no nat or static that matched...

mat_rouch has commented on question about nat on asa v8.0 with same-security interfaces

3 years 1 month ago
I had been under the impression that if there was no nat or static that matched...

mat_rouch has created question about nat on asa v8.0 with same-security interfaces

3 years 1 month ago
I want to make sure I understand how the nat requirements work on asa v8.0 when...

mat_rouch has created Quick question re: migration of nat exemption from asa pre-8.2 to post-8.2

3 years 2 months ago
I am going through http://www.cisco.com/en/US/docs/security/asa/asa83/upgrading...

mat_rouch has commented on Question re: failover licensing on 5510 8.0(4)

3 years 2 months ago
Thanks for the reply.  Yes, the ip conflict part makes sense.  That should not...

mat_rouch has commented on Question re: failover licensing on 5510 8.0(4)

3 years 2 months ago
Thanks for the reply.  Yes, the ip conflict part makes sense.  That should not...

mat_rouch has created Question re: failover licensing on 5510 8.0(4)

3 years 2 months ago
We have a set of ASA5510s configured as an active/standby HA pair.  THey show...

mat_rouch has commented on Question about static identity nat when migrating ASA from pre-8.3 to 8.3

3 years 2 months ago
Thanks for the answer and the link.-Mathew

mat_rouch has commented on Question about static identity nat when migrating ASA from pre-8.3 to 8.3

3 years 2 months ago
Thanks for the answer and the link.-Mathew

mat_rouch has created Question about static identity nat when migrating ASA from pre-8.3 to 8.3

3 years 2 months ago
I have looked over the documentation for the ASA 8.3 migration and there is...

mat_rouch has commented on Problem with NAT statements disappearing on 5540 8.4(3)

3 years 2 months ago
okay, so presumably to remove the "any" we'd need a nat statement for each...

mat_rouch has commented on Problem with NAT statements disappearing on 5540 8.4(3)

3 years 2 months ago
okay, so presumably to remove the "any" we'd need a nat statement for each...

mat_rouch has created Problem with NAT statements disappearing on 5540 8.4(3)

3 years 2 months ago
Unusual problem with as ASA5540 running 8.4(3).  There are several NAT...

mat_rouch has created Encrypted GRE tunnel changes state to reset/down upon IOS upgrade

4 years 2 weeks ago
I installed a 1941 router with an encrypted GRE tunnel yesterday.  The router...

mat_rouch has created Looking for equivalent to "snmp-server ifindex persist" for IPSec tunnels

4 years 2 weeks ago
I have a cisco 3945 router on which I am attempting to monitor several IPSec...

mat_rouch has created question regarding index fields in ipsec flowmib on 3945 router

4 years 1 month ago
I have a 3945 router which I am monitoring via SNMP.  I would like to use the "...

Bio












mat_rouch's Stats

Points5
Discussion started 22
Answers marked as Correct 0
Endorsed 0
Content Rated 7