pablo.nxh

Member Since: Jul 19, 2010

English
pablo.nxh commented on ACE: SourceIP-based Loadbalancing in Application Networking 2 years ago

Hi Anke,This is doable with your ACE but depends on how the restricted URL looks like, for the...

pablo.nxh commented on ACE dropping packets in Application Networking 2 years ago

Hi Nishchay,What do you mean by dropping packets? The capture doesn't tell much as it seems it was...

pablo.nxh commented on Issues With ACE 4710 Config in Application Networking 2 years ago

Hi Wes,Do you have a sketch of your current setup? I feel there's a switching connectivity issue...

pablo.nxh commented on ACE Security design question in Application Networking 2 years ago

Dave,I don't see a problem with your new design; just keep in mind you'll be moving to what's...

pablo.nxh commented on ACE Security design question in Application Networking 2 years ago

Hi Dave,Personally I don't see any flaw on doing this. Assuming that currently your SMTP traffic is...

pablo.nxh commented on ACE 4710 Issue in Application Networking 2 years ago

Hi Ali,I'd check on the status of the rserver/serverfarm since you configured a TCP probe under the...

pablo.nxh commented on ACE: insert-http X-Forwarded-For header-value "%is" in Application Networking 2 years ago

Hi Kaneswaran,The source IP will still be seen as coming from your NAT IP otherwise you'll end up...

pablo.nxh commented on Cisco ACE - Exempt HTTP URL from SSL Offloading in Application Networking 3 years ago

Hi Masif,In case you have not gotten assistance with this one, you just need to specify the...

pablo.nxh commented on ACE SSL end-to-end in Application Networking 4 years ago

Hi Dave,Using the cert and key pair in the ACE and the backend server at the same time shouldn't be...

pablo.nxh commented on CSS11500 SSL handling question for multiple url/FQDNs with the same ip address in Application Networking 4 years ago

Hi Tim,Unfortunately this is not possible; you can't associate multiple certificates to a single...

pablo.nxh commented on CSS Strange Behavior in Application Networking 4 years ago

Hi Gilles,You could monitor with 3 or 4 commands to check what  services are receiving the...

pablo.nxh commented on CSS Strange Behavior in Application Networking 4 years ago

Hello,Do you see this problem after the session is being established and its been working for a...

pablo.nxh commented on ACE ONE One Arm Mode in Application Networking 4 years ago

Hi Green,You need to add the "POL_SEC_20 and POL_SEC_FW" policies also under the interface VLAN 20...

pablo.nxh commented on ACE: Log in apache real server appear with nat ip address in Application Networking 4 years ago

Hi Laurent,The only workaround would be to do the SSL offloading first on the ACE and have it...

pablo.nxh commented on CSS 11503 - server-to-server load balancing in Application Networking 4 years ago

Hi Ryan,The config looks in good shape, the only thing is that since you'll be doing LB from/to a...

pablo.nxh commented on HTTP-Cookie sticky not working. in Application Networking 4 years ago

Hello there,A couple of questionsHow did you find out this is not working? Cookie checking on FF...

pablo.nxh commented on ACE 4710 Url Rewrite. in Application Networking 4 years ago

Hi,Basically this is done with a HTTP redirection, in your case (assuming your real config has the...

pablo.nxh commented on need help with http to http url redirect configuration on ACE. in Application Networking 4 years ago

Hello Ravi,Action-list is for more specific scenarios when you need to modify something within the...

pablo.nxh commented on SSL Offload on ACE to SSL Serverfarm in Application Networking 4 years ago

Hi Jason,You should seeing something with this command: ACE-4710A/Admin# show sticky cookie-insert...

pablo.nxh commented on SSL Offload on ACE to SSL Serverfarm in Application Networking 4 years ago

Hi Jason,It's called End-to-End SSL and if you already have SSL offloading working then you're...

pablo.nxh commented on CSS 11501 - L5 rules over SSL? in Application Networking 4 years ago

Hi, Problem is related to the layer 5 behavior when it comes to HTTP 1.1. The config seems to be in...

pablo.nxh commented on ACE 4710 and insert-http x-forward header-value "%is" in Application Networking 4 years ago

Hi,Basically what you did with that change was to force the ACE to add an extra header inside the...

pablo.nxh commented on Weak ciphers in Application Networking 4 years ago

Hi Jeff,As you mentioned you need to create a  parameter-map type SSL and then add it under your...

pablo.nxh commented on ACE load balance based on Source IP Address in Application Networking 4 years ago

Hi,Just to put some config sample that might help you to get this done.First create the new...

pablo.nxh commented on ACE Port redirection in Application Networking 4 years ago

Hello,Just change the VIP to listen on www and set the port number right next to the rserver under...

pablo.nxh commented on CSS 11500 Responds for any Port in Application Networking 4 years ago

Hi Scott,The only thing that comes to mind is that you have a content rule VIP with a broad mask...

pablo.nxh commented on ACE: URL redirect - not working in Application Networking 4 years ago

Hi Gavin,In this case your backend servers have configured this redirection in the HTTP server...

pablo.nxh commented on ACE: URL redirect - not working in Application Networking 4 years ago

Hi Gavin,You must add "%p" after the forward slash, like this:rserver redirect url.test.com-rd ...

pablo.nxh commented on Issue with Source NAT on ACE in Application Networking 4 years ago

Hi Karthik,NAT is not applied in order based on lower/higher ID under the interface, in this case...

pablo.nxh commented on ACE multiple loadbalancing policies help in Application Networking 4 years ago

Hey Laurent,In this case I'd say fortunately, this will make things way easier =)Long story short,...

pablo.nxh commented on ACE multiple loadbalancing policies help in Application Networking 4 years ago

Hi Laurent,Thanks for trying that out. Something that just called my attention is this:class-map...

pablo.nxh commented on ACE multiple loadbalancing policies help in Application Networking 4 years ago

Hi Laurent,Thanks for the info. From the configuration I noticed a couple of things missing, 1. The...

pablo.nxh commented on ACE multiple loadbalancing policies help in Application Networking 4 years ago

Hi LaurentI'm thinking this is just a matter of how your policies and classes are applied on that...

pablo.nxh commented on CCS11503 and NAT in Application Networking 4 years ago

Hi Fernando, You can do this enabling ACL's on the CSS and making them NAT only the specific...

pablo.nxh commented on Delete Licence on CISCO ACE 4710 in Application Networking 4 years ago

HI Liepold,So when you do a "show license brief" on that box you don't get anything? Tnx__ __ Pablo

pablo.nxh commented on Best practice SSL End-to-End in Exchange 2010 CAS loadbalancing in Application Networking 4 years ago

Hi Dion,You can open up a case with TAC to have that template reviewed and confirm if the problem...

pablo.nxh commented on Delete Licence on CISCO ACE 4710 in Application Networking 4 years ago

Hi Liepold,You can enter the command:ACE# show license briefThat should show you any license...

pablo.nxh commented on SSL Offloading not working right in Application Networking 4 years ago

I think I spotted another problem in your configuration your HTTPS VIP is using a /24 mask instead...

pablo.nxh commented on SSL Offloading not working right in Application Networking 4 years ago

Hello,In order for SSL termination to work correctly you need to specify the clear text port used...

pablo.nxh commented on HTTP and HTTPS on identical TCP port in Application Networking 4 years ago

Hi Jonagy,It can be done but a little bit different as you presented: - If HTTP then use pool A- If...

pablo.nxh commented on CSS http keepalive failes even though server responds in Application Networking 4 years ago

Hi Kurt,What WebNS version are you running on that CSS? Do you have any other "class A" keepalives...

pablo.nxh commented on IIS Hostheader in Application Networking 4 years ago

Hi Karthik,This is actually "easier" on the ACE as you don't need a scripted probe: Just do...

pablo.nxh commented on ACE Software Support in Application Networking 4 years ago

Hi David,Latest supported version for ACE10/20 is A2(3.5). As you mentioned versions 4 and 5 are...

pablo.nxh commented on Application timeout on ACE in Application Networking 4 years ago

Hi,Your problem might be related to multiple factors, it would be great if you can share your...

pablo.nxh commented on Load Balance https based on url in Application Networking 4 years ago

Hi John,If you want to do the offload in the ACE also called SSL termination, it is a two step...

pablo.nxh commented on Load Balance https based on url in Application Networking 4 years ago

Hi John,Unfortunately this can't be done unless you configure the ACE to offload your SSL...

pablo.nxh commented on ACE 4700 not load balancing in Application Networking 4 years ago

Hi Bruce,From your description seems like the problem might be related to NAT or a Proxy in front...

pablo.nxh commented on IOS upgrade for ACE10-6500-K9 in Application Networking 4 years ago

Hello Ahmed,Unfortunately version 4.x and version 5.x are only supported on the latest hardware...

pablo.nxh commented on CSS Port redirection in Application Networking 4 years ago

Hi,Your server/app might be asking the client to open a connection in port 3636, additionally to...

pablo.nxh commented on CSS Port redirection in Application Networking 4 years ago

Hi, What you need to do here is actually configure the port under the service itself and change to...

Bio

Cisco Data Center Application Services Support Specialist










pablo.nxh's Stats

Points247
Discussion started 1
Answers marked as Correct 41
Endorsed 0
Content Rated 12