Peter Paluch

Member Since: Jul 29, 2005

English
Peter Paluch's Activity on Cisco Support Community
Currently displaying 50 results

Peter Paluch has commented on ppp chap hash value.

17 hours 21 min ago
Hi Evgeniy, The details of PPP CHAP authentication can be found in RFC 1994 as...

Peter Paluch has commented on Different RD value for same VPN

1 week 3 days ago
Hi Arup,Yes, absoutely - you can use different RD for the same VRF on different...

Peter Paluch has commented on How to get Two Peer Routers Authenticated w.o PPP

1 week 3 days ago
Hi Ashish,There do not seem to be many alternatives left if you do not want to...

Peter Paluch has commented on how many trunks are allowed in a switch ?

3 weeks 2 hours ago
Jon,I hear what you are saying: If the switch can guarantee - using other means...

Peter Paluch has commented on how many trunks are allowed in a switch ?

3 weeks 12 hours ago
Jon,So the lookup using the vlan ID is only for optimisation and nothing else ?...

Peter Paluch has commented on how many trunks are allowed in a switch ?

3 weeks 12 hours ago
Hi Jon,But doesn't your second point in the last post somewhat contradict...

Peter Paluch has commented on %SPANTREE-2-LOOPGUARD_BLOCK

3 weeks 13 hours ago
Hi,I apologize for dropping out from this thread over the past few weeks - they...

Peter Paluch has commented on How to send multicast message from PC to router to start multicast

3 weeks 13 hours ago
Frank,You are very much welcome. Please keep me posted whether this worked for...

Peter Paluch has commented on MST with multiple regions problem

3 weeks 13 hours ago
Dario,Whether it's reasonable to have your network consist of 34 different...

Peter Paluch has commented on How to send multicast message from PC to router to start multicast

3 weeks 13 hours ago
Hi Frank,You are welcome.To sum up basic configuration rules for your network...

Peter Paluch has commented on how many trunks are allowed in a switch ?

3 weeks 13 hours ago
Hi Jon,However on thinking about it using the mac address table wouldn't...

Peter Paluch has commented on Setup Logging Facility local 6 but still getting messages on Local 0

3 weeks 14 hours ago
Hi,Are you sure that this message indeed comes from the 2851 router? It's...

Peter Paluch has commented on How to send multicast message from PC to router to start multicast

3 weeks 14 hours ago
Frank,To receive the multicast stream, you can use VLC again. On the end PC,...

Peter Paluch has commented on How to send multicast message from PC to router to start multicast

3 weeks 16 hours ago
Hi Frank,I have personally used the VideoLAN Client (VLC) to do streaming, and...

Peter Paluch has commented on how many trunks are allowed in a switch ?

3 weeks 16 hours ago
Dear friends,Please allow me to join and add my two cents.Q1) You are asking if...

Peter Paluch has commented on How to send multicast message from PC to router to start multicast

3 weeks 16 hours ago
Frank,To send, or better said, to stream a multicast from a PC, you just need...

Peter Paluch has commented on Q- Is it possible to reuse VLANs on different interfaces of router ?

3 weeks 17 hours ago
Hi Reza and Ashish,Reza, your answer is perfectly right for basic switches...

Peter Paluch has commented on Two tunnels, two different mtu values, no OSPF adjacency

3 weeks 2 days ago
Hi Warren,According to this thread:https://supportforums.cisco.com/discussion/...

Peter Paluch has commented on %SPANTREE-2-LOOPGUARD_BLOCK

1 month 4 days ago
Hi,Just wondering - is it possible you have something similar configured on any...

Peter Paluch has commented on %SPANTREE-2-LOOPGUARD_BLOCK

1 month 4 days ago
Hi,I do not think this is the root cause of the problem. You cannot stop root...

Peter Paluch has commented on multiple subnets under one vlan

1 month 5 days ago
Mohammed, As long as you have a single VLAN only, you will not reduce the...

Peter Paluch has commented on %SPANTREE-2-LOOPGUARD_BLOCK

1 month 5 days ago
Hi,I believe you need to discuss this with your ISP. What we can see here is...

Peter Paluch has commented on EIGRP metric calculation bug?

1 month 5 days ago
Vasilii, Paul, This is going to be a long and involved post so please bear...

Peter Paluch has commented on Port fast spanning tree

1 month 1 week ago
Hi Jon,If a portfast enabled port receives a BPDU it will transition to a...

Peter Paluch has commented on Best Practices for "bgp bestpath med missing-as-worst"?

1 month 1 week ago
Jon, Jose,Thank you both for your exquisite and insightful answers. Rated as...

Peter Paluch has commented on EIGRP metric calculation bug?

1 month 1 week ago
Hi Paul,Yeah, I have been shooting somewhat blindly here.Nonetheless, what you...

Peter Paluch has commented on RSTP in Stacking environment

1 month 1 week ago
Hi,In fact, when Switch B was master, Port 1/0/25 in SwitchA was elected as...

Peter Paluch has commented on Can I just switch out flash cards and boot to new config?

1 month 1 week ago
Hi,No need to apologize. This forum is all about asking questions, both for...

Peter Paluch has commented on Can I just switch out flash cards and boot to new config?

1 month 1 week ago
Hi,I do not quite understand the point of taking out the Compact Flash card...

Peter Paluch has commented on RSTP in Stacking environment

1 month 1 week ago
Hello,My personal feeling is that the delay is not related to the RSTP but...

Peter Paluch has commented on EIGRP metric calculation bug?

1 month 1 week ago
Hi Paul,What kind of EIGRP configuration are you using - EIGRP named mode, or...

Peter Paluch has commented on Nexus5548 BGP soft-reconfiguration inbound

1 month 1 week ago
Mattias,Okay... on IOS-based devices, there are two commands:show ip bgp...

Peter Paluch has commented on Nexus5548 BGP soft-reconfiguration inbound

1 month 1 week ago
Mattias, I may be answering a slightly different question but here goes: Are...

Peter Paluch has created Best Practices for "bgp bestpath med missing-as-worst"?

1 month 1 week ago
Dear friends,For a number of years, I have been under an impression that for...

Peter Paluch has commented on where is edge ports in this document

1 month 2 weeks ago
Hi,1. is the edge port means the port of distribution layer switch which...

Peter Paluch has commented on Communication between the secondary community VLANs hosts

1 month 2 weeks ago
Hi CF,If there is no promiscuous port/host defined, will the community VLAN...

Peter Paluch has commented on EIGRP Metric and UCLB Doc

1 month 2 weeks ago
Hi Carlos,I think you have posted this topic twice in two separate threads. You...

Peter Paluch has commented on neighbor allowas-in

1 month 2 weeks ago
Hello Ambrish,Imagine a scenario like this one: [[{"fid":"1118431","...

Peter Paluch has commented on RSTP conversion time takes twice time when user set path cost in both side of the link?

1 month 2 weeks ago
Hi Jon,Glad you liked it :) I tried to comprehend the vendor's answer but...

Peter Paluch has commented on Private-VLan Cisco 2975

1 month 2 weeks ago
Hi Eduardo,To prune a set of VLANs from a trunk manually, you should use the...

Peter Paluch has commented on Private-VLan Cisco 2975

1 month 2 weeks ago
Hi,What particular private VLAN you want your 2975 to talk to? Is it a...

Peter Paluch has commented on RSTP conversion time takes twice time when user set path cost in both side of the link?

1 month 2 weeks ago
Hi,I find the vendor's explanation strange, if not incompetent, in multiple...

Peter Paluch has commented on 886VA as a classical router (ethernet)

1 month 2 weeks ago
Hi Ondrej,You're welcome - and I am very glad it works!One thing I don...

Peter Paluch has commented on OSPF LSA type 4

1 month 2 weeks ago
Hi,Yes, that one is exactly the LSA-4.It does not denote "type 4" for...

Peter Paluch has commented on Classful Subnetting Vs CIDR/VLSM

1 month 2 weeks ago
Hi,In addition to Jon's reply (he's one of the greatest gurus around...

Peter Paluch has commented on OSPF LSA type 4

1 month 2 weeks ago
Hi, So I can only see LSA 4 using command -- show ip ospf database asbr-...

Peter Paluch has commented on OSPF LSA type 4

1 month 2 weeks ago
Hi Ashok,I am afraid you are not entirely correct.You are right that for E1...

Peter Paluch has commented on 886VA as a classical router (ethernet)

1 month 2 weeks ago
Hi Ondrej, I am sorry for replying lately. The primary problem I see with...

Peter Paluch has commented on Non existent route-map applied to redistribution

1 month 3 weeks ago
Hi,By its very nature, this is an incorrect configuration. Different IOS...

Peter Paluch has commented on Q-IN-Q. 3 tags

1 month 3 weeks ago
Anna,You can daisy-chain switches that are connected with dot1q-tunnel ports,...

Bio

Teaching networking topics at University of Zilina, Slovakia









  • Cisco Designated VIP

    2015 LAN, WAN





  • Cisco Designated VIP

    2014 WAN, LAN





  • Cisco Designated VIP

    2013 WAN, LAN





  • Cisco Designated VIP

    2012 WAN, LAN





  • Cisco Designated VIP

    2011 WAN, LAN









Peter Paluch's Stats

Points13616
Discussion started 47
Answers marked as Correct 1440
Endorsed 41
Content Rated 521