paul driver

Member Since: Jun 12, 2007

User Badges:
  • Red, 2250 points or more

English
paul driver commented on using multiple VTY access lists to restrict access in LAN, Switching and Routing 1 week ago

HelloFYI -  You CAN pick a vty line to access but again it would still be available for when you...

paul driver commented on QOS - DSCP Vaules in LAN, Switching and Routing 1 week ago

Hello Joseph i couldn't have put it any better that ! - lol 

paul driver commented on QOS - DSCP Vaules in LAN, Switching and Routing 1 week ago

Hello Please review below- probably explains it better than I was trying to- which makes me wonder...

paul driver commented on QOS - DSCP Vaules in LAN, Switching and Routing 1 week ago

HelloMy understanding is the Class Selector PHBs are values that can be understood by differential...

paul driver commented on Inbound and Outbount Traffic in BGP in WAN, Routing and Switching 1 week ago

HelloIf you HQ diagram is correct, I would expect sub-optimal routing and black holing of traffic...

paul driver commented on how can outside global hosts identify inside local ? in LAN, Switching and Routing 1 week ago

HelloBy NAT static translationsexample:ip nat inside source static 192.168.1.10  1.1.1.10 < ...

paul driver commented on NAT & IPSec where is a fail? in WAN, Routing and Switching 1 week ago

Hello R2 after NAT translation additionally match the packet to IPSec transform map. The packet...

paul driver commented on No valid authentication send key is available on interface NVI0 in WAN, Routing and Switching 1 week ago

Hello glad to hear that ! please mark the thread as answered so to assist others in the future  res...

paul driver commented on 802.1x supplicant on 819 router not working in WAN, Routing and Switching 1 week ago

Hello Is this supplicant dot1x compatible? Also you seem to have a quite a short timeout period for...

paul driver commented on No valid authentication send key is available on interface NVI0 in WAN, Routing and Switching 1 week ago

Hello You have ospf authentication enabled globally all interfaces. but I only see the digest key...

paul driver commented on Static NAT fails to continue NATing on 3925 in WAN, Routing and Switching 2 weeks ago

Hello Not sure I see any benifits of that? Unless you want to segregate between the vlans then you...

paul driver commented on Static NAT fails to continue NATing on 3925 in WAN, Routing and Switching 2 weeks ago

HelloCan you clarify, Is this an intranet web srv or is it should to be accessed from the internet...

paul driver commented on BGP One Router Two ISP Failover in WAN, Routing and Switching 2 weeks ago

HelloAs this sounds like you have just the one router connecting to two ISP's? You don't mention if...

paul driver commented on How to change the next-hop address of BGP learned routes to its DHCP/PPPoE server gateway in WAN, Routing and Switching 2 weeks ago

Hello Georg it won't as the ebgp routes are more specific - Pbr or other related statics would work...

paul driver commented on How to change the next-hop address of BGP learned routes to its DHCP/PPPoE server gateway in WAN, Routing and Switching 2 weeks ago

Hello Because your only default route via dhcp has an admin distance of 254 and those ebgp prefixes...

paul driver commented on How to change the next-hop address of BGP learned routes to its DHCP/PPPoE server gateway in WAN, Routing and Switching 2 weeks ago

Hello R1-R2 are ebgp peering and R2 is also receiving an dynamic addressing from R3.If you trying...

paul driver commented on 2 ISP + NAT (some DHCP, some static) in WAN, Routing and Switching 2 weeks ago

HelloAs your router will have connected interfaces to these ISPs , You shouldn't have to use two...

paul driver commented on Port flapping with WAPs on 2960x switch in LAN, Switching and Routing 2 weeks ago

Hello Try hardcoding speed/duplex settings,enable stp portfast.Turn off any control traffic not...

paul driver commented on 6509-E- high peak ulitisation in LAN, Switching and Routing 2 weeks ago

Hello Thanks for the link, This seems a viable suggestion although it I am thinking it must be more...

paul driver commented on NAT configration in LAN, Switching and Routing 3 weeks ago

Hello pings from 192.168.1.0 to 192.168.2.0 is working This is correct...

paul driver commented on NAT configration in LAN, Switching and Routing 3 weeks ago

Hello NbnampWe seem to be going around in circles here -  Given the topology you provided both NAT...

paul driver commented on NAT configration in LAN, Switching and Routing 3 weeks ago

HelloFor option 2 - Did you remove the static from the FS and change its DG to point to the 1841?...

paul driver commented on NAT configration in LAN, Switching and Routing 3 weeks ago

Hello i have already provided those - Please review them and select either one to use  res paul

paul driver commented on NAT configration in LAN, Switching and Routing 3 weeks ago

Hello Any static host translation( inside/outside)  doesn't require an acl for which NAT refers to....

paul driver commented on NAT configration in LAN, Switching and Routing 3 weeks ago

Hello Remove the static route from FS just let it use its DG add the static nat as suggested and...

paul driver commented on NAT configration in LAN, Switching and Routing 4 weeks ago

HelloI was on the understanding you couldn't reach host C from internal lans - however this isn't...

paul driver commented on NAT configration in LAN, Switching and Routing 4 weeks ago

HelloSounds good, It maybe you could utilize Domain-less NAT instead but before to that can you...

paul driver commented on Conflicting EIGRP routes being advertised causing outage in LAN, Switching and Routing 4 weeks ago

Hello If the initial switchover was successful it quite perplexing as to why is started to fail....

paul driver commented on NAT configration in LAN, Switching and Routing 4 weeks ago

Hello may I suggest if applicable to attach a small 4-8 port unmanaged switch and relocate  all 3...

paul driver commented on NAT configration in LAN, Switching and Routing 4 weeks ago

Hello So the SP has the same address range on two separate interfaces?Is this bridged by any chance...

paul driver commented on ISIS does not advertise prefix of passive interface on ASR 03.10.00.S in WAN, Routing and Switching 4 weeks ago

Hello Enabling passive interface shouldn't lose you a prefix in the routing table, Can you...

paul driver commented on What happens when you overheat a Cisco 2800 in WAN, Routing and Switching 4 weeks ago

Hello It would have to be quite an high temperature to overheat , I have once was privy to a...

paul driver commented on PAYCLOCK BOX AND ARP in WAN, Routing and Switching 4 weeks ago

HelloHow are you suppose to administer these devices? What other means of connecting to this device...

paul driver commented on NAT configration in LAN, Switching and Routing 4 weeks ago

Hello Humm this should work unless we are missing something! As stated I see the SP-FS and...

paul driver commented on NAT configration in LAN, Switching and Routing 4 weeks ago

HelloFile serverLooks like the SP rtr interface, files server and Cisco 1841 are on the same...

paul driver commented on NAT in WAN, Routing and Switching 1 month ago

Hello Just like to add you can utilize Domain-less NAT ( NVI NAT) which differs from Domain based...

paul driver commented on Finding out the OSPF areas in a network in LAN, Switching and Routing 1 month ago

Hello Review this excellent CSC documentation on such a mater:https://sreading-and-understanding-...

paul driver commented on CBWFQ in non congestion network in LAN, Switching and Routing 1 month ago

Hello if your hitting your max CIR then having a shaped policy is important so you don't...

paul driver commented on PAYCLOCK BOX AND ARP in WAN, Routing and Switching 1 month ago

Hello So you do have connectivity between your inside vlans and dmz vlan but just not to this...

paul driver commented on CBWFQ in non congestion network in LAN, Switching and Routing 1 month ago

Hello QOS is only applicable to a congested network if you don't experience any performance issues...

paul driver commented on OSPF adjaceny and route learning in WAN, Routing and Switching 1 month ago

Hello if you don't need ospf to form adjecency on vlan 104 then yes make that svi passive res paul

paul driver commented on Cisco Catalyst 3K QinQ in WAN, Routing and Switching 1 month ago

Hello try applying cdp/vtp  res paul

paul driver commented on OSPF adjaceny and route learning in WAN, Routing and Switching 1 month ago

Hello Looks like you have ospf enabled on all theses vlans which seems unnecessary, If you dont...

paul driver commented on Switch VLAN Multicast Operation in LAN, Switching and Routing 1 month ago

Hello Does the M/C need to be routed, Its not clear if it does or not?If not, Have you tried...

paul driver commented on Cisco Catalyst 3K QinQ in WAN, Routing and Switching 1 month ago

Hello What L2 protocol are you suing?sh l2protocol-tunnel interface gig1/0/3int gig1/0/3l2protocol-...

paul driver commented on Catalyst 2960X / No PoE on some ports in LAN, Switching and Routing 1 month ago

Hello Unfortunately  it seems the port is faulty-  This has been discussed  a few time on here have...

paul driver commented on BGP return traffic issu in WAN, Routing and Switching 1 month ago

Hello actually i have 3 ISP links it is connected on single router In this scenario I wouldn't...

paul driver commented on Loosing EIGRP neighborship in LAN, Switching and Routing 1 month ago

Hello I changed the bandwidth on R7's fa1/3 to so the route to R1's 1.1.1.1 will take R7's Fa1/2...

paul driver commented on bgp multipath load balancing in WAN, Routing and Switching 1 month ago

HelloTry applying MED incoming of preferred peers, Doing so should give you the two multipaths you...

Bio

Originated from a systems administrative background, mainly working with active directory infrastructure, then I fell into networking and started to support manufacturing LAN/MAN campus networks.

Currently work for AT&T on Healthcare and Civil nuclear accounts.

User Badges:
  • Badge.
    Red
    2250 points or more
  • Badge.
    Community Spotlight Award

    Members Choice June 2013

  • Badge.
    Community Spotlight Award

    Mobile App Contributor March 2013

  • Badge.
    Cisco Designated VIP

    2016 LAN, WAN

  • Badge.
    Cisco Designated VIP

    2015 LAN, WAN

  • Badge.
    Cisco Designated VIP

    2014 LAN

paul driver's Stats

Points2956
Discussion started 11
Answers marked as Correct 292
Endorsed 6
Content Rated 42