pennautomotive

Member Since: Jan 01, 2010

English
pennautomotive commented on SIP Provider Recommendations? in Voice Systems 2 years ago

Check out nexVortex. (nexvortex.com) We have used them for several years with our UC560. They have...

pennautomotive commented on Need SIP provider that will allow me to send SNR caller-id in Voice Systems 3 years ago

Take a look at NexVortex. If you decide to use their service let them know Jordan Feldman of Penn...

pennautomotive commented on Problems with 9971 and SIP Trunk in Voice Systems 4 years ago

Well I had the same problem and that's what I ended up doing. I honestly forget what I pointed it...

pennautomotive commented on Problems with 9971 and SIP Trunk in Voice Systems 4 years ago

Take a look at your config. You will notice that now somewhere in the config you will see code that...

pennautomotive commented on Problems with 9971 and SIP Trunk in Voice Systems 4 years ago

I understand. I have had this same problem. What IP address does your firewall point to internally?...

pennautomotive commented on Problems with 9971 and SIP Trunk in Voice Systems 4 years ago

Does your UC happen to be behind another firewall? Sent from Cisco Technical Support iPhone App

pennautomotive commented on Jabber and Cisco AnyConnect VPN in Voice Systems 4 years ago

Brian I have the same issue and I believe it is by design. I have a question for you though. What...

pennautomotive commented on uc500 and cyberdata paging gateway in Voice Systems 4 years ago

Also it is worth mentioning that for me the intercom itself would not show up as registered through...

pennautomotive commented on uc500 and cyberdata paging gateway in Voice Systems 4 years ago

I have been experienceing the same issue. I have been unable to get a CyberData intercom to...

pennautomotive commented on UC 500 Software Packs in Voice Systems 4 years ago

I have partipated in other betas for the UC500 platform. Should I shoot Anna an email to ask for...

pennautomotive commented on Adding 1 to all outgoing calls in Voice Systems 4 years ago

That's perfect. Thank you very much.Sent from my iPhone

pennautomotive commented on Adding 1 to all outgoing calls in Voice Systems 4 years ago

Do you mind providing an example? Even sudo-code would be appreciated.

pennautomotive commented on Download rights for IPCC with UC560 system? in Voice Systems 4 years ago

I just also want to note that I am also noticing the same behavior. Also with other Cisco products....

pennautomotive commented on UC 500 Software Packs in Voice Systems 5 years ago

I just wanted to point this out to anyone that doesn't frequent the UC 500 Software Packs page. The...

pennautomotive commented on POTS Line High Voltage in Voice Systems 5 years ago

The POTS phone line, with all phones on-hook, should measure around 48 volts DC. Taking a...

pennautomotive commented on Is there a hunt group type for this? in Voice Systems 5 years ago

Thanks for the suggestions I will try it out. I have had the newest CCA for months now since it was...

pennautomotive commented on Is there a hunt group type for this? in Voice Systems 5 years ago

There are some things I use the CCA for. However, areas in the CLI that I know the CCA doesn't...

pennautomotive commented on Is there a hunt group type for this? in Voice Systems 5 years ago

5006 is a GDM

pennautomotive commented on Is there a hunt group type for this? in Voice Systems 5 years ago

I know how to configure this using the CCA. It just often doesn't get the job done and gets in the...

pennautomotive commented on Smart CallConnector Toolbar dialling in Voice Systems 5 years ago

I added 9 in the dial out number box on all of our Windows 7 machines andthey all work fine.On 11/...

pennautomotive commented on Smart CallConnector Toolbar dialling in Voice Systems 5 years ago

Hey, We have to dial a 9 out now to call someone, and we use the free call connector. We just added...

Bio












pennautomotive's Stats

Points0
Discussion started 8
Answers marked as Correct 0
Endorsed 0
Content Rated 4