ppflaum12

Member Since: Dec 11, 2005

English
ppflaum12 commented on UCS dashboard not updating inventory since 2.2.1b upgrade in Unified Computing 2 years ago

Thanks ... running it now. I see some great improvements. Still need user labels added to both...

ppflaum12 commented on UCS dashboard not updating inventory since 2.2.1b upgrade in Unified Computing 2 years ago

Actually, the only thing I found missing, that I need, is the user labels. Also, there doesn't seem...

ppflaum12 commented on Nexus 5548 Optimal Fail Over / Convergence design in Server Networking 4 years ago

If VIO supports lacp I would prefer to see a vpc from the 2k to the VIO to eliminate Arp changes...

ppflaum12 commented on UCS Port Channeling in Unified Computing 4 years ago

You should add trunk to your portfast command and as the previous person said you should remove the...

ppflaum12 commented on ANM Virtual Appliance - SCP, TFTP or SFTP Support in Application Networking 4 years ago

This would be a good feature to addSent from Cisco Technical Support iPhone App

ppflaum12 commented on LMS 3.2 Dropping the syslog as queue is full in Network Management 5 years ago

Did you ever get this fixed? ... I am having the same issue.

ppflaum12 commented on LMS 3.2 Campus Manager in IP Telephony 5 years ago

I am having the same issue ... any updates?

ppflaum12 commented on Authentication failed after boot for 2 or 3 minutes in LAN, Switching and Routing 5 years ago

Thanks I appreciate the response ... now to find out why this is normal and if it can be turned off.

ppflaum12 commented on Authentication failed after boot for 2 or 3 minutes in LAN, Switching and Routing 5 years ago

thanks for the info ... can you clarify why this happens? i.e. if I have the device configured for...

ppflaum12 commented on Authentication failed after boot for 2 or 3 minutes in LAN, Switching and Routing 5 years ago

this can be duplicated on a 4510, 3750  etc ... or even if it is not connected to the network we...

ppflaum12 commented on Authentication failed after boot for 2 or 3 minutes in LAN, Switching and Routing 5 years ago

we are using tacacs ... on a L2 switch. Management is on vlan 1...

ppflaum12 commented on N5K vPC Keepalive link and management concerns in Other Data Center Subjects 6 years ago

Do you have to use a seperate svi? Or could you use vlan 1 in your configuration?

ppflaum12 commented on Moving from CSM to ACE in Application Networking 6 years ago

you don't need the gateway ... just the mac-sticky enable

Bio












ppflaum12's Stats

Points0
Discussion started 3
Answers marked as Correct 0
Endorsed 0
Content Rated 0