Pushpendra Yadav

Member Since: Sep 19, 2011

English
Pushpendra Yadav's Activity on Cisco Support Community
Currently displaying 35 results

Pushpendra Yadav has commented on Packet Capture for VPN traffic

7 months 1 week ago
capture CAP_VPN type raw-data interface INSIDE [Capturing - 0 bytes] ...

Pushpendra Yadav has commented on Packet Capture for VPN traffic

7 months 1 week ago
Hi David, Done but still no traffic. Logs shows the traffic but not packet...

Pushpendra Yadav has commented on Packet Capture for VPN traffic

7 months 1 week ago
I tried but still [Capturing - 0 bytes]

Pushpendra Yadav has created Packet Capture for VPN traffic

7 months 1 week ago
Hi Team, Please help me to set ACL and capture for Remote Access VPN...

Pushpendra Yadav has commented on Blocking ICMP from WAN on Cisco 3560

1 year 10 months ago
Ah, Yes I understand.And here is working configurationinterface Vlan300 ip...

Pushpendra Yadav has commented on Blocking ICMP from WAN on Cisco 3560

1 year 10 months ago
I want to allow ICMP only from 5.5.5.5 and block for all.

Pushpendra Yadav has commented on Blocking ICMP from WAN on Cisco 3560

1 year 10 months ago
Thanks,but Allowing permit ip any any will open all ports except icmp. That...

Pushpendra Yadav has created Blocking ICMP from WAN on Cisco 3560

1 year 10 months ago
Hi,I am using Cisco Switch as DMZ Switch. I want to block ICMP packets from...

Pushpendra Yadav has created Commands to check Capacity/Bandwidth between Site to Site VPN Tunnel

1 year 10 months ago
Hi,How can we check Capacity/bandwidth between End A to End B of site to site...

Pushpendra Yadav has commented on How to check port mirroring is working or not?

1 year 11 months ago
install Wireshark on your system. Connect laptop on span port and then start...

Pushpendra Yadav has commented on How to configure port for Hypervisor

1 year 11 months ago
Thanks,Problem solved.Issue was native vlan was also in same group.So this...

Pushpendra Yadav has commented on How to configure port for Hypervisor

1 year 11 months ago
Hi Reza,VLANs are created on Cisco Switch. but yes on ESX Server there are VMs...

Pushpendra Yadav has created How to configure port for Hypervisor

1 year 11 months ago
Hi Guys,Our system Administration team create 1 hypervisor VMware server. Now...

Pushpendra Yadav has commented on How to communication 6506 to ASA if DMZ switch is in middle ?

1 year 11 months ago
Resolved.Thanks

Pushpendra Yadav has commented on switch in dmz

1 year 11 months ago
No worries,Issue is resolved.Thanks

Pushpendra Yadav has commented on How to communication 6506 to ASA if DMZ switch is in middle ?

1 year 11 months ago
Guys,I am in kind of trouble so please if you can help me.Thanks

Pushpendra Yadav has commented on switch in dmz

1 year 11 months ago
Hey Guys,I have same type of issue please help.I have 1 DMZ Switch(2 VLANs,...

Pushpendra Yadav has created How to communication 6506 to ASA if DMZ switch is in middle ?

1 year 11 months ago
Hi Cisco Experts,Please assist me with this scenerio.I have 1 DMZ Switch(2...

Pushpendra Yadav has commented on Adding nonat statement disconnects Internet

2 years 2 months ago
Thanks Jouni,It works for me,I think ACLs on this time ACL was taken and no...

Pushpendra Yadav has commented on Adding nonat statement disconnects Internet

2 years 2 months ago
Okay,in that case, Can I use same ACL for different interfaces ?

Pushpendra Yadav has commented on Adding nonat statement disconnects Internet

2 years 2 months ago
but How does this make a difference as all Traffic goes for NAT0

Pushpendra Yadav has commented on Adding nonat statement disconnects Internet

2 years 2 months ago
Hi Jouni,Thats correct, I am facing this issue.reg"nat (nameif) 0 access-list...

Pushpendra Yadav has created Adding nonat statement disconnects Internet

2 years 2 months ago
Hi,I found very strange issue regarding L2L IPSec VPN tunnel.on ASA 5510 I have...

Pushpendra Yadav has created Remote Access VPN (IPSec) Configuration using FQDN

2 years 2 months ago
Hi Cisco Friends,We have dns server(only Internal IP) inside our network, right...

Pushpendra Yadav has commented on How to Configure Subrate t3/e3 Port on Cisco 3825

2 years 6 months ago
Well, encapsulation was missing. actually mismatching.we did correct at both...

Pushpendra Yadav has commented on How to Configure Subrate t3/e3 Port on Cisco 3825

2 years 6 months ago
(C3825-ADVIPSERVICESK9-M), Version 12.4(24)T7, RELEASE SOFTWARE (fc2)

Pushpendra Yadav has created How to Configure Subrate t3/e3 Port on Cisco 3825

2 years 6 months ago
Hi,Can you please how to configure T3/E3 Interface on Cisco 3825. It got 2 Co...

Pushpendra Yadav has commented on split-tunnel-policy tunnelall ?

2 years 11 months ago
Well I have Got the answer from Cisco Support.one OUTSIDE_NAT0 ACL was required...

Pushpendra Yadav has created split-tunnel-policy tunnelall ?

2 years 11 months ago
Hi,I Configured IPSec Remote Access.Now I want to send my all traffic using...

Pushpendra Yadav has created URL Working with Wireless but not with Wired

3 years 3 months ago
Hi All,I see Trace route Completes for Wired network but after destination IP I...

Pushpendra Yadav has commented on How to Copy IOS Image on Router from Internet

3 years 3 months ago
Hi Edison,This could Solve my problem if my machine had Public IP assigned but...

Pushpendra Yadav has commented on How to Copy IOS Image on Router from Internet

3 years 3 months ago
Hi Edison,This could Solve my problem if my machine had Public IP assigned but...

Pushpendra Yadav has created How to Copy IOS Image on Router from Internet

3 years 3 months ago
Hi Guys,I am sitting on Internet and want to copy IOS Image to router. I can...

Pushpendra Yadav has created Controlling Radius authentication

3 years 4 months ago
Hi All,We are using RSA as authentication server for Networking Devices...

Pushpendra Yadav has created RSA Soft Token issue with VPN Concentrator 3000

3 years 9 months ago
Hi All,We Upgraded RSA Hardware token to Soft token. But we face some issues...

Bio












Pushpendra Yadav's Stats

Points0
Discussion started 13
Answers marked as Correct 0
Endorsed 0
Content Rated 6