rais

Member Since: Nov 29, 2001

English
rais's Activity on Cisco Support Community
Currently displaying 50 results

rais has created EAP-list: How to Configure?

4 months 3 weeks ago
Hi , I am trying to configure EAP-TLS on an Aironet 1200, but can't seem to...

rais has commented on Same AS but different public per each country

1 year 3 months ago
It's perfectly fine to use the same AS in multiple countries/continents.AS...

rais has commented on Nexus OSPF cost calculation issue

1 year 3 months ago
I understand it's not working automatically as it should. As a band-aid or...

rais has commented on Send broadcast between vlans

1 year 3 months ago
Are you trying to send a broadcast message for the users to view on their...

rais has commented on Nexus OSPF cost calculation issue

1 year 3 months ago
Try configuring bandwidth using bandwidth command under interface....

rais has commented on How to connect two routers over multiple mobile operators

1 year 3 months ago
Good to know that GRE header is not required for VTIs. Apparently, OSPF is...

rais has commented on How to connect two routers over multiple mobile operators

1 year 3 months ago
DMVPN is an option where you can use:tunnel source <interface-name>for...

rais has commented on why in ospf , lsa refresh time is set as 30 minutes

1 year 3 months ago
Thanks Peter. Best Regards,Rais.

rais has commented on why in ospf , lsa refresh time is set as 30 minutes

1 year 3 months ago
RFC 2328 sets the LSRefreshTime under 'Architectural Constants' to 30...

rais has commented on BGP Path selection

1 year 5 months ago
That's correct. Once the advertisement is on both links it will follow the...

rais has commented on BGP Path selection

1 year 5 months ago
Once the eBGP connection has been brought up, the default behavior is to send...

rais has commented on IS-IS route leaking question

1 year 5 months ago
That's default for Cisco routers. L1/L2 will have complete knowledge of the...

rais has commented on IS-IS route leaking question

1 year 5 months ago
By default, L2 routes are not distributed into L1. Instead, closest L1/L2 can...

rais has commented on Bandwidth Aggregation for outbound connections

1 year 5 months ago
For voice, flow-based is better. Thanks.

rais has commented on Bandwidth Aggregation for outbound connections

1 year 5 months ago
You can create two default static routes with the same AD/metric. Router will...

rais has commented on Infuencing BGP routes learned via EIGRP

1 year 5 months ago
I don't understand your condition for not using prefix-lists. That seems to...

rais has commented on Infuencing BGP routes learned via EIGRP

1 year 6 months ago
What are you trying to achieve? Just a flexibility to apply policies based upon...

rais has commented on Help with understanding download speeds using large and small files

1 year 6 months ago
FTPing a large file will give enough time for the TCP window size to get...

rais has commented on BGP same AS # but in multiple sites

1 year 6 months ago
Yes, the service provider has to use as-override [or similar knob] to send...

rais has commented on iBGP Routing Issues

1 year 6 months ago
Apparently, your PE1 is not learning the 10.16/16 from eBGP peer.Thanks.

rais has commented on configure dns failover

1 year 7 months ago
If netsol is hosting your website, DNS failover is not your responsibility....

rais has commented on I need to see what VLAN-ids are present on a trunk interface. What debugs would help me achieve this?

1 year 8 months ago
 You may be able to do 'show mac-address-table' and see what VLANs...

rais has commented on What is MTU size? why we define in Tunnel or Routing interface? Why not in Switching port?

1 year 8 months ago
We define the Maximum Transmission Unit [MTU] on Tunnel/Routing interface so...

rais has commented on configuring WAN connections using PPP

1 year 8 months ago
Under serial interface you can use 'encapsulation ppp' command. ...

rais has commented on Advantages of using full mesh im core/distribution layer when not using VSS?

1 year 11 months ago
I think it means for accessing a resource we go directly to the resource with...

rais has commented on Advantages of using full mesh im core/distribution layer when not using VSS?

1 year 11 months ago
I think it means for accessing a resource we go directly to the resource with...

rais has commented on MPLS Traffic engineering - RSVP Calculation

1 year 11 months ago
Not sure about the first question. However, RSVP will create LSP over any path...

rais has commented on MPLS Traffic engineering - RSVP Calculation

1 year 11 months ago
Not sure about the first question. However, RSVP will create LSP over any path...

rais has commented on how LSP is established MPLS VPN

2 years 1 week ago
For MPLS VPN network, usually all PEs know how to get to other PE routers via...

rais has commented on how LSP is established MPLS VPN

2 years 1 week ago
For MPLS VPN network, usually all PEs know how to get to other PE routers via...

rais has commented on Confusion in SOO

2 years 3 months ago
ASN is used to avoid loops in BGP peerings. However, there are situations in...

rais has commented on Request and response in RIP

2 years 4 months ago
In this case, 1.1.1.0 will be the entry in IP address (4) field above.HTH.

rais has commented on frame-relay in real ISP network (Devices)

2 years 4 months ago
Any MPLS capable routers that support L2 VPNs/VPLS and frame-relay...

rais has commented on tunnel source dynamic command

2 years 4 months ago
Can you add 'tunnel mode gre multi' Thanks.

rais has commented on tunnel source dynamic command

2 years 4 months ago
For a tunnel you are supposed to supply the two terminating end points. Using...

rais has commented on VPLS Question

2 years 5 months ago
Absolutely. Thanks.

rais has commented on VPLS Question

2 years 5 months ago
P routers simply swap labels and need not be aware of vpls or other services....

rais has commented on Urgent:where to configure ip tcp adjust-mss 1452 in main FastEthernet interface or in subinterfaces?

2 years 5 months ago
Hi,I have a few question regarding ip tcp adjust-mss comand:1. Does this...

rais has commented on Querry on FLEX Links.

2 years 5 months ago
FLEX links are designed to avoid STP. If STP is enabled, there is no need for...

rais has commented on MPLS & Vlans - Basic question

2 years 6 months ago
Ethernet tags are stripped on a non-MPLS IP network. The same should hold true...

rais has commented on ISP connectivity and vlan routing

2 years 6 months ago
You need to NAT the LAN/10.10.10.0 traffic. I don't think your switch is...

rais has commented on Layer 2 VPn connectivity issue

2 years 6 months ago
Have you tried tagging the VLAN 200 across the ISP link? If that didn't work...

rais has commented on Switch port settings to a Dell teamed Nic?

2 years 6 months ago
NIC teaming is usually for connecting a host to multiple switches. In addition...

rais has commented on BGP failover testing

2 years 8 months ago
This issue should be resolved using routing. When ISP1 is down, the default...

rais has commented on OSPF routing assistance

2 years 8 months ago
You can increase the OSPF cost for this new link on both routers/sides and you...

rais has commented on OSPF routing assistance

2 years 8 months ago
Not sure why only new link should run OSPF. It should be enabled on all routers...

rais has commented on MPLS connections

2 years 8 months ago
That would depend upon your data requirements - VoIP, video, data flows all...

rais has commented on Redistrubtion issue toward new MPLS

2 years 8 months ago
When redistrubuting to BGP/RIP you could use route-maps and different metrics...

rais has commented on Connecting device to cisco 1900 series router no internet connection

2 years 8 months ago
For network 192.168.0.X, your NAT and DHCP should already be taken care of by...

rais has commented on Connecting device to cisco 1900 series router no internet connection

2 years 8 months ago
You haven't designated the Outside interface. Your F0/0/3 is a switchport, so...

Bio












rais's Stats

Points518
Discussion started 20
Answers marked as Correct 42
Endorsed 0
Content Rated 35