Rasika Nayanajith

Member Since: Feb 20, 2008

English
Rasika Nayanajith's Activity on Cisco Support Community
Currently displaying 50 results

Rasika Nayanajith has commented on Wireless bridge with layer 2 switches

5 hours 52 min ago
Check this post and it should give you how to configure your bridge to carry...

Rasika Nayanajith has commented on WLC 8500 crash after reboot

5 hours 56 min ago
You are hitting following bug. I think you require to upgrade your WLC code (8....

Rasika Nayanajith has commented on 802.11a/n/ac Operational Status down

23 hours 18 min ago
You can use below command to verify what country configured show wireless...

Rasika Nayanajith has commented on Autonomous Mode

1 day 4 hours ago
Yes, you can convert this AP to fully autonomous functionality. HTH Rasika...

Rasika Nayanajith has commented on downgrading from 8.2 to 8.1 on 5500 controller

1 day 6 hours ago
What is the issue you having with 8.2.x code ? It is the same process as...

Rasika Nayanajith has commented on 3800 AP not discovery the WLC, WLC running 8.3.102.0

1 day 6 hours ago
Not sure, it should be a bug . I notice below in 8.2.x  and may be...

Rasika Nayanajith has commented on 3800 AP not discovery the WLC, WLC running 8.3.102.0

1 day 7 hours ago
If you do "capwap ap primary-base <wlc_name> <wlc_mgt_ip> " on your...

Rasika Nayanajith has commented on Europe/France WIFI regulation information

1 day 7 hours ago
Refer this post, it has useful information and links to what you looking for...

Rasika Nayanajith has commented on 2600 access point and diversity

1 day 7 hours ago
Hi You can select which antenna to be used for Tx/Rx, in this way you can...

Rasika Nayanajith has commented on Link status shows N/A and AP does not broadcast SSID on cisco 3760 integrated controller

1 day 8 hours ago
wlan office 42 SEL-HPF-Office Since you have defined WLAN_ID 42 (which is...

Rasika Nayanajith has commented on cisco aironet 1240ag series access point issue

2 days 6 hours ago
Hi Here are basic config you can do via CLI. Hope your AP image support WPA2/...

Rasika Nayanajith has commented on Vendor Trying to Make Me Turn Off 40 MHz Globally

2 days 6 hours ago
I would think this is their end device issue that need to be addressed by that...

Rasika Nayanajith has commented on Migration from Cisco WLC 5508 to 5520

2 days 20 hours ago
as per requester they will be providing new management ip for this 5520 WLC....

Rasika Nayanajith has commented on 5760 "ap image reset" or equivalent OID

2 days 20 hours ago
Did you reach TAC on this matter ? They should fix given issues & make it...

Rasika Nayanajith has commented on Cisco Wireless Controller Audit

2 days 20 hours ago
Hi Manoj, I would use WLC Config Analyzer to assess the existing environment....

Rasika Nayanajith has commented on Converting universal APs to ready to use AP

2 days 20 hours ago
Thanks Rasika...So you're saying there is no option to change the firmware of...

Rasika Nayanajith has commented on Cisco CMX servise

3 days 3 hours ago
I have a doubt about heatmap. I need to include Cisco Prime to show the heatmap...

Rasika Nayanajith has commented on cisco air-ap1572eac-b-k9

3 days 7 hours ago
Also when hooking up to the current Poe switch what port on the Ap does the...

Rasika Nayanajith has commented on ISE upgrade

3 days 7 hours ago
Refer below for compatibility information http://www.cisco.com/c/en/us/td/docs...

Rasika Nayanajith has commented on Cisco 3850 Wirless Design Guide with Cisco WLC 5500/5508

3 days 7 hours ago
I would not suggest integrating these two systems (ie AireOS and IOS-XE). Since...

Rasika Nayanajith has commented on Converting universal APs to ready to use AP

3 days 7 hours ago
I do not think there is another way. Either replace the AP with another that...

Rasika Nayanajith has commented on Infrastructure Management Frame Protection(MFP) - WLC 8.0 code - per WLAN MFP configuration

4 days 7 hours ago
I do not think there is option to configure infrastructure MFP per WLAN. I can...

Rasika Nayanajith has commented on AP 1702i clients can not ping their getway hence other subnets not reachable from clients

5 days 6 hours ago
Hi, You need to add below configuration lines. Pls test this and let me know...

Rasika Nayanajith has commented on AP 1702i clients can not ping their getway hence other subnets not reachable from clients

6 days 7 hours ago
Pls attach your 3850 config to check Rasika

Rasika Nayanajith has commented on CPI WLC Unreachable

6 days 7 hours ago
Hi Adam, Glad to see you get it working & thanks for detailed update. If...

Rasika Nayanajith has commented on CMX isse analytics

1 week 1 day ago
If you need location analytics, CMX 10.2.2.x is the one you should be running....

Rasika Nayanajith has commented on Cisco WLC 2504

1 week 1 day ago
I am unable to access the service port address of 192.168.1.1. My PC is set to...

Rasika Nayanajith has commented on Client behind WGB not allowed to get DHCP address

1 week 1 day ago
Hi Dominic, By looking at my old notes (see below), "config wgb vlan enable"...

Rasika Nayanajith has commented on Access Point 1Gig port how accomodate 450Mb for 20+ users

1 week 1 day ago
How it achieves the 450Mb per user on 5Ghz 802.11ac  where 20+ users are...

Rasika Nayanajith has commented on AP won't join 2504 WLC

1 week 3 days ago
When I copied the config from the original AP to the new AP, it took them both...

Rasika Nayanajith has commented on Prime Infrastructure 3.0 Convergence?

1 week 3 days ago
We are planning to convert to a PI to 3.0 system. The current version is 2.2....

Rasika Nayanajith has commented on How can i solve the problem regarding cisco air-cap1602i-e-k9

1 week 3 days ago
What software version running on your AP ? Provide "show dot11 associations...

Rasika Nayanajith has commented on AP won't join 2504 WLC

1 week 3 days ago
Did you try to change the switchport & directly connect the AP to switch ?...

Rasika Nayanajith has commented on AP won't join 2504 WLC

1 week 3 days ago
When attempting to ping the WLC from the AP I get the output "% Unrecognized...

Rasika Nayanajith has commented on Aironet 1532 Standalone

1 week 3 days ago
Yes, it can work in Autonomous mode. you require correct autonomous image (eg...

Rasika Nayanajith has commented on DHCP configuration issues with Wireless

1 week 3 days ago
so how do we test for /23 or /22 where we do not have enough devices to reach...

Rasika Nayanajith has commented on AP won't join 2504 WLC

1 week 4 days ago
Looking at the controller, it does not receive a join request from the AP....

Rasika Nayanajith has commented on DHCP configuration issues with Wireless

1 week 4 days ago
Hi Peter, Under WLAN Advanced configuration, there is a tick box for allow...

Rasika Nayanajith has commented on Prime infra dosen't show me the APs

1 week 5 days ago
Post "show interface summary" output from your WLC and let us know what is CPI...

Rasika Nayanajith has commented on how to disable the broadcast Layer 3 LWAPP discovery for LAP

2 weeks 4 hours ago
Place AP on different AP management vlan. Even if it got static IP, you should...

Rasika Nayanajith has commented on assign SSID's to Bridge mode AP's

2 weeks 1 day ago
Typically AP management should be on native vlan. So it make sense bridge...

Rasika Nayanajith has commented on Catalyst 3650 - No administration Links in Wirelesss Web Gui

2 weeks 1 day ago
Ok, thanks for that information. I had simple alphanumeric letters in my...

Rasika Nayanajith has commented on how to disable the broadcast Layer 3 LWAPP discovery for LAP

2 weeks 1 day ago
Can't disable it. What is the problem you are going to solve by doing this...

Rasika Nayanajith has commented on Cisco 1602i accidentally downgraded to Lightweight - how to revert to Autonomous?

2 weeks 1 day ago
I should say, I have searched and read the posts on this forum about correcting...

Rasika Nayanajith has commented on Are any tools needed to configure an Aironet 1242AG?

2 weeks 1 day ago
If you laptop/pc does not have a serial port, but got USB port, use some of the...

Rasika Nayanajith has commented on Configuring an Aironet access point

2 weeks 1 day ago
Hi, You need to type "config t" prior to apply any configuration....

Rasika Nayanajith has commented on Catalyst 3650 - No administration Links in Wirelesss Web Gui

2 weeks 1 day ago
Hi  In my 3850 network (running 3.6.5E) it works fine with URL ...

Rasika Nayanajith has commented on Catalyst 3650 - No administration Links in Wirelesss Web Gui

2 weeks 2 days ago
Hi Sathis, Makesure below commands is there in your config AS01#sho run all...

Rasika Nayanajith has commented on Are any tools needed to configure an Aironet 1242AG?

2 weeks 3 days ago
You need to get into AP CLI to troubleshoot/verify your configuration. You can...

Rasika Nayanajith has commented on Adjusting the regulatory domain of wlc and APs

2 weeks 4 days ago
We are deploying in Nepal. As  there is no option of Nepal there so what...

Bio

I have being working with Cisco product since 2003 when I started my career as Engineer- Corporate Technical solutions for MPLS service provider in Sri Lanka.

After 4 years, moved to a solution Integrating company in Dubai & did my CCIE in R&S in 2008 (#22989) .In 2009 moved to Australia & currently working for La Trobe University in Melbourne as Team Leader Networks. Did CCIE Wireless in 2013.

My favorite topics are QoS, Multicast in Cisco wired & wireless environment.

Since 2015, I am practicing Vipassana meditation and trying to live in the present moment.

If you need to learn more about what I am doing, please follow me on my blog http://mrncciew.com








  • Cisco Designated VIP

    2016 Wireless





  • Cisco Designated VIP

    2015 Wireless





  • Cisco Designated VIP

    2014 Wireless





  • Community Spotlight Award

    Members Choice November 2013





  • Community Spotlight Award

    Questions Answered September 2013









Rasika Nayanajith's Stats

Points7184
Discussion started 21
Answers marked as Correct 762
Endorsed 10
Content Rated 156
Website: