robwils

Member Since: Jul 16, 2011

English
robwils commented on Catalyst 2960-S stacking question in LAN, Switching and Routing 4 years ago

Try the command: switch x renumber y Where x is the current switch number and y is the number you...

robwils commented on VS-S720-10G in LAN, Switching and Routing 4 years ago

According to this page, the sup does support the X2-10GB-CX4: http://www.cisco.com/en/US/docs/...

robwils commented on [Cisco 7606] redundancy upgrade issue in LAN, Switching and Routing 4 years ago

It looks to me like it has not loaded any IOS. Connect to the console port of the 2nd Supervisor in...

robwils commented on 6509-e supervisor swap in Getting Started with LANs 4 years ago

Yes, the config will still be there as long as you save the running configuration with the write...

robwils commented on 6509-e supervisor swap in Getting Started with LANs 4 years ago

I'd say your best bet is to use TFTP to transfer your config and vlan.dat to a server and then...

robwils commented on connecting nexus 5000 in LAN, Switching and Routing 5 years ago

Check out this link:http://www.cisco.com/en/US/docs/switches/datacenter/nexus5000/sw/configuration/...

robwils commented on C4506, C6509 and C6509E with VSS in LAN, Switching and Routing 5 years ago

If I am reading it correctly you cannot see a 6509, if this 6500 is conencted to another 6500 with...

robwils commented on Cisco router 3620 boot issues in LAN, Switching and Routing 5 years ago

Try power cycling the device. If no luck get a recent stable IOS and upload it. This can be done...

Bio












robwils's Stats

Points5
Discussion started 0
Answers marked as Correct 1
Endorsed 0
Content Rated 1