rupert.wever

Member Since: Nov 20, 2003

English
rupert.wever commented on flexconnect in Wireless IP Voice and Video 2 years ago

So I wonder if it is possible to use Flexconnect local authentication and be able to support 1-sec...

rupert.wever commented on MFP Anomaly Detected in Other Wireless - Mobility Subjects 2 years ago

Running 7.6.110.0 w/ AP3700sDisabled MFP: Still seeing the errorsDisabled WMM: Mac wireless clients...

rupert.wever commented on Migrate WCS 7.0.172 to Prime 1.3 in Network Management 3 years ago

As it turns out, all I had to do is rename the file to tar.gz -- browser was apparently dropping...

rupert.wever commented on Migrate WCS 7.0.172 to Prime 1.3 in Network Management 3 years ago

Has anyone seen an error message when trying to import WCS 7.0.230 maps into Prime Infrastructure 1...

rupert.wever commented on Problem within Autonomous AP Migration process in Other Wireless - Mobility Subjects 3 years ago

The process fails because it cannot write the ENV variables to your tftp server. Are you using the...

rupert.wever commented on NAC Guest Server and Multiple Guest SSID's/Splashpages in Security and Network Management 4 years ago

Is there a document that explains how RADIUS attribute format should look like? I am trying to...

rupert.wever commented on H-REAP with Web Auth Radius in Security and Network Management 4 years ago

Perhaps I am asking an obvious question, but just in case, when selecting web-auth, are you also...

rupert.wever commented on Cisco 7925 phone not joining the network in Wireless IP Voice and Video 5 years ago

To answer your question directly, use the command:"debug client "Sent from Cisco Technical Support...

rupert.wever commented on Do I need separate Access Points? in Wireless IP Voice and Video 5 years ago

You do not need separate ap's for each application. Best-practice recommendation is to have...

rupert.wever commented on Cisco 7925G - Changings in power consumption in Firmware 1.3.4 in Wireless IP Voice and Video 6 years ago

Agreed -- expecting users to reboot the phone everytime is no different than asking them to usea...

rupert.wever commented on Urgent--Load Profile failed -WLC 4402 in Getting Started with Wireless 7 years ago

On WLC CLI, assuming b-radio:> config advanced 802.11b profile clients global 25Please use this...

rupert.wever commented on Relevance of Mgmt i/f DHCP server on WLC in Security and Network Management 8 years ago

Precisely my point:You said: "controller will attempt to revert to the mgt interface for dhcp to...

rupert.wever commented on Relevance of Mgmt i/f DHCP server on WLC in Security and Network Management 8 years ago

How will the newly discovered know the dhcp address from mgt interface if the AP is not discovered...

rupert.wever commented on LWAPP AP finds controller without benefit of option 43 in Security and Network Management 9 years ago

LWAPP AP's discover controller thru other methods as well. DHCP Option 43 is only one of those...

rupert.wever commented on 7921 constantly dropping off the network in Wireless IP Voice and Video 9 years ago

Highly recommend you upgrade away from 4.0.206. Go with at least 4.0.217.0

rupert.wever commented on Dynamic Interfaces w/Multiple WLC's & SSID's/VLAN's in Other Wireless - Mobility Subjects 9 years ago

Your dynamic interfaces look good.All controllers should have the same virtual IP addresses,...

rupert.wever commented on counting the number of AP's in Getting Started with Wireless 9 years ago

WCS 4.1 gives you a good AP count.Reports > Inventory Reports > Access PointsOne of my...

rupert.wever commented on 4400, Problems with Trunk Connection in Other Wireless - Mobility Subjects 9 years ago

And are the management / ap-management interface are configured as vlan0 on the controller -or- is...

rupert.wever commented on Does changing RRM DCA reload radios? in Security and Network Management 9 years ago

Expect the controller's 802.11bg network to be disabled, changes made, and 802.11bg network re-...

rupert.wever commented on Does changing RRM DCA reload radios? in Security and Network Management 9 years ago

- Changing the power levels via WLC's GUI does not cause AP reload nor noticeable interruption....

rupert.wever commented on problem in network coused by controllers in Other Wireless - Mobility Subjects 9 years ago

Please review the following link:http://www.cisco.com/en/US/tech/tk722/tk809/...

rupert.wever commented on problem in network coused by controllers in Other Wireless - Mobility Subjects 9 years ago

Ahmed,I'd check a couple of places:#1 - Do you have LAG/Etherchannel enabled on both sides of the...

rupert.wever commented on Guest Network Splash Page in Security and Network Management 9 years ago

Assuming you are talking about the WLAN Controller + WCS.Check out these links:http://www.cisco.com...

rupert.wever commented on a controller is not assigning IP addresses in Getting Started with Wireless 9 years ago

That's the easiest way to test your setup, provided you do not leave it opened. If it works you do...

rupert.wever commented on a controller is not assigning IP addresses in Getting Started with Wireless 9 years ago

That is certainly a possibility. Can you tested without encryption (open)?

rupert.wever commented on a controller is not assigning IP addresses in Getting Started with Wireless 9 years ago

I see this as a common symptom, and one of the typical issues is the WLAN configuration:#1 - Are...

rupert.wever commented on DHCP Client will not work on a WLAN 4402 in Other Wireless - Mobility Subjects 9 years ago

Sounds like your WLAN is still mapped to the management interface. #1 - Make sure you have an...

rupert.wever commented on LWAPP over GRE in Other Wireless - Mobility Subjects 9 years ago

Not sure if you've already done this, but has the AP being 'primed'? How is the AP determining...

rupert.wever commented on cisco Could not process the RSN and WARP IE's. station not using RSN in Security and Network Management 9 years ago

Sounds like the infrastructure is configured for WPA1 and the client for WPA2.

rupert.wever commented on Spectralink phone problem in Wireless IP Voice and Video 9 years ago

I highly recommend following the spectralink Configuration and Deployment guide - tested and VIEW...

rupert.wever commented on MESH 1500 PAP not registering with RAP in Other Wireless - Mobility Subjects 9 years ago

- For the record, the AP1500's do NOT support 802.3af POE. Cisco supplies a power injector you can...

rupert.wever commented on wlan controller distribution port link down in Getting Started with Wireless 9 years ago

If you are referring to connecting the 1000BaseT to your FastEthernet port, it is not possible:...

rupert.wever commented on WISM and RF Group in Other Wireless - Mobility Subjects 10 years ago

I may be wrong on this, but I believe the RF groups are actually determined based on what the...

rupert.wever commented on ASK THE EXPERT - DEPLOYING A GLOBAL ENTERPRISE WLAN in Expert Corner 10 years ago

Oison,We ran into the following bug when attempting to override AAA with SSID (i.e. WLAN-ID).http...

rupert.wever commented on Upgrading 2000 controller issue in Security and Network Management 10 years ago

I got that error too. It turns out the tftp server I used was not reliable (what happens when you...

rupert.wever commented on WEP-WPA at the same time in WLAN Controllers in Security and Network Management 10 years ago

Hola Moises.I don't think that's possible. Why not have 2 distinct SSIDs? That way you'll have a...

rupert.wever commented on WLC controller Ethernet Multicast Mode in Getting Started with Wireless 10 years ago

When you are supporting Wireless Applications that require MC, such as Spectralink's (ca use MC for...

rupert.wever commented on 7920 Phone Drop in Wireless IP Voice and Video 10 years ago

Christian -- Assuming your RF environment was properly surveyed (i.e. proper overlap & coverage...

rupert.wever commented on Authentication option for Wlan controller in Security and Network Management 10 years ago

Sorry Bruno, Management RADIUS or TACACS Authentication are not currently supported on the WLAN...

rupert.wever commented on LWAPP AP unable to Join controller in Security and Network Management 10 years ago

It's interesting that only one AP couldn't join.The error message basically tells you that the AP...

rupert.wever commented on Authentication in Getting Started with Wireless 10 years ago

http://www.cisco.com/en/US/products/ps6366/index.html

rupert.wever commented on Authentication in Getting Started with Wireless 10 years ago

WLC4400-series (from Airespace acquisition) are a great cerntralized-architecture solution. One...

rupert.wever commented on Bridging with AP1030 and Controller in Getting Started with Wireless 10 years ago

This would essentially be a 'mesh' network setup.Both APs should be in bridge mode.There may be an...

rupert.wever commented on local (hybrid) REAP in Other Wireless - Mobility Subjects 10 years ago

Rayan,Not sure how big your campus network is, but I would object to having the same VLAN across...

rupert.wever commented on Wireless Employee Denial to Guest SSID in AAA, Identity and NAC 10 years ago

Thanks Darran, but I am using only MAC-auth for guest (just so I could use ACS to deny the invalid...

rupert.wever commented on Wich EAP with OTP in Security and Network Management 10 years ago

AFAIK:PEAP-GTCEAP-TLS

rupert.wever commented on WLC 4400 & AP's in Security and Network Management 10 years ago

If one WLC 'dies' the joined AP's will (A) switch to a secondary WLC (if previously configured) or...

rupert.wever commented on Certificate errors on autonomous to lightweight conversion in Other Wireless - Mobility Subjects 10 years ago

You can (did you try) ensuring that the date/time in the controller is current (use NTP whenever...

rupert.wever commented on ACS 3.3 User Authentication Question in AAA, Identity and NAC 10 years ago

You may need ACS 4.0 for this...

rupert.wever commented on ACS 3.3 User Authentication Question in AAA, Identity and NAC 10 years ago

Hi Daniel (long time no talk),Use Network Access Profiles where you can use filtering to specify...

Bio












rupert.wever's Stats

Points33
Discussion started 2
Answers marked as Correct 2
Endorsed 0
Content Rated 0