shivlu jain

Member Since: Jan 18, 2007

English
shivlu jain commented on MPLS training question in MPLS 6 years ago

labels are generated for two things:-1. one for igp routes2. second for vpnv4 routesto reach end to...

shivlu jain commented on OSPF in VRF with same area ID in MPLS 6 years ago

Yes you are right you can use; for every customer you can use the same area; this is the main...

shivlu jain commented on what is loopguard , BPDUguard , Rootguard ? in WAN, Routing and Switching 6 years ago

Loopguard:- Unidirectional link failures may cause a root port or alternate port to become...

shivlu jain commented on Alternate to VPLS in MPLS 6 years ago

Also for VPLS your cisco router must have sup 720, if you are having a routers like 7200 the best...

shivlu jain commented on Alternate to VPLS in MPLS 6 years ago

Hi MaheshAs per your suggestion, when customer will add a different vlan in that case a new ip...

shivlu jain commented on Trouble with BGP Failover in WAN, Routing and Switching 6 years ago

HiI did not see the prefix list WHOLESALE-NETWORKS and access list 40,42,45,46,48 and 49. Can you...

shivlu jain commented on Replacing a Cisco 7206VXR (NPE-G1) with a Cisco 3750 in WAN, Routing and Switching 6 years ago

IP input is very high on this router. Could you tell are you using this router for NAT or any SNMP...

shivlu jain commented on RIP advertisements coming only from Secondary HSRP in WAN, Routing and Switching 6 years ago

Hi ShivaniCan you provide the show ip routes of R1, R2 and R3.      regardsShivlu Jainhttp://www....

shivlu jain commented on MPLS VPN OSPF CE-PE Protocol Without Area 0 in MPLS 6 years ago

hi chetansometimes customer demand to run the area 0 at their end, in that case you need to go with...

shivlu jain commented on BGP multihomed 2 ISPs, One won't run BGP in WAN, Routing and Switching 6 years ago

In this case, one issue could come across about the different outgoing and incoming interfaces. If...

shivlu jain commented on Stripping weight 32768 from BGP redistribution. Danger? in WAN, Routing and Switching 6 years ago

I also got the same issue but in that case I increased the weight of the route by using route map....

shivlu jain commented on Need to add VLAN in WAN, Routing and Switching 6 years ago

I donot about your core clous, the best way is to use L2TPv3. Please see the given http://www....

shivlu jain commented on MPLS Architecture Help in MPLS 6 years ago

In Addition to Giuslar, If you have network expansion plan, try to go with route reflectors....

shivlu jain commented on OSPF in MPLS VRF with no Area 0 in MPLS 6 years ago

chk this:-Workarounda)Ask your customer to extend the area 0 till you PE.b)Create a sham link...

shivlu jain commented on MPLS Query in MPLS 6 years ago

you need to use MPLS enabled ios. S26SPSK9Cisco 2600 IOS SP SERVICES c2600-spservicesk9-mz. It...

shivlu jain commented on Underruns and Overruns Issue in CESoPSN PWE3 in MPLS 6 years ago

Appreciate for the document. Now my question is how to calculate the jitter buffer value for...

shivlu jain commented on class value in label in MPLS 6 years ago

In MPLS we are having only 3 bit which means not more than 8 combinations of offering class of...

shivlu jain commented on MPLS Due Diligence in MPLS 6 years ago

HiWithout RR, you need full mesh architecture among BGP peers which is not very cumbersome.Are you...

shivlu jain commented on BGP metric for Backup MPLS circuit in WAN, Routing and Switching 6 years ago

RTR could be one sided. But I dont know about BFD. I think it should be bi directional....

shivlu jain commented on cisco 3640 with 2 ISP & route-map load balancing in WAN, Routing and Switching 6 years ago

HiIn the given aclaccess-list 10 permit 192.168.30.0 0.0.0.255 the ip .151 is also permitted. Could...

shivlu jain commented on Cisco 7206VXR (NPE-G2) CPU Utilization in WAN, Routing and Switching 6 years ago

If you are using acl more than 50 lines then better to use complied acls. Are your BGP and IGP...

shivlu jain commented on Corrupted LFIB entry in MPLS 6 years ago

HiAfter refreshing the BGP entry label could be generated again. Or  I have one work around for you...

shivlu jain commented on Cisco validated design - MPLS network in MPLS 6 years ago

HiIt is nothing but the best common practises .regardsShivlu Jainhttp;//www.mplsvpn.info

shivlu jain commented on MPLS Due Diligence in MPLS 6 years ago

Hi Stephens:-Please see the depicted points:-1. Are you going to deploy RR, if yes plan for RR...

shivlu jain commented on GRE With VRF in MPLS 6 years ago

could you tell why you are using vrf interface on CE router. regardsShivlu Jainhttp://www.mplsvpn....

shivlu jain commented on Having trouble with ftp sites in WAN, Routing and Switching 6 years ago

Just check the TCP window size.regardsShivlu Jainhttp://www.mplsvpn.info

shivlu jain commented on VPN Site to Site in VPN 6 years ago

It could be done by using GRE tunnels. For security you can use ipsec tunnels also.regardsShivlu...

shivlu jain commented on PAT with puplic ip over ADSL in WAN, Routing and Switching 6 years ago

Just change the given and then post the results:-ip nat inside source list 1 interface dialer 0...

shivlu jain commented on VLAN problem with SONET/SDH Equipment in LAN, Switching and Routing 6 years ago

I think they have mapped only a single vlan in VCG, this could be the reason for not forwarding all...

shivlu jain commented on 2 basic questions on multicasting in LAN, Switching and Routing 6 years ago

The auto-rp listener is used to overcome the need to configured a sparse-dense-mode, when you...

shivlu jain commented on 2 basic questions on multicasting in LAN, Switching and Routing 6 years ago

You can use MSDP for RP redundancy.http://www.cisco.com/en/US/docs/ios/12_2/ip/configuration/guide/...

shivlu jain commented on Are vlans necessary? in LAN, Switching and Routing 6 years ago

HiThe segregation of vlan is only to reduce the broadcast domain. Every vlan means you are using...

shivlu jain commented on BGP metric for Backup MPLS circuit in WAN, Routing and Switching 6 years ago

Yes are very much right, it will take 3 minutes because of BGP dead timer. The best way is to use...

shivlu jain commented on MPLS TE - Explicit Path Configuration in MPLS 6 years ago

I think no, we can select only one option.regardsShivlu Jainhttp://www.mplsvpn.info

shivlu jain commented on MPLS TE - Explicit Path Configuration in MPLS 6 years ago

HiIn RSVP-TE, if you want to use the next hop address of the adjacent router then you need to use...

shivlu jain commented on Multicast VPN General Design Questions in MPLS 6 years ago

Please check the given link and download the document. That will clear you lot of things.http://www...

shivlu jain commented on Switch Access tow Data Vlan at same time in LAN, Switching and Routing 6 years ago

HiOn single port could only be part of access vlan. If you want to pass multiple data vlans on that...

shivlu jain commented on Redundancy between two ISP using HSRP - Need Help. in WAN, Routing and Switching 6 years ago

In HSRP and VRRP, if you want to do the load balancing then you need to create two virtual groups....

shivlu jain commented on Simple question on EIGRP in WAN, Routing and Switching 6 years ago

Hi You are having below configsinterface GigabitEthernet0/8no switchportip address 10.255.10.53 255...

shivlu jain commented on neighbor next-hop-unchanged in MPLS 6 years ago

HiGiuslar has given a good hint which is l2tpv3. I can tell you how to achieve the solution. What...

shivlu jain commented on Redistribution issues between OSPF and RIP in WAN, Routing and Switching 6 years ago

I tested it but they are easily shifted.regardsShivlu Jainhttp://www.mplsvpn.info

shivlu jain commented on Router Reboot 7206 VXR in WAN, Routing and Switching 6 years ago

see this bug CSCsg39977 regardsShivlu Jain

shivlu jain commented on Router Reboot 7206 VXR in WAN, Routing and Switching 6 years ago

This is the software bug. According to me this is the deferred IOS. You need to change IOS....

shivlu jain commented on Redistribution issues between OSPF and RIP in WAN, Routing and Switching 6 years ago

I have tested it and it is working fine. Can you check whether you have changed the OSPF reference...

shivlu jain commented on Redistribution issues between OSPF and RIP in WAN, Routing and Switching 6 years ago

One problem also I could see with the configs of R2 and R3, where in you are using passive...

shivlu jain commented on Multicast VPN General Design Questions in MPLS 6 years ago

In this case you need to define a RP under vrf and that RP should belong to your vrf domain....

shivlu jain commented on Corrupted LFIB entry in MPLS 6 years ago

HiI have seen this problem but not able to document it, In this case you need to refresh the MP-...

shivlu jain commented on Corrupted LFIB entry in MPLS 6 years ago

I have already faced this issue many times. The best is to soft refresh the labels. I have posted...

shivlu jain commented on Basic Concept of Xconnect in the case of AToM in MPLS 6 years ago

Hi InderYou could also get good information from given linkhttp://www.mplsvpn.info/search/label/...

shivlu jain commented on Redistribution issues between OSPF and RIP in WAN, Routing and Switching 6 years ago

HiI need to test the scenario. But what I can visualize is that the problem is occuring because of...

Bio












shivlu jain's Stats

Points301
Discussion started 115
Answers marked as Correct 19
Endorsed 0
Content Rated 22
Website: