Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
1926159members
1237641discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

SSID not discoverable by laptop in Packet Tracer

We have configured two Lightweight Access Points using a 3504 WLC. Both access points are connected to the WLC, and have been assigned IP addresses through DHCP from the WLC. Both also state they are providing the WLAN we created. Authentication for ...

cmonte0247 by • Community Member
  • 83 Views
  • 2 replies
  • 0 Helpful votes

4506 dhcp issue

we had a daily-basis ip conflict with dhcp server on cisco switch 4506E specially after replacing some the users' ports or a user using the laptop and moves alot, the ip conflict is detected using GARP method.note: the user could try multible free IP...

IPSec VPN Tunnel Lan-to-Lan decrypt count zero

Hi, I have one issue with IPSec tunnel Lan-to-Lan between ASA 5525x (v9.8) and ASA FPR 2110 (v9.16). My Tunnel is up but ping between each client was not successful. Both peer status sh cry isakmp sa in "MM_ACTIVE".I ran packet-tracer icmp between pe...

El Rondo by • Level 1
  • 100 Views
  • 3 replies
  • 0 Helpful votes

Migrate subnet into SD Access

HiI am testing migrating a subnet into SD Access.  I have a subnet routed outside my fabric and I have a device inside my fabric on that subnet routed by the external gateway by handing off the address pool on a L2 VN.  This all works fine.I now want...

KevinR99 by • Level 1
  • 150 Views
  • 9 replies
  • 0 Helpful votes

MTLS does not take effect

My expressway version is X12.6.1,Mutual TLS mode is on, both the CA certificate and the server certificate have been imported, then configured an dns zone with TLS verify mode is on ,also have TLS verify subject name, When I initiated the call, I fou...

SDA L2VNIDs

Hi All,Quick question hopefully. I noticed that when DNA Center provisions a L2 network within a fabric site, its allocates a L2VNID starting 8188 for local segments and 16196 for multisite remote border/anchor VN segments.If I remove and re-add an p...

dm2020 by • Level 1
  • 22 Views
  • 0 replies
  • 0 Helpful votes

Redundancy Over VSAT Link

Hi, we have a WAN and VSAT connection to one of the site. WAN is primary and VSAT is secondary link.We have dedicated router for WAN and VSAT. VSAT link is connected to one of the LAN access switch.Could you please help me, what kind of configuration...

inhamit_0-1713245875089.png
inhamit by • Level 1
  • 87 Views
  • 2 replies
  • 0 Helpful votes
Load more
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: