Stephen Rodriguez

Member Since: May 22, 2006

English
Stephen Rodriguez commented on CCW API for List Price? in Operations Exchange 6 months ago

I've been looking for API documentation as well, so that I can automate building of estimates, and...

Stephen Rodriguez commented on Flex controller upgrade with redundant site in Security and Network Management 10 months ago

Honestly I'd load the code to both WLC, and then push the new image to the "primary Flex AP" at...

Stephen Rodriguez commented on 5760 Web auth and Dynamic Channel Assignment clients required to re-authenticate in Security and Network Management 10 months ago

DCA should have nothing to do with it. Even if the AP changes channels the clients state in the...

Stephen Rodriguez commented on 5508WLC Guest certificate in Security and Network Management 10 months ago

Yes, the certificate needs to be issued from a public/well known CA. Otherwise the client device...

Stephen Rodriguez commented on WLC one WLAN, multiple subnets in Other Wireless - Mobility Subjects 10 months ago

So the WLAN is enabled for FlexConnect local switching, and you went into the AP and mapped the...

Stephen Rodriguez commented on WLC one WLAN, multiple subnets in Other Wireless - Mobility Subjects 10 months ago

I would go with FlexConnect for the remote sites. http://www.cisco.com/c/en/us/td/docs/wireless/...

Stephen Rodriguez commented on Assing static IP address to AIR-LAP1522AG-A-K9 in Getting Started with Wireless 10 months ago

sorry, debug capwap ap ip address and debug capwap ap controller ip address Steve

Stephen Rodriguez commented on Guest Network redesign - Anchor WLC removal in Other Wireless - Mobility Subjects 10 months ago

if you want to use the SonicWall as the DHCP server, you need to disable DHCP proxy on the WLC....

Stephen Rodriguez commented on Assing static IP address to AIR-LAP1522AG-A-K9 in Getting Started with Wireless 10 months ago

ok, you can try this: debug capwap console cli debug capwap client no-reload capwap ap ip address...

Stephen Rodriguez commented on Assing static IP address to AIR-LAP1522AG-A-K9 in Getting Started with Wireless 10 months ago

that AP is running a capwap image, so you can't configure the AP directly. You need to have the AP...

Stephen Rodriguez commented on Generate CSR for Third-Party Certificates and Download Chained Certificates to the WLC (SHA2) in Security and Network Management 10 months ago

Looks like SHA-256 is supported already. Generate CSR and it looks like you need to specificy -...

Stephen Rodriguez commented on OEAP600 and WLC 8.0.120.0 Compatibility in Getting Started with Wireless 10 months ago

Per the 8.0.120.0 Release Notes the OEAP600 is still supported what do you get from: debug mac-...

Stephen Rodriguez commented on AP LW 1600 not joining to Controller in Catalyst 3850 in Other Wireless - Mobility Subjects 10 months ago

Looking at the Cisco Error meessage decoder, that could be realted to the LSC authorization you...

Stephen Rodriguez commented on 3502i not joining 5508 running 7.6.130.0 in Other Wireless - Mobility Subjects 10 months ago

what do you get from the following debugs run concurrently on the WLC debug mac address F4:CF:E2:...

Stephen Rodriguez commented on Latency issues b/w LWAP and WLC in Other Wireless - Mobility Subjects 10 months ago

Honestly,    I'd leave the controllers in the DC, and just use FlexConnect for the branches....

Stephen Rodriguez commented on WiFi Clients Unstables in Other Wireless - Mobility Subjects 10 months ago

my recommendation would be to grab the latest drivers, and build an MSI package that you can push...

Stephen Rodriguez commented on WiFi Clients Unstables in Other Wireless - Mobility Subjects 10 months ago

But what is the wireless NIC. Is there a common chipset? Intel, Broadcom etc HTH, Steve

Stephen Rodriguez commented on WiFi Clients Unstables in Other Wireless - Mobility Subjects 10 months ago

what NIC and driver version are the clients using? Keep in mind that windows update does not...

Stephen Rodriguez commented on Cisco Rogue Detector on AP's and automatic alerting function? in Security and Network Management 10 months ago

Are you utilizing Cisco PI or some other SNMP/network management tool? HTH,Steve

Stephen Rodriguez commented on CMX Facebook Social Auth in Other Wireless - Mobility Subjects 10 months ago

This command removes the client from the WLC MSCB. Even if something else is doing the...

Stephen Rodriguez commented on AP 2702 draws low Power from Ethernet in Other Wireless - Mobility Subjects 10 months ago

You could try to go into the AP config on the WLC and check the box for pre-standard power. Or you...

Stephen Rodriguez commented on CMX Facebook Social Auth in Other Wireless - Mobility Subjects 10 months ago

you should be able to use the command config client deauthenticate < client mac address >...

Stephen Rodriguez commented on Upgrading WLC - Bypass FUS in Getting Started with Wireless 10 months ago

Yes you can go straight to the 1.9 FUS image. http://www.cisco.com/c/en/us/td/docs/wireless/...

Stephen Rodriguez commented on Antenna AIR ANT2460NP-R44 and AP AIR-L'AP1252G-À-k559 in Getting Started with Wireless 10 months ago

Yes that antenna is compatible with teh 1252 for the 2.4GHz side. But it is a patch antenna so the...

Stephen Rodriguez commented on EoIP mobility tunnel and FW rules in Other Wireless - Mobility Subjects 11 months ago

I agree with Rasika. Allow either side to send the traffic. but IIRC, the lowest MAC address, per...

Stephen Rodriguez commented on Network Discovery win7 WITH Wireless LAN Controller and access point not Showing in Other Wireless - Mobility Subjects 11 months ago

on your controller, do you have broadcast forwarding enabled? Controller > General HTH,Steve

Stephen Rodriguez commented on Can't access wireless client bridge in Getting Started with Wireless 11 months ago

when you look at the WLC, do you see the M111 WGB as a client with an address? Steve

Stephen Rodriguez commented on Change VLAN Identifier on Management Interface on WLC 5508 in Getting Started with Wireless 1 year ago

so the exact command you want to look for is: vlan dot1q tag native HTH,Steve

Stephen Rodriguez commented on Change VLAN Identifier on Management Interface on WLC 5508 in Getting Started with Wireless 1 year ago

It should work with:interface GigabitEthernet0/31 description WLC switchport trunk encapsulation...

Stephen Rodriguez commented on QoS on wlc and Ap in Other Wireless - Mobility Subjects 1 year ago

Yes, the WLC supports 802.1p. QoS You'll want to look at the configuration guide for the version of...

Stephen Rodriguez commented on Wireless client authentication issue with ACS in Getting Started with Wireless 1 year ago

Can you share the configuration of the AP? Steve

Stephen Rodriguez commented on Adding new WLC in Security and Network Management 1 year ago

If you have PI, you can use that to push the config to the AP. Other than that you'll need to get...

Stephen Rodriguez commented on 2504 cannot ping the gateway and cannot be seen on network in Getting Started with Wireless 1 year ago

Well, one problem I see on G1/0/2  is that it is in VLAN 1 and your WLC is VLAN 10. So what you...

Stephen Rodriguez commented on ASA5506w connected to vWLC in Getting Started with Wireless 1 year ago

Per Table 3 you should be using the 702 image for the AP integrated into the ASA5506W. But that...

Stephen Rodriguez commented on Wifi signal problem in Getting Started with Wireless 1 year ago

signal strength will vary device to device. what kind of device is it?How many SS?Latest drivers?...

Stephen Rodriguez commented on 1572 AP in Other Wireless - Mobility Subjects 1 year ago

Yes, this is possible. Flexible Antenna Configuration You'll need to change the Flex Antenna mode...

Stephen Rodriguez commented on Cisco 1131 console connection not working in Getting Started with Wireless 1 year ago

when you console into an AP your console settings need to be: 9600/8/none/1 with flow control set...

Stephen Rodriguez commented on Cannot ping through wireless router? in Getting Started with Wireless 1 year ago

ok, so that really sounds more like a routing issue than a wireless issue.  So what does your...

Stephen Rodriguez commented on Autonomous Access Points (aironets) with overlapping SSID names in Getting Started with Wireless 1 year ago

That should work so long as you don't have AP on the same channel next to each other, and the SSID...

Stephen Rodriguez commented on AP Radio Module - Autonomous/Lightweight in Other Wireless - Mobility Subjects 1 year ago

If your AP are being managed by Prime, then you should be able to push that as a script. Other than...

Stephen Rodriguez commented on AP Radio Module - Autonomous/Lightweight in Other Wireless - Mobility Subjects 1 year ago

I believe that a show controllers dot11radio 1 will show you that HTH,Steve

Stephen Rodriguez commented on Clear text to ASCII in Security and Network Management 1 year ago

You don't, you just type it in as normal. The 'ascii' they are referencing isn't the ascii code "...

Stephen Rodriguez commented on Clear text to ASCII in Security and Network Management 1 year ago

why bother going through that trouble?Just put the PSK in as 'ascii 0'So long as service-password...

Stephen Rodriguez commented on Cisco WLC HA-SKU standalone controller in Other Wireless - Mobility Subjects 1 year ago

No, you need to have a WLC that has licensing to support the number of AP you have. HTH,Steve

Stephen Rodriguez commented on Aironet AAA Settings, login not working in Security and Network Management 1 year ago

what is your configuration under the VTY? login authentication tac_admin - or something similar? ...

Stephen Rodriguez commented on Aironet AAA Settings, login not working in Security and Network Management 1 year ago

you also need to change the exec statement: aaa authorization exec default group tac_admin http://...

Stephen Rodriguez commented on Diferent DHCP servers with the same ssid in Getting Started with Wireless 1 year ago

You will want to look into the AP Groups feature. http://www.cisco.com/c/en/us/support/docs/...

Stephen Rodriguez commented on Autonomous 2602i Wireless Speed more than 54mb? thanks in advance in Getting Started with Wireless 1 year ago

it doesn't look like you have the MCS rates enabled.This is from my AP: beamform rssi 65 beamform...

Stephen Rodriguez commented on Issue delete and add device to Prime 2.2 in Security and Network Management 1 year ago

There are two things you can do: 1) Open a TAC case. They can get one of the Devs online to look...

Stephen Rodriguez commented on 2504 with 3702I download speed half of upload speed in Other Wireless - Mobility Subjects 1 year ago

can you post the WLAN config? show wlan < wlan id > and what is the port config of the...

Bio

Over 15 years of telecom/datacom experience. I spent almost 5 years in Cisco TAC, with 3 of those years as a Lead for the Wireless Team. Extensive experience with all of the wireless solutions from IOS AP up to the CUWN Controllers. As well as experience working with ACS 3.3/4.x, and some 5.x, and IAS/NPS. Ability to help customers determine business needs and drivers and deliver a solution designed to meet the.requirements to keep the users successful.

Specialties: Networking both wired and wireless.








  • Cisco Designated VIP

    2014 Wireless





  • Cisco Designated VIP

    2013 Wireless





  • Cisco Designated VIP

    2012 Wireless









Stephen Rodriguez's Stats

Points6404
Discussion started 3
Answers marked as Correct 789
Endorsed 6
Content Rated 101
Website: