Member Since: Feb 02, 2009
- Gold, 750 points or more
>Firmware 4.2.1.02 continues to restrict 1-to-1 NAT to only addresses in the main RV042 LAN (...
>I realize I can setup multiple internal subnets but that also seems to introduce restrictions...
>1) is there a way to get around the (seemingly arbitrary) class C (slash 24+) subnet...
Do you have a case number?
Chris, ISA550 can support the configuration you described.
CSCtz41379 - RV082V3 Dual WAN Protocol Binding rule not working properly over G2G VPN
ISA550 or ISA570 should be able to meet your requirement.
RV042G currently does not support URL filtering by category.
Hi Steve,What you described is a known issue, which has been fixed by firmware 4.2.2.05 (beta). If...
Try clearing the browser's cache - see attached.
You could try configuring rate control rules (under System Management>Bandwidth Management) to "...
If the Diag LED is blinking slowly, it means the router's firmware needs to be re-flashed.
RVL200 can be replaced first to test the Split DNS feature on the remote site.
The Linksys RVL200 or RV042 does not support Split DNS over IPsec tunnel, which seems to be what...
What traffic can go into an IPsec tunnel depends on the definition of the local subnet and remote...
>Is it actually necessary to disable DHCP in order to make static routing work properly? No, it'...
You might want to remove all custom access rules first to troubleshoot the issue.
You could configure a protocol binding rule to bind http traffic from a single LAN IP address (or a...
The scenario you described should be feasible with a pair of RV042 and RV082, where all traffic is...
- Page 1
Gold750 points or more
Te-Kai Liu's Stats
|Answers marked as Correct||116|